(a)
The charge on the capacitor plate.
(a)
Answer to Problem 99P
The charge on the capacitor plate is
Explanation of Solution
Given:
The value of emf is
The value of capacitance is
The resistance is
Formula used:
The expression for the charge as a function of time is given as,
Calculation:
The charge on the capacitor plate after
Conclusion:
Therefore, the charge on the capacitor plate is
(b)
The rate of increasing charge.
(b)
Answer to Problem 99P
The rate of increasing charge is
Explanation of Solution
Formula used:
The expression for rate of increasing charge is,
Calculation:
The rate of increasing charge after
Conclusion:
Therefore, the rate of increasing charge is
(c)
The current after
(c)
Answer to Problem 99P
The current after
Explanation of Solution
Formula used:
The expression for current is,
Calculation:
From equation (1) and (2), the current after
Conclusion:
Therefore, the current after
(d)
The power supplied by battery.
(d)
Answer to Problem 99P
The power supplied by battery is
Explanation of Solution
Formula used:
The expression for power is,
Calculation:
The power supplied by battery after
Conclusion:
Therefore, the power supplied by battery is
(e)
The power delivered to resistor.
(e)
Answer to Problem 99P
The power delivered to resistor is
Explanation of Solution
Formula used:
The expression for power delivered to resistor is,
Calculation:
The power supplied by battery after
Conclusion:
Therefore, the power delivered to resistor is
(f)
The rate of stored energy.
(f)
Answer to Problem 99P
The rate of stored energy is
Explanation of Solution
Formula used:
The expression for stored energy is,
Calculation:
Differentiate equation (3) with respect to time,
The rate of stored energy is calculated as,
Conclusion:
Therefore, the rate of stored energy is
Want to see more full solutions like this?
Chapter 25 Solutions
Physics for Scientists and Engineers
- Power P0 = I0 V0 is delivered to a resistor of resistance R0. If the resistance is doubled (Rnew = 2R0) while the voltage is adjusted such that the current is constant, what are the ratios (a) Pnew/P0 and (b) Vnew/V0? If, instead, the resistance is held constant while Pnew = 2P0, what are the ratios (c) Vnew/V0, and (d) Inew/I0?arrow_forwardAn ECG monitor must have an KC time constant lessthan 1.00102s to be able to measure variations involtage oversmall time intervals, (a) If the resistance of the circuit (duemostly to that of the patient's chest) is 1.00kTwhat is the maximum capacitance of the circuit?(b) Would It be difficult in practice to limit the capacitance to less than the value found in (a)?arrow_forwardin the curcuit shown in the figure , the S switch is closed at t = 0 and the capacitors, which are completely empty, begin to fill. Here E = 20 V , C = 4uF and R = 30 ohm. a) what is the time constant of the circuit , T in units of microseconds? b)when t=T , what is the total charge , in units of microcloumb accumulated in the capacitors ?arrow_forward
- In the circuit shown, the capacitor has an initial charge of Qo at t=0. When the switch S is closed at t=0, the capacitor takes 38 s for its charge to drop to 50% of Qo. Find the time (in seconds) it takes the charge to drop to 30% of Qoarrow_forward210 0 a 24 V 50 μ 320 0 First, what is the time constant of the circuit formed when a and c are connected? Give your ans in ms to 3 significant digits. Question 17 Next, what is the time constant of the circuit formed when b and c connected? Give your answe ms to 3 significant digits. Question 18 Finally, you perform the following sequence of events. The capacitor starts uncharged and the switch is flipped to connect a and c. The capacitor is charged for 20 ms. The switch is then flipp to connect b and c, and the capacitor is discharged for 26 ms, at which time the switch is set to position where it is not in contact with either a or b. What is the voltage on the capacitor? Give answer to 2 significant digits.arrow_forwardIn the RC circuit below, Vs-17, R = 1kQ2, and the capacitor =51 µF. if, initially, the switch is at position A and the capacitor is fully charged, what time, seconds (to two decimal places), will it take V to reach 4 Volts after the switch is moved from position A to position B? Vs A B R Vxarrow_forward
- Consider the circuit shown in the figure below, where C, - 8.00 uF, C, - 8.00 uF, and AV = 22.0 V. Capacitor C, is first charged by closing switch S,. Switch S, is then opened, and the charged capacitor is connected to the uncharged capacitor by closing S AV (a) Calculate the initial charge (in pC) acquired by C (Round your answer to at least one decimal place.) (b) Calculate the final charge (in uC) on each capacitor. (Round your answers to at least the nearest integer) (c) What 17 After a very long time, switch S, is also closed. By what amount does the charge on the second capacitor change after 5, has been closed for a very long time? (Give your answer in uC.)arrow_forwardQ ✰ ✰ O A capacitor Co is placed in a simple loop circuit with a variable voltage source set at Vo, producing stored charge Qo on the capacitor. If the The capacitor is replaced with C₁ with a capacitance of 3.6℃o, and the voltage changed to 1.6V, What is the new charge Qnew in terms of Qo? Supply the missing numerical factor below. Qnew =( Qoarrow_forwardWhile the switch is open, denote the energy stored in capacitor C1 with U0. After the switch has been closed for a long time, denote the energy stored in C1 with U1. Find the ratio U0/U1. Assume R1=1.87 ohm.arrow_forward
- A capacitor with capacitance C = 5 µF is charged to a voltage V = 10V. It is then discharged through a resistor R=2 MQ. At what time after the start of the discharge process has the voltage across the capacitor fallen to 1V?arrow_forwardFor the circuit shown in the figure, V = 20 V, C = 10 μF, R = 0.80 MQ, and the battery is ideal. Initially the switch S is open and the capacitor is uncharged. The switch is then closed at time t = 0.00 s. What is the charge across the capacitor 20 s after closing the switch? { www R O 0.18 mC O 1.5 mC O 0.48 mC O 3.0 MC O 2.3 MCarrow_forwardConsider the circuit shown in the figure. A short time after closing the switch, the charge on the capacitor is 90.0% of its initial charge. Assume the circuit has a time constant of 17.7 s. +Q C Fe (a) Calculate the time interval required (in s) for the capacitor to reach this charge. (b) If R = 220 k2, what is the value of C (in µF)? µF RIarrow_forward
- College PhysicsPhysicsISBN:9781305952300Author:Raymond A. Serway, Chris VuillePublisher:Cengage LearningPrinciples of Physics: A Calculus-Based TextPhysicsISBN:9781133104261Author:Raymond A. Serway, John W. JewettPublisher:Cengage Learning
- Physics for Scientists and Engineers: Foundations...PhysicsISBN:9781133939146Author:Katz, Debora M.Publisher:Cengage LearningGlencoe Physics: Principles and Problems, Student...PhysicsISBN:9780078807213Author:Paul W. ZitzewitzPublisher:Glencoe/McGraw-Hill