Create a degree of freedom table using the "Short Cut Method" for the steady-state sugar evaporation system shown below. Stream B Rate: B = ?? Composition: Water: BW= 100% Evaporator 1 Feed: Stream A Rate: A = 50,000 kg/h Composition: Sugar: As = 50% Water: Aw= 50% Stream E Rate: E = ?? Composition: Sugar: Es = ?? Water: Ew = ?? Stream C Rate: C = 1,000 kg/h Composition: Water: Cw = 100% Evaporator 2 Product: Stream D Rate: D = ?? Composition: Sugar: D,= 60% Water: Dw= ?? Figure 1. Sugar concentration process operating at steady-state.

Q: The volume of a system consisting of an ideal gas decreases at constant pressure. As a result, the…

A: The objective of the question is to calculate the heat transferred to the system (qp) when the…

Q: Water of is Flowing through 2.54 cm horizontal tube diameter, what is the maximum will be average…

A: The diameter of horizontal tube, D = 2.54 cm = 0.0254 mViscosity of water, Density of wtaer, At…

Q: The methane (CH4) gas at 25°C is fed into a furnace with 100% excess air at 100°C. Q 1.0 mol CH4(g),…

A: ReactionData,

Q: Krypton is contained in a closed cylinder fitted with a weightless piston at 141 K and 1 bar. Heat…

A: The objective of the question is to calculate the change in molar enthalpy (ΔH) for krypton, an…

Q: A lagoon with volume 15,000 m3 is being polluted by a stream that flows at 1,000 m3/day andcarries…

A: The objective of the question is to determine the concentration of fecal bacteria in the lagoon…

Q: Krypton is contained in a closed cylinder fitted with a weightless piston at 162 K and 1 bar. Heat…

A: Given Data:Krypton is contained in a closed cylinder fitted with a weightless piston.The Pressure P1…

Q: A batch process is operated with the following sequence. The feed to the batch process consists of a…

A:

Q: A transmission case measures W = 0.30 m on a side and receives a power input of P; = 150 hp from the…

A:

Q: Heat Conduction The wall (thickness L) of a furnace, with inside temperature 800° C, is comprised of…

A:

Q: 52) In the Cu - Ag phase diagram shown below Composition (at% Ag)

A:

Q: Q) a)Sketch the iron carbon phase diagram and estimated composition of i-iv on diagram b) allows in…

A: The iron-carbon phase diagram is an important tool in metallurgy for demonstrating the phase…

Q: Hydrodealkylation is a process in which side chain alkyl groups (like methyl) are removed from…

A: Data

Q: 0.0239 mol of bismuth ( Mwt=209) is heated along with 0.0312 mol of sulfur (Mwt=32) to form Bi₂S3…

A: Bismuth (Bi) is heated with sulfur (S) to form Bi2S3 , according to following reaction,The number of…

Q: discuss any one horizon sand mill in Oil & Paint Technology

A: A Horizontal Bead (Sand) Mill is a type of grinding machine that is used to disperse and grind…

Q: The equilibrium constant (K) of the following reaction under the conditions of 298.15 K and 0.1 MPa…

A: Now,Taking,

Q: Example 2: For the reaction bellow: CnH(2n+2) + a(O₂ + 3. 76 N₂) → nCO2 + (n + 1)H₂O + 3. 76a №₂ If…

A: Given reaction is Heat of combustion is given as,

Q: (d) Given a fluid viscosity of 0.001 Pa-s, calculate shear stress at (x, y) = (1, 3).

A:

Q: Hydrodealkylation is a process in which side chain alkyl groups (like methyl) are removed from…

A: DataEquationBasis,

Q: 6) 1) check the dimensionless homogeneity of the following 2g (Pm-P)z P U= where, u-velocity,…

A: The homogeneity of the given expression for velocity  can be checked by verifying that all the terms…

Q: write a detail note on pug mill and dough mixer.

