The bath length in atomic absorption spectrophotometer can usually be changed by.? a. Using higher temperature b. Using a different hollow cathode lamp Oc. Turning a special handle attached to the flame holder od. Using a larger quartz cuvet e.C and D

The bath length in atomic absorption spectrophotometer can usually be changed by.? a. Using higher temperature b. Using a different hollow cathode lamp Oc. Turning a special handle attached to the flame holder od. Using a larger quartz cuvet e.C and D

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter6: Random Errors In Chemical Analysis

Section: Chapter Questions

Problem 6.17QAP

See similar textbooks

Related questions

Q: nswer these two questions about flame atomic absorption spectroscopy analytic (FAAS) Different…

A: Quantitative applications- Atomic absorption spectroscopy is very useful for the determination of a…

Q: Explain how beam chopping reduces line noise and noise from source drift.

A: To explain: How beam chopping reduces line noise and noise from source drift.

Q: plalh the difference between the split and splitless mode of operation in a GO jector. Consider…

Q: 1. State the reasons for reading the absorbance of unknown against reagent water blank or against…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: What are the processes of concentrate samples analysis in Uv-visible spectroscopy? Please answer…

Q: Is the Cu detectable at a concentration of 0.10 mg/L in Flame-AAS? Please use data given.

A: Flame AAS is atomic absorbation spectroscopy. Which is used to detect the various sample i. e.blood…

Q: If a plot between absorption and concentration was not linear and a plot between absorbance and bath…

A: Interpretation: To identify the reason for why the absorbance and concentration plot is not linear.

Q: A reference UV Vis abrorption spectrum of the solvent alone, which is subtracted fram the spectrum…

A: We can find the concentration of a solution from its absorption value in the UV-Vis spectrum. More…

Q: ewavelength of a

Q: Relative Standard Deviation of UV Vis, please explain.

A: A question based on RSD, which is to be accomplished.

Q: (c). What is the dynamic range of the method? Hint: it is NOT the entire concentration range. (d). A…

A: Atomic absorption spectroscopy is a quantitative spectroscopic method to determine the concentration…

Q: Using words and/or pictures and/or equations, explain how the use of a deuterium (D2) lamp can…

A: Atomic Absorption Spectroscopy is a technique used for the quantitative determination of different…

Q: According to Beer’s law, if b and ε are held constant, absorbance is directly proportional to _____.

A: The correct answer is given below

Q: Is standardization against primary standard required for controlled potential coulometry ?

A: Controlled potential coulometry, as the name suggests, is a coulometry method that measures the…

Q: An empty infrared cell showed 8.9 interference fringes in the wavelength range of 1894 to 2399 cm-1.…

A: The equation required to determine the path length of cell is as follows, b=∆N2ν1-ν2

Q: Noise is a result of which source(s): Filtering Diffraction of Radiation O Shielding Chemical O…

A: NOISE: Noise is defined as an unwanted sound which is very loud or unpleasant. It can be created by…

Q: What type of instrument is shown in the diagram? Reference cell Po 0. Amplifier Grid Source hv…

A: The light beam in single beam instruments passes through the sample without splitting, but the beam…

Q: Which of the following statements about flame ionization detector (FID) is not true? O A. FID…

A: FID (Flame Ionization Detector) is a chromatographic instrument used for the analysis of any organic…

Q: At what potential should the cyclical sweep begin? O open circuit potential O anodic peak potential…

A: In cyclic voltammetry voltage used to change between two values i.e. cathodic peak potential and…

Q: Why does the fluorescence quenching happen? Please shortly answer at your own words. Answer should…

A: A molecule of a substance after absorbing UV/Vis light gets excited to upper energy level from the…

Q: In Spectrophotometric Determination of a Metal, how do you compute or get for the Corrected…

A: We know spectrophotometric method is the most widely used tool to study the formation of metal…

Q: A student wants to determine the concentration of iron ion in a 15.000 gram solid that contains…

A: As the solution is absorbing green light, the color of the solution would be red according to color…

Q: The bath length in atomic absorption spectrophotometer can usually be changed by...? O a. Using…

A: Atomic absorption spectrophotometer detects elements in either liquid or solid samples through the…

Q: State if rotation is (+) or (-). Note that all samples were measured using a 1.0 dm tube at 21.5…

A: polarimeter is a optical instrument to measure angle of rotation of a optically active compound.

Q: The transmittance measured for a CH stretch vibration in an alkane is measured to be 26%. What is…

A: This problem can be solved by using Beer lambert's law according to which :…

Q: The bath length in atomic absorption spectrophotometer can usually be changed by.? a. Using higher…

A: A question about atomic absorption spectroscopy, which is to be accomplished.

Q: For bulk crystalline sample which technique is best ? Give me handwritten answer with explaination?

Q: why is an electro thermal atomizer more sensitive than flame atomizer?

A: The oldest technique used in Atomic absorption spectroscopy is the Flame atomizer.

Q: In which technique, atomic absorption or atomic emission, is flame temperature stability more…

A: To explain in which below technique, the flame temperature stability is more critical. Atomic…

Q: (a) Why is carbon used as an electrode in arc and spark sources? Explain briefly. (b) Compare…

A: Carbon used as an electrode in arc and spark sources: If we pass the high voltage of electric…

Q: If a plot between absorption and concentration was not linear and a plot between absorbance and bath…

A: We know that absorbance is given by the formula, A = ∈ c l where A = absorbancec = concentrationl=…

Q: The diagram below represents the layout of a typical single-beam UV-Vis, explain the function of…

Q: Explain if we need or not a quartz cuvet when doina UV-visible Absorption spectrometry.

