Delmar's Standard Textbook Of Electricity
7th Edition
ISBN: 9781337900348
Author: Stephen L. Herman
Publisher: Cengage Learning
expand_more
expand_more
format_list_bulleted
Textbook Question
Chapter 21, Problem 7RQ
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25
Expert Solution & Answer
Trending nowThis is a popular solution!
Students have asked these similar questions
An RC circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 ohms and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
The attached image shows a circuit with an AC voltage source, a resistor, inductor, and capacitor connected in series. The circuit has the following characteristics:
Resistor resistance: 10 ohm
Capacitor capacitance: 0.05 F
Inductor inductance: 13 H
Current Amplitude: 4 A
Voltage amplitude across the source: 60 V
Frequency at the source: 0.3 Hz
Voltage amplitude across the resistor: 35 V
Voltage amplitude across the capacitor: 37 V
Voltage amplitude across the inductor: 80 V
(a) Calculate the RMS voltages from the amplitudes above. From the RMS voltages across the capacitor, inductor and resistor, calculate the RMS voltage of the AC source.
Hint: Vrms = V0/sqrt(2)
Vrms = sqrt( (Vrms,R)2 + (Vrms, L - Vrms, C)2 )
(b) Calculate the RMS value of the current
(c) Using the resistance, capacitance, inductance, and the frequency of the AC voltage, calculate the impedance Z. From this, and the previously measured value of Vrms, find the RMS value of the current in the circuit.
A 47-ohms load resistor is connected in series with a 10-uF capacitor. At what frequency will the capacitor reach the same value as the load resistor?
Chapter 21 Solutions
Delmar's Standard Textbook Of Electricity
Ch. 21 - In a pure capacitive circuit, does the current...Ch. 21 - A series circuit contains a 20- resistor and a...Ch. 21 - An RC series circuit has a power factor of 76%....Ch. 21 - An RC series circuit has a total impedance of 84 ....Ch. 21 - A capacitor has a capacitive reactance of 50 when...Ch. 21 - A 15-F AC capacitor is connected in series with a...Ch. 21 - An RC series circuit is connected to a 120-V,...Ch. 21 - An RC series circuit is connected to a 240-V,...Ch. 21 - Prob. 1PPCh. 21 - Assume that the voltage drop across the resistor,...
Ch. 21 - Assume the circuit shown in Figure 21-1 has an...Ch. 21 - Assume the circuit in Figure 21-1 has a power...Ch. 21 - In a series RC circuit, ET=240 volts, R=60, and...Ch. 21 - In a series RC circuit, ET=120 volts, R=124, and...Ch. 21 - In a series RC circuit, ET=208 volts, IT=2.4...Ch. 21 - In a series RC circuit, ET=460 volts and =44. Find...Ch. 21 - In a series RC circuit, ET=240 volts at 60 Hz. An...Ch. 21 - In a series RC circuit, the apparent power is 4250...
Knowledge Booster
Learn more about
Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.Similar questions
- A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?arrow_forwardTwo capacitors having values of 80 F and 60 F are connected in series. What is the total capacitance?arrow_forwardYou find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.arrow_forward
- A pure capacitive circuit is connected to a 480-volt, 60-Hz power source. An ammeter indicates a current flow of 24 amperes. The circuit current must be reduced to 16 amperes by connecting a second capacitor in series with the first. What is the value of the existing capacitor? What value capacitor should be connected in series with the original capacitor to limit the circuit current to 16 amperes?arrow_forwardIncandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.arrow_forwardA postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?arrow_forward
- Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?arrow_forwardList the five capacitor replacement rules.arrow_forwardWhat is the minimum AC voltage rating of each capacitor in Question 11?arrow_forward
- You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?arrow_forwardYou are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.arrow_forwardThree capacitors having values of 2.2 F, 280 F, and 470 pF are connected in parallel. What is the total capacitance?arrow_forward
arrow_back_ios
arrow_forward_ios
Recommended textbooks for you
- Delmar's Standard Textbook Of ElectricityElectrical EngineeringISBN:9781337900348Author:Stephen L. HermanPublisher:Cengage LearningElectricity for Refrigeration, Heating, and Air C...Mechanical EngineeringISBN:9781337399128Author:Russell E. SmithPublisher:Cengage Learning
Delmar's Standard Textbook Of Electricity
Electrical Engineering
ISBN:9781337900348
Author:Stephen L. Herman
Publisher:Cengage Learning
Electricity for Refrigeration, Heating, and Air C...
Mechanical Engineering
ISBN:9781337399128
Author:Russell E. Smith
Publisher:Cengage Learning
02 - Sinusoidal AC Voltage Sources in Circuits, Part 1; Author: Math and Science;https://www.youtube.com/watch?v=8zMiIHVMfaw;License: Standard Youtube License