Concept explainers
Consider a concentric tube heat exchanger with an area of
(a) Determine the outlet temperature of the hot fluid.
(b) Is the heat exchanger operating in counterflow or parallel flow, or can’t you tell from the available information?
(c) Calculate the overall heat transfer coefficient.
(d) Calculate the effectiveness of this exchanger.
(e) What would be the effectiveness of this exchanger if its length were made very large?***
Want to see the full answer?
Check out a sample textbook solutionChapter 11 Solutions
Fundamentals of Heat and Mass Transfer
Additional Engineering Textbook Solutions
DESIGN OF MACHINERY
Engineering Mechanics: Statics & Dynamics (14th Edition)
Statics and Mechanics of Materials
Thermodynamics: An Engineering Approach
Applied Fluid Mechanics (7th Edition)
Introduction To Finite Element Analysis And Design
- Water flowing in a long, aluminum lube is to be heated by air flowing perpendicular to the exterior of the tube. The ID of the tube is 1.85 cm, and its OD is 2.3 cm. The mass flow rate of the water through the tube is 0.65kg/s, and the temperature of the water in the lube averages 30C. The free-stream velocity and ambient temperature of the air are 10m/sand120C, respectively. Estimate the overall heat transfer coefficient for the heat exchanger using appropriate correlations from previous chapters. State all your assumptions.arrow_forward10.1 In a heat exchanger, as shown in the accompanying figure, air flows over brass tubes of 1.8-cm 1D and 2.1-cm OD containing steam. The convection heat transfer coefficients on the air and steam sides of the tubes are , respectively. Calculate the overall heal transfer coefficient for the heal exchanger (a) based on the inner tube area and (b) based on the outer tube area.arrow_forwardMot water is used to heat air in a double-pipe heat exchanger as shown in the following sketch. If the heat transfer coefficients on the water side and on the air side are 550W/m2Kand55W/m2K respectively, calculate the overall heat transfer coefficient based on the outer diameter. The heat exchanger pipe is 5-cm, schedule 40 steel (k=54W/mK) with water inside.arrow_forward
- Principles of Heat Transfer (Activate Learning wi...Mechanical EngineeringISBN:9781305387102Author:Kreith, Frank; Manglik, Raj M.Publisher:Cengage Learning