Q: Two students A, B did the Flame photometric analysis by different atomization methods in which the…

A: Flame Atomic Absorption Spectroscopy (FAAS), commonly called flame spectroscopy is a branch of…

Q: A HPLC column had a sample (0.10ml) loaded onto it. The detector volume showed 0.15 mL. From this…

A: Before starting any troubleshooting, whether it is related to instruments or columns, it isessential…

Q: Consider the chromatogram that t3=20 sec, calculate for its number of theoretical plates: " 12 Ty…

A: Here we are required to find the number of theoretical plates

Q: Two parallel gray planes have emissivities of 0.8 and 0.7 and are maintained at 800°C and 1500°C.…

Q: sing words and/or pictures and/or equations, explain how the use of a deuterium (D2) lamp can…

A: The flame atomic absorption spectrophotometry is a technique to estimate the amount of metal in the…

Q: 2. Please calculate absorbance for below a. a solution with a transmittance of 0.570 b. a solution…

A: When radiations fall on a substance, some amount of radiation gets absorbed by the sample and the…

Q: State if rotation is (+) or (-). Note that all samples were measured using a 1.0 dm tube at 21.5…

A: A polarimeter is a optical instrument to measure angle of rotation of a optically active compound.

Q: a) You measure the percent transmittance of a solution containing chromophore X at 400nm in a 1-cm…

A: From data T%= 50%, so, T= 0.5 l = 1 cm c = 0.5mM= 0.0005M A1 = 0.2 A2 = 0.8 Furthermore, molar…

Q: To the presence of hexane HBr addition PEROXIDE leads to the output: subject to

A: Markovnikov's rule says that when the addition of unsymmetrical molecules like H2O, HX, HOX, etc. to…

Q: Why is the monochromator not placed after the TCH lamp when performing an absorbance or…

A: Since the basis for the AAS process is atomic ABSORPTION, the monochromator seeks to only allow the…

Q: Why do you have to use the same cuvette after doing the baseline correction in Ultraviolet-Visible…

A: Answer - Ultraviolet-Visible Spectrophotometry - Ultraviolet-visible (UV-Vis) spectrophotometry is…

Q: According to given TLC plate below which of the following statement(s) is/ are false ? |- Rf value…

A: It is given a TLC plate in which the solvent travels a distance of 0.75 (approximately), and…

Q: Calculate the Rf for the TLC spot

A: We have to calculate the Rf for given TLC spot.

Concept explainers

Crystallography

Crystallography is the category of science that focuses on the atomic and molecular arrangements with their bonding constituting the crystal structure. It is derived experimentally and originated in the year 1912. It is a combination of two words; those are crystal, meaning a cold drop, and graph, meaning writing.

Question

The bath length in atomic absorption spectrophotometer can
usually be changed by..?
a. Using higher temperature
b. Using a different hollow cathode lamp
c. Turning a special handle attached to the flame holder
d. Using a larger quartz cuvet
e. C and D

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

The bath length in atomic absorption spectrophotometer can usually be changed by. O a. Using higher temperature O b. Using a different hollow cathode lamp O c. Turning a special handle attached to the flame holder O d. Using a larger quartz cuvet O e.C and D
Convert the following transmittance or % transmittance to absorbance. a. 0.305 b. 45.7%
Surface atoms rearrange itself because of lack of. and link to..... atoms ... 1. Topmost Layer, surface atoms O2. Bulk Layer, bulk atoms 3. All Stated O4. Topmost Layer, Bulk Layer
The following are the reasons why instrumental analysis methods are used, except for: a. Narrow concentration ranges may be detected. b. Extreme low sensitivity, with molecule and noise signal detection. c. Separate equipment or facilities for control, data handling, and optimization procedures. d. All of the above
Use the data in Figure 4.8 to estimate the ratio of radiation intensity at 10,000 Å (infrared) to that at 5000 Å (visible) from a blackbody at 5000 K. How will this ratio change with increasing temperature? Explain how this change occurs.
A typical split ratio is in ........ratio for .........quantity of sample?
The percent transmittance (%T) is defined as: %T = (I/Io)*100. What does I stand for? Select one: a. intensity of emitted light by the pure solvent; b. intensity of light transmitted through the sample; c. intensity of emitted light by the sample; d. intensity of light transmitted through the pure solvent; e. all options are incorrect;
i) The transmittance of as solution measured at 590nm in a 1.5cm cuvette was 76.2%. ii) Calculate absorbance of above solution? iii) If the concentration is 0.0802 M, what is the molar absorptivity of this solution at given wave length? iv) If the molar absorptivity is 10000L/ (mol.cm), what is the concentration?
Is it possible to obtain negative values of the absorbance and in what conditions? In reference to Beer's Law.
Why can't we use continuous spectrum source and select necessary wavelengths using monochromator and polychromator in the atomic absorption spectroscopy?
5. why do we need spindle cide in viscometer ?
Determine the relationship. In ATR-FTIR, as we increase the wavenumber, the penetration depth In ATR, the higher the reflective index of the crystal, the penetration depth _______. In ATR-FTIR, as you decrease the sample size the penetration depth ____. In ATR-FITR, as the wavelength increase, the penetration depth _____. A. increases B. decreases C. decreases exponentially D. does not affect