Suppose a heat engine is connected to two energy reservoirs, one a pool of molten aluminum (660°C) and the other a block of solid mercury (-38.9°C). The engine runs by freezing 1.40 g of aluminum and melting 16.0 g of mercury during each cycle. The heat of fusion of aluminum is 3.97 x 105 J/kg; the heat of fusion of mercury is 1.18 x 104 J/kg. What is the efficiency of this engine? 74.9 x Note that the usable energy in a heat engine is the difference between the energy input and the exhaust energy. %

Suppose a heat engine is connected to two energy reservoirs, one a pool of molten aluminum (660°C) and the other a block of solid mercury (-38.9°C). The engine runs by freezing 1.40 g of aluminum and melting 16.0 g of mercury during each cycle. The heat of fusion of aluminum is 3.97 x 105 J/kg; the heat of fusion of mercury is 1.18 x 104 J/kg. What is the efficiency of this engine? 74.9 x Note that the usable energy in a heat engine is the difference between the energy input and the exhaust energy. %

Principles of Physics: A Calculus-Based Text

5th Edition

ISBN:9781133104261

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter18: Heat Engines, Entropy, And The Second Law Of Thermodynamics

Section: Chapter Questions

Problem 3P

See similar textbooks

Similar questions

A certain steel railroad rails 13 yd in length and weighs 70.0 lb/yd How much thermal energy is required to increase the length of such a rail by 3.0 mm? .Note: Assume the steel has the same specific heal as iron.
In performing 100.0 J of work, an engine discharges 50.0 J of heat. What is the efficiency of the engine?
For a temperature increase of 10 at constant volume, what is the heat absorbed by (a) 3.0 mol of a dilute monatomic gas; (b) 0.50 mol of a dilute diatomic gas; and (c) 15 mol of a dilute polyatomic gas?
(a) What is the rate of heat conduction through the 3.00-cm-thick fur of a large animal having a I .40-m surface area? Assume that the animal's skin temperature is 32.0 , that the air temperature is 5.00 , and that has the same thermal conductivity as air. (b) What food intake will the animal need in one day to replace this heat transfer?
A heat pump has a coefficient of performance of 3.80 and operates with a power consumption of 7.03 103 W. (a) How much energy does it deliver into a home during 8.00 h of continuous operation? (b) How much energy does it extract from the outside air?
When 400 J of heat are slowly added to 10 mol of an ideal monatomic gas, its temperature rises by 10 . What is the work done on the gas?
A coal power plant consumes 100,000 kg of coal per hour and produces 500 MW of power. If the heat of combustion of coal is 30 MJ/kg, what is the efficiency of the power plant?
The insulated cylinder shown below is closed at both ends and contains an insulating piston that is flee to move on frictionless bearings. The piston divides the chamber into two compartments containing gases A and B. Originally, each compartment has a volume of 5.0102 m3 and contains a monatomic ideal gas at a temperature of and a pressure of 1.0 atm. (a) How many moles of gas are in each compartment? (b) Heat Q is slowly added to A so that it expands and B is compressed until the pressure of both gases is 3.0 atm. Use the fact that the compression of B is adiabatic to determine the final volume of both gases. (c) What are their final temperatures? (d) What is the value of Q?
A multicylinder gasoline engine in an airplane, operating at 2.50 103 rev/min, takes in energy 7.89 103 J and exhausts 4.58 103 J for each revolution of the crankshaft. (a) How many liters of fuel does it consume in 1.00 h of operation if the heat of combustion of the fuel is equal to 4.03 107 J/L? (b) What is the mechanical power output of the engine? Ignore friction and express the answer in horsepower. (c) What is the torque exerted by the crankshaft on the load? (d) What power must the exhaust and cooling system transfer out of the engine?
If a gas is compressed isothermally, which of the following statements is true? (a) Energy is transferred into the gas by heat. (b) No work is done on the gas. (c) The temperature of the gas increases. (d) The internal energy of the gas remains constant. (e) None of those statements is true.
A gasoline engine has a power output of 170 kW (about 2.28×105 hp ). Its thermal efficiency is 22.0 %. How much heat must be supplied to the engine per second? Express your answer in joules per second. How much heat is discarded by the engine per second? Express your answer in joules per second.
Compressed air can be pumped underground into huge caverns as a form of energy storage. The volume of a cavern is 6.3 x 105 m³, 5 and the pressure of the air in it is 7.4 × 106 Pa. Assume that air is a diatomic ideal gas whose internal energy U is given by U = nRT. If one home uses 30.0 kWh of energy per day, how many homes could this internal energy serve for one day?