Consider a feedback amplifier for which the open-loop gain is given by
(a) Determine the frequency
(a)
The frequency
Answer to Problem 12.80P
The value of the voltage
Explanation of Solution
Given:
The expression for the open loop gain of the amplifier is given by,
The phase of
Calculation:
The expression for the phase transfer function
Substitute
The expression for the magnitude of the transfer
Conclusion:
Therefore, the value of the voltage
(b)
The magnitude of the loop gain
To identify: Whether the system is stable or not.
Answer to Problem 12.80P
Thevalue of
Explanation of Solution
Given:
The expression for the open loop gain of the amplifier is given by,
The value of
Calculation:
The given expression for the transfer function is shown below,
Substitute
Substitute
The expression for the phase transfer function is given by,
Substitute
The expression for the closed loop low frequency gain is given by,
Substitute
The magnitude of the loop gain
Conclusion:
Therefore, the value of
(c)
The magnitude of the loop gain
To identify: Whether the system is stable or not.
Answer to Problem 12.80P
Thevalue of
Explanation of Solution
Given:
The expression for the open loop gain of the amplifier is given by,
The
Calculation:
The given expression for the transfer function is shown below,
Substitute
Substitute
The expression for the phase transfer function is given by,
Substitute
The expression for the closed loop low frequency gain is given by,
Substitute
The magnitude of the loop gain
Conclusion:
Therefore, the value of
Want to see more full solutions like this?
Chapter 12 Solutions
Microelectronics: Circuit Analysis and Design
- The voltage gain of an amplifier is 3000 when no feedback is applied. When negative feedback is applied and feedback factor is 0.01, then estimate the gain with feedback.arrow_forwardQ1 Design an operational-amplifier circuit using two inverting configurations to produce the output vo = +201 + 0.5v2 – 0.2v3 – 1v4. Choose feedback resistor Rf = 220kN for each amplifier. %3D | -arrow_forwardd) Infinity 11. The closed loop gain of a summing amplifier with input resistance of 10 Mega ohm and feedback resistance of 50 Mega Ohm is approximately: a) -14 dB b) 14 dB c) -5 dB d) 5 dB 12. A voltage follower op-amp has an open loop gain of 500000 and the bandwidth is 20 MHz, the gain- bandwidth product of the amplifier is: a) 1000000 MHz b) 500000 MHz c) 20000 KHz d) infinityarrow_forward
- Assume that the R2/R1 ratio of a feedback amplifier with voltage supply of +/- 10 V is 3.0 and that a value of 1.0 V is applied to the non inverting input of the op-amp. What is the output voltage value?arrow_forward3. An ideal shunt-shunt feedback amplifier has Rs =∞. If li= 100 microAmp, I fb = 99 microAmp and Vo = 5V determine: a. Az, Bg and Azf, (including the units) b. Rif & Rof if Ri= 5 Kohm & Ro = 4 Kohm.arrow_forwardAssume that the R2/R1 ratio of a feedback amplifier with voltage supply of +/- 10 V is 3.4 and that a value of 8.5 V is applied to the inverting input of the op-amp. What is the output voltage value?arrow_forward
- Design and draw a three-stage amplifier connected in series with gains of +15, –21, and –30 by using OPAMPS. Use a 420 kn feedback resistor for all stages. What output voltage results for an input of V, = 2 mV?arrow_forwardGiven the feedback circuit below and assuming the voltage amplifier has gain A₂, input resistance R₁ and output resistance Ro, answer the following questions: + a. Loop gain b. Closed loop gain Re C. Input resistance d. Output resistance Rin м + RE A) Sketch the feedback small signal model of this circuit. (Hint: You may convert the input VIN and source resistance Rs to its Norton current equivalent if needed) B) Find the following in terms of the amplifier parameters and resistances R, and RF: Routarrow_forwardQuiz: Test 5 New Tab /23350/quizzes/31837/take Problem 1 A positive-feedback amplifier circuit (inverting Schmitt trigger) is shown in the following figure exists in the positive stable state. Determine voltage v at the non-inverting input vs common ground (give you answer in volts) if the output voltage vout 12 V is given to you. 3k2 1kQ vt Vout O V %3D Keep 3 significant digits. O EPIC QAHES LEGIONarrow_forward
- Q) An amplifier has voltage 1 point gain with the feedback of 100. If the gain without feedback changes by 40% and the gain with feedback should not vary more than 8%, the values of open-loop gain and feedback ratio will be respectively given by *arrow_forwardQ) An amplifier has an open-loop gain of 100 and a feedback ratio of 0.4. If the open-loop gain changes by 30% due to temperature, the percentage change in gain of the amplifier with feedback will be (a) 0.73% (b) 0.52% (c) 0.28% (d) 0.45%arrow_forwardThe voltage gains of an amplifier without feedback and with negative feedback, are 100 and 20, respectively. The percentage of negative feedback is:arrow_forward
- Power System Analysis and Design (MindTap Course ...Electrical EngineeringISBN:9781305632134Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. SarmaPublisher:Cengage Learning