The bath length in atomic absorption spectrophotometer can usually be changed by.? a. Using higher temperature b. Using a different hollow cathode lamp O c. Turning a special handle attached to the flame holder d. Using a larger quartz cuvet O e. C and D

The bath length in atomic absorption spectrophotometer can usually be changed by.? a. Using higher temperature b. Using a different hollow cathode lamp O c. Turning a special handle attached to the flame holder d. Using a larger quartz cuvet O e. C and D

Principles of Modern Chemistry

8th Edition

ISBN:9781305079113

Author:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Publisher:David W. Oxtoby, H. Pat Gillis, Laurie J. Butler

Chapter1: The Atom In Modern Chemistry

Section: Chapter Questions

Problem 16P: In the problem 15 above, what is vy , the y-component of the electron’s velocity, when it has...

See similar textbooks

Related questions

Q: As the cell thickness increases, the intensity of the transmitted light also increases. Is this True…

A: Ans - This statement is false. Explain - As the cell thickness increases, the intensity…

Q: nswer these two questions about flame atomic absorption spectroscopy analytic (FAAS) Different…

A: Quantitative applications- Atomic absorption spectroscopy is very useful for the determination of a…

Q: Explain how beam chopping reduces line noise and noise from source drift.

A: To explain: How beam chopping reduces line noise and noise from source drift.

Q: plalh the difference between the split and splitless mode of operation in a GO jector. Consider…

Q: 1. State the reasons for reading the absorbance of unknown against reagent water blank or against…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: : Calculate the increase factor in the fraction of surface atoms when macro sphere 1 m in diameter…

Q: Is the Cu detectable at a concentration of 0.10 mg/L in Flame-AAS? Please use data given.

A: Flame AAS is atomic absorbation spectroscopy. Which is used to detect the various sample i. e.blood…

Q: If a plot between absorption and concentration was not linear and a plot between absorbance and bath…

A: Interpretation: To identify the reason for why the absorbance and concentration plot is not linear.

Q: What are flame tests used to identify?

A: When the electrons of atoms are ground state, the electrons will be present in the lowest possible…

Q: It is never necessary to take more than one composite sample per field. True Or False

A: Composite soil sampling is the traditional soil sampling method. To make a composite sample we mix…

Q: (a) Illustrate a respective diagram showing Interstitials impurity and Frenkel defect.

Q: A solution of KMnO4 with a concentration of 8.25 x 10-5 M yields an absorbance value of 0.1302 when…

A: Given, Absorbance, A = 0.1302 Concentration, c = 8.25 x 105 M Length of cuvette, l = 5.60 cm

Q: ewavelength of a

Q: Relative Standard Deviation of UV Vis, please explain.

A: A question based on RSD, which is to be accomplished.

Q: Discuss detail account on fol soft ionization techniques? a. Matrix Assisted Laser Desorption…

A: a. Matrix Assisted Laser Desorption Ionization (MALDI) Used mainly for large biomolecules (Peptides…

Q: (c). What is the dynamic range of the method? Hint: it is NOT the entire concentration range. (d). A…

A: Atomic absorption spectroscopy is a quantitative spectroscopic method to determine the concentration…

Q: 13. The presented scheme has flaws. What is/are the flaw/s? CH3 соон 1. Cl2, FeC, 2. KMNO.

A: Solution - First KMnO4 is used to oxidize the CH3 group into COOH which acts as a EWG. When Cl2 is…

Q: Calculate the Absorbance from concentration for each trial of 0,10, 30, 40, 50 % (with yellow LED)…

A: The Absorbance from concentration for each trial of 0,10, 30, 40, 50 % has to be calculated.

Q: According to Beer’s law, if b and ε are held constant, absorbance is directly proportional to _____.

A: The correct answer is given below

Q: An empty infrared cell showed 8.9 interference fringes in the wavelength range of 1894 to 2399 cm-1.…

A: The equation required to determine the path length of cell is as follows, b=∆N2ν1-ν2

Q: The bath length in atomic absorption spectrophotometer can usually be changed by.? a. Using higher…

A: The correct answer has to be given.

Q: At what potential should the cyclical sweep begin? O open circuit potential O anodic peak potential…

A: In cyclic voltammetry voltage used to change between two values i.e. cathodic peak potential and…

Q: Why does the fluorescence quenching happen? Please shortly answer at your own words. Answer should…

A: A molecule of a substance after absorbing UV/Vis light gets excited to upper energy level from the…

Q: In Spectrophotometric Determination of a Metal, how do you compute or get for the Corrected…

A: We know spectrophotometric method is the most widely used tool to study the formation of metal…

Q: (A) Draw a sketch of the expected chromatrogram (peaks, broadening, relative elution times, etc.)

A: Given: A) To sketch the expected chromatogram.

Q: The bath length in atomic absorption spectrophotometer can usually be changed by...? O a. Using…

A: Atomic absorption spectrophotometer detects elements in either liquid or solid samples through the…

Q: as we increase the wavenumber, the penetration A. increases B. does not affect gher the reflective…

Q: why is an electro thermal atomizer more sensitive than flame atomizer?

A: The oldest technique used in Atomic absorption spectroscopy is the Flame atomizer.

