Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)
8th Edition
ISBN: 9781305387102
Author: Kreith, Frank; Manglik, Raj M.
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Videos
Textbook Question
Chapter 5, Problem 5.43P
A refrigeration truck is traveling at 130 km/h on a desert highway where the air temperature is
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
Q : Engine oil at 80°C flows over a 10-m-long flat plate whose
temperature is 30°C with a velocity of 2.5 m's. Determine the rate of heat
transfer over the entire plate per unit width. Take the properties of the oil
at film temperature
A heated plate, 20 by 20 cm, is inclined at an angle of 60°with the horizontal and placed in water. Approximately constant-heat-flux conditions prevail with a mean plate temperature of 40°C and the heated surface facing downward. The water temperature is 20°C. Calculate the heat lost by the plate.
What is the rate of heat loss through a
4-cm Fiberglass wall of the inside
temperature
is 22 °C and the outside
temperature is 45 °C and windy (17 kph)
? the area of the wall is 100 square
meters. Include surface films. Assume
the k-value for 4-cm fiberglass is 0.056
W/m. °C and the surface air film
coefficient for windy velocity (17 kph) is
0.053 for out film and the inner film Rs
value is 0.093 as per the surface film
coefficient tables ?
Chapter 5 Solutions
Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)
Ch. 5 - Evaluate the Reynolds number for flow over a tube...Ch. 5 - 5.2 Evaluate the Prandtl number from the following...Ch. 5 - Evaluate the Nusselt number for flow over a sphere...Ch. 5 - 5.4 Evaluate the Stanton number for flow over a...Ch. 5 - Evaluate the dimensionless groups hcD/k,UD/, and...Ch. 5 - 5.6 A fluid flows at 5 over a wide, flat plate 15...Ch. 5 - 5.7 The average Reynolds number for air passing in...Ch. 5 - Prob. 5.8PCh. 5 - When a sphere falls freely through a homogeneous...Ch. 5 - 5.10 Experiments have been performed on the...
Ch. 5 - 5.13 The torque due to the frictional resistance...Ch. 5 - The drag on an airplane wing in flight is known to...Ch. 5 - 5.19 Suppose that the graph below shows measured...Ch. 5 - Engine oil at 100C flows over and parallel to a...Ch. 5 - For flow over a slightly curved isothermal...Ch. 5 - Air at 20C flows at 1 m/s between two parallel...Ch. 5 - Air at 1000C flows at an inlet velocity of 2 m/s...Ch. 5 -
5.43 A refrigeration truck is traveling at 130...Ch. 5 - The air-conditioning system in a Chevrolet van for...Ch. 5 - Determine the rate of heat loss from the wall of a...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.Similar questions
- An electrical transmission line of 1.2-cm diameter carries a current of 200 amps and has a resistance of 310-4 ohm per meter of length. If the air around this line is at v, determine the surface temperature on a windy day, assuming a wind blows across the line at 33 km/h.arrow_forwardDetermine the rate of heat loss from the wall of a building resulting from a 16 km/h wind blowing parallel to its surface. The wall is 24 m long and 6 m high, its surface temperature is 27C, and the temperature of the ambient air is 4C.arrow_forwardCalculate the convective heat transfer rate via the top and the two side walls of a refrigerated box trailer as shown in the figure. The trailer is cruising at a rate of 70 mph (31.3 m/s). The box trailer dimensions are 16 m long, 4.1 m high, and 2.6 m wide. Assume that the surface of the trailer is at uniform temperature of 10°C. The air temperature is 30°C. Because of the presence of the prime-mover in the front, the air flow can be assumed to be turbulent when it encounters the trailer. 187.4 kW Walls. Prime-mover 16 m 2.6 marrow_forward
- Water at 43.3°C flows over a large square plate at a velocity of 28 cm/s. The plate is 1.2 m long (in the flow direction) and its surface is maintained at a uniform temperature of 10.0°C. The width of the plate is 1.2 m. Calculate the steady rate of heat transfer for the entire width of the plate in watts (W). The properties of water at the film temperature of (Ts + T∞)/2 = (10 + 43.3)/2 = 27°C are ρ = 996.6 kg/m3, k = 0.610 W/m·°C, μ = 0.854 × 10–3 kg/m·s, and Pr = 5.85. The steady rate of heat transfer per unit width of the plate is ___ W.arrow_forwardA cylindrical bottle with a diameter of 10 cm and a height of 30 cm contains cold water at 3 °C. The bottle is placed in windy air at 27°C. The temperature of the water is measured at 11 °C after 45 minutes of contact with the air. Neglecting radiation effects and heat transfer from the upper and lower surfaces, estimate the average wind speed. I need the solution from fundamental concepts of how the heat flow behaves in the systemarrow_forwardA can of engine oil with a length of 150 mm and a diameter of 100 mm is placed vertically in the trunk of a car. In a hot summer day, the temperature in the trunk is 43°C. If the surface temperature of the can is 17°C, determine heat transfer rate from the can surface. Neglect the heat transfer from the ends of the can.arrow_forward
- An average man has abody surface area of 1.8m2 and a skin temperature of 33degrees celcius .The convection heat transfer coefficient for a clothed person walking in still air is expressed as {h,8.6V^0.53}FOR 0.5<v<2m/s,where V is the walking velocityin m/s.Assuming the average surface temperature of the clothed person to be 30degrees celcius, determine the rate of heat loss from an average man walking in still air at 10degrees celcius by convectionat a walking velocity of (a)0.5m/s (b)1.0m/s (c)1.5m/s (d)2.0m/sarrow_forwardSolar radiation is incident on the glass cover of a solar collector at a rate of 700W/m². The glass of collector absorbs 88 percent of the incident radiation on it and has an emissivity of 0.9. The entire hot water needs of a family can be provided by a single collector of 1.2m height and 2m width. The temperature of the glass cover of the collector is measured to be 35C° on a day when the surrounding air temperature is 25C° and the wind is blowing at 30km/h. The effective sky temperature for radiation exchange between the glass cover and the open sky is -40C°. Water enters the tubes which attached to the absorber plate at a rate of 1kg/min. Assuming the back surface of the absorber plate to be heavily insulated and the only heat loss to occur through the glass cover, determine (a) the total rate of heat loss from the collector, (b) the collector efficiency, which is the ratio of the amount of heat transferred to the water to the solar energy incident on the collector, and (c) the…arrow_forwardQ9) Consider a 50 cm diameter and 95 cm long hot water tank. The tank is placed on the roof of a house. The water inside the tank is heated to 80°C by a flat-plate solar collector during the day. The tank is then exposed to windy air at 18°C with an average velocity of 40 km/h during the night. Estimate the temperature of the tank after a 45 mm period. Assume the tank surface to be at the same temperature as the water inside, and the heat transfer coefficient on the top and bottom surfaces to be the same as that on the side surface.arrow_forward
- Q2/Engine oil at 80°C flows over a 6-m-long flat plate whose temperature is 30°C with a velocity of 3 m/s. Determine the total drag force and the rate of heat transfer over the entire plate per unit width.arrow_forwardWater at 43.3°C flows over a large square plate at a velocity of 20 cm/s. The plate is 2 m long (in the flow direction) and its surface is maintained at a uniform temperature of 10.0°C. The width of the plate is 2 m. Calculate the steady rate of heat transfer for the entire width of the plate in watts (W). The properties of water at the film temperature of (Ts + T∞)/2 = (10 + 43.3)/2 = 27°C are p = 996.6 kg/m³, k= 0.610 W/m-°C, μ = 0.854 x 10-3 kg/m-s, and Pr = 5.85. The steady rate of heat transfer per unit width of the plate is W.arrow_forwardDuring a cold winter day, wind at 55 km/h is blowing parallel to a 4m high and 10m long wall of a house. If the air outside is at 5 degrees Celsius and the surface temperature of the wall is 12 degrees Celsius , determine the rate of heat loss from the wall by convection. What would your answer be if the wind velocity has doubled? From Table A-1:thermal conductivity, k = 0.0246 W/m degrees Celsiusviscosity, v = 1.4 x 10^-5 m^2/sPrandtl no. Pr = 0.717arrow_forward
arrow_back_ios
SEE MORE QUESTIONS
arrow_forward_ios
Recommended textbooks for you
Principles of Heat Transfer (Activate Learning wi...Mechanical EngineeringISBN:9781305387102Author:Kreith, Frank; Manglik, Raj M.Publisher:Cengage Learning
Principles of Heat Transfer (Activate Learning wi...
Mechanical Engineering
ISBN:9781305387102
Author:Kreith, Frank; Manglik, Raj M.
Publisher:Cengage Learning
Heat Transfer – Conduction, Convection and Radiation; Author: NG Science;https://www.youtube.com/watch?v=Me60Ti0E_rY;License: Standard youtube license