A: The objective of this question is to provide a detailed explanation about two types of industrial…

Q: N-Ti Temperature C 3500 3000 2500 2000 1670°C? (STI) 1500- 1000- 500 882°C 0 Ti 10 L 14.0 (aTi) 20…

A: A phase diagram for N-Ti is given.There are four phases given, that are,L

Q: Not graded assignmen can u do b , d and f

A: The objective of the question is to calculate the aromaticity of ortho-xylene, find the mass density…

Q: • A manometer is used to measure the pressure of a gas in a tank. The fluid used has a the specific…

A: Given data:specific gravity = 0.85The manometer column height is 55 cm.The local atmospheric…

Q: Hydrodealkylation is a process in which side chain alkyl groups (like methyl) are removed from…

A: Hydrodealkylation process - Hydrodealkylation is a chemical reaction that often involves reacting an…

Q: From the graph below, which shows carbon dioxide concentration in the atmosphere: Carbon dioxide…

A: A graph showing carbon dioxide concentration with the atmosphere is given,the initial concentration…

Q: An aqueous solution feed of 1,000 kg/h of 29 wt% acetone is to be multistage countercurrent…

A: For part 2 some properties(interfacial tension, Viscosity. specific heat capacity, and density for…

Q: Write the oxide composition limits of OPC and explain their necessity

A: The objective of the question is to understand the oxide composition limits of Ordinary Portland…

Q: 1. Calculate the surface per unit volume in square centi- meters per cubic centimeter of galena…

A: Mesh%…

Q: Consider the toluene hydrodealkylation reaction that produces benzene and methane, as shown below.…

A: Toluene dealkylation reaction is given as,Initial number of moles of Toluene (C7H8) in the feed,…

Q: C.W2: Refrigerant-134a enters the condenser of a residential heat pump at 800 kPa and C at a rate of…

A:

Q: Describe types and benefits of pigments, paint and oil.

A: The objective of this question is to understand the different types of pigments, paints, and oils,…

Q: (a) Below is the suggested rate law that is consistent with the data. k Cão Co₂ (1 + KcoCco)² -co =…

A: Reaction,Rate of reaction,

Q: The second virial coefficient is related to pair-wise potential function via B(T) = 2πN₁₁ (1 e-/kT)…

A:

Q: Classify the types of admixtures and write a short note on them .

A: The objective of this question is to classify the types of admixtures used in concrete and provide a…

Q: 5-19. A controller receives a signal from a tempera- ture transmitter with a range of 100 to 150°C.…

A:

Q: 1. Water is flowing through a 0.75 m diameter pipe. The velocity distribution in the pipe is given…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: Stream B Rate: B = ?? Composition: Water: BW= 100% Evaporator 1 Feed: Stream A Rate: A = 50,000 kg/h…

A:

Q: 05: The level of the water in an enclosed water tank is (40 m) above ground level. The pressure in…

A:

Q: 1. Please consider the reaction below. The reactants enter at 1 bar and 373 °C. The product exits at…

A: The following reaction is given,The reaction is under constant pressure of ,initial temperature,…

Q: 4. An experimental test rig is used to examine two-phase flow regimes in horizontal pipelines. A…

A: A two-phase flow regimes in horizontal pipelines is given with the following data,the temperature of…

Q: 3-19. Draw the block diagram representing the following transfer functions. In each case, do not do…

A: Block diagrams are made up of a single block or a group of blocks. These are used to graphically…

Q: P23-1A Rogen Corporation manufactures a single product. The standard cost per unit of product is…

A: It is given that a company is manufacturing a single product and the following data has been…

Q: Q.2: The combustion analysis using ORSAT apparatus, where the analysis indicated as 15% CO2, and…

A: Given data:In the dry stack gas, the composition of CO2 is 15 %.The fuel is C4H9OH.

Q: The mixture containing 40% Benzene by Weight - 60% Toluene shall be distilled in a continuously…

A: It is given that a mixture of Benzene and toluene is being distilled. The following data is…

Q: EXAMPLE 10-2 An Actual Steam Power Cycle A steam power plant operates on the cycle shown in Fig.…

A: Now we see at point 1:Now at the point 3:

Q: A computer consists of an array of five printed circuit boards (PCBs), each dissipating P, = 20 W of…

A:

Q: 3) What is the pH of a 0.02 M solution of sodium propionate? (12 pts) Reaction of sodium propionate…

A: The objective of the question is to calculate the pH of a 0.02 M solution of sodium propionate.…

Q: . Background of the (***** Manufacturing Industry) • Briefly introduce the chemical industry to set…

A: “Since you have posted multiple questions with multiple sub-parts, we will provide the solution only…

Q: - Specifically define endothermic, exothermic, dissolution, and enthalpy -Explain how enthalpy can…

A: “Since you have posted multiple questions, we will provide the solution only to the first question…

Q: (a) Let's consider a steady flow of an incompressible Newtonian fluid (with a density of p and a…

A: "Since you have posted multiple questions, we will provide the solution only to the first question…