Q: Intensifying screens can be placed on both sides of the X-ray film (double-sided) or on one side…

A: Intensifying screens can be place in x-beam film in light of the fact that the two sides of x-bar…

Q: (a) Why is carbon used as an electrode in arc and spark sources? Explain briefly. (b) Compare…

A: Carbon used as an electrode in arc and spark sources: If we pass the high voltage of electric…

Q: Instrumental studies involve the calculation of the instruments' limit of detection (LOD) in…

Q: If a plot between absorption and concentration was not linear and a plot between absorbance and bath…

A: We know that absorbance is given by the formula, A = ∈ c l where A = absorbancec = concentrationl=…

Q: The diagram below represents the layout of a typical single-beam UV-Vis, explain the function of…

Q: atomic absorption.

A: Atomic absorption spectroscopy is a spectroanalytical technique used for the quantitative…

Q: Spectrophotomeric Data: (for standard Beer's Law graph) These are Calculated Values mL primary mL…

A: A table of spectroscopic data

Q: Two students A, B did the Flame photometric analysis by different atomization methods in which the…

A: Flame Atomic Absorption Spectroscopy (FAAS), commonly called flame spectroscopy is a branch of…

Q: About Atomic spectroscopy a) Explain the fundamental difference between the two main types of…

A: Hello. Since your question has multiple parts, we will solve first question for you. If you want…

Q: Consider the chromatogram that t3=20 sec, calculate for its number of theoretical plates: " 12 Ty…

A: Here we are required to find the number of theoretical plates

Q: Two parallel gray planes have emissivities of 0.8 and 0.7 and are maintained at 800°C and 1500°C.…

Q: a) You measure the percent transmittance of a solution containing chromophore X at 400nm in a 1-cm…

A: From data T%= 50%, so, T= 0.5 l = 1 cm c = 0.5mM= 0.0005M A1 = 0.2 A2 = 0.8 Furthermore, molar…

Q: Does the amount of radiation (cpm) increase or decrease as the distance between the sorce and the…

A: Amount of radiation between the source and sensor is determine using the inverse square formula:…

Q: In Monochromators the entrance slit transmits a single A the exit slit transmits a single A the…

A: A monochromator is an optical device used in the spectrometer.

Q: To the presence of hexane HBr addition PEROXIDE leads to the output: subject to

A: Markovnikov's rule says that when the addition of unsymmetrical molecules like H2O, HX, HOX, etc. to…

Q: Why is the monochromator not placed after the TCH lamp when performing an absorbance or…

A: Since the basis for the AAS process is atomic ABSORPTION, the monochromator seeks to only allow the…

Q: (a) Draw the variation of signal strength with applied voltage for a-particles and explain.

A: This Question is based on Nuclear Chemistry concept.

Q: 1. Which following statement is NOT correct for Matrix-Assisted Laser Desorption/Ionization (MALDI)…

A: 1) C. Matrix materials is not applied for biomolecules with laser wavelengths 2) B. requires that…

Question

The bath length in atomic
absorption
spectrophotometer can
usually be changed by.?
a. Using higher
temperature
b. Using a different
hollow cathode lamp
c. Turning a special
handle attached to the
flame holder
d. Using a larger quartz
cuvet
O e. C and D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Answer

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Transparent Conducting Oxides and their Applications

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

* OWLY2 |Online Schedu x My Home ssignment/takeCovalentActivity.do?locator%3Dassignment-take C MasteringAandP: L. G what is the cell wall.. G Mary was in a terrib.. Dimensional Analy.. L. [Review Topics TReferences Use the Referemces ta acces impartant vaees if needed far this question. Does a reaction occur when aqueous solutions of zinc chloride and potassium sulfide are combined? O yes O no If a reaction does occur, write the net ionic equation. Use the solubility rules provided in the OWL Preparation Page to determine the solubility of compounds. Be sure to specify states such as (aq) or (s). If a box is not needed leave it blank. Submit Answer Retry Entire Group 2 more group attempts remaining MC
12.At the applications have high vibration.. is most useful 13. Sphere or nodular graphite cab be produced by adding . or ....... 14.Mg has less ductility than Al because Mg has .. .structure where Al has ... structure
Please answer atleast 4 sub-parts. Thank you.
A- Consider a silicon crystal at 300° K doped with arsenic atoms. Depending on the following figure, find the equilibrium electron and hole concentration n, and p.. Given n; = 1.45 *10 cm. -E E 0.164eV %3D -E,
7. An impure sample of Na S04 weighed 1.562 g. A BASO, precipitate from this sample weighed 2.496 g. Calculate the percentage of sulfur and the percentage purity of the salt. Ans. 21.97% S; 97.25% Na S0. ore sample which weirbed
In the problem 15 above, what is vy , the y-component of the electron’s velocity, when it has reached the right edge of the plates? Note that ay=vyt (be careful with the sign). How is the ratio S/L related to vx and vy , if vy is calculated at the right edge of the plates? The distances S and L are shown in Figure 1.11.
1.The max.% of carbon that can be add to iron is. 2.Medium alloy steel has atotal amount of alloying element about ........... 3. .reduces the brittleness of steel alloy by form ...
Need help with part (d). Thank you :)
An ideal Pa fstom a volume oļ 1.00 m3 to gos exbands at a constant boressune of 6.00x105 a volume of 4.00 m3 and comstant a v0lume of 4.00 m a then is combstezBed to one - thistd that pressuHe and then is compsteBBed to volume of 2.50 m3 as showen in tthe figuHe below befote sretusining Piguare to its initial state , How much woork is done in showwn gas thorough cycle of the þoiocess shown. Pliot Pa) taking a a one in the figune ? ANS;→ Tatom the P-v diagian Fat the P-V diagiam we 00
why spontainiety occur??
Need help with part (c). Thank you :)
Need help with part (b). Thank you :)