Under conditions for which the same room temperature is maintained by a heating or cooling system, it is not uncommon for a person to feel chilled in the winter but comfortable in the summer. Consider a room whose air temperature is maintained at 20°C throughout the year, while the walls of the room are nominally at 30°C and 14°C in the summer and winter, respectively. The exposed surface of a person in the room may be assumed to be at a temperature of 32°C throughout the year and to have an emissivity of 0.90. The coefficient associated with heat transfer by natural convection between the person and the room air is approximately 2 W/m2.K. Calculate the following. Heat flux due to convection: q'onv i W/m? Heat flux due to radiation in the summer: W/m2 Heat flux due to radiation in the winter: qnd = i W/m?

Under conditions for which the same room temperature is maintained by a heating or cooling system, it is not uncommon for a person to feel chilled in the winter but comfortable in the summer. Consider a room whose air temperature is maintained at 20°C throughout the year, while the walls of the room are nominally at 30°C and 14°C in the summer and winter, respectively. The exposed surface of a person in the room may be assumed to be at a temperature of 32°C throughout the year and to have an emissivity of 0.90. The coefficient associated with heat transfer by natural convection between the person and the room air is approximately 2 W/m2.K. Calculate the following. Heat flux due to convection: q'onv i W/m? Heat flux due to radiation in the summer: W/m2 Heat flux due to radiation in the winter: qnd = i W/m?

Principles of Heat Transfer (Activate Learning with these NEW titles from Engineering!)

8th Edition

ISBN:9781305387102

Author:Kreith, Frank; Manglik, Raj M.

Publisher:Kreith, Frank; Manglik, Raj M.

Chapter1: Basic Modes Of Heat Transfer

Section: Chapter Questions

Problem 1.19P: 1.19 A cryogenic fluid is stored in a 0.3-m-diameter spherical container is still air. If the...

See similar textbooks

Similar questions

Under conditions for which the same room temperature is maintained by a heating or cooling system, it is not uncommon for a person to feel chilled in the winter but comfortable in the summer.Consider a room whose air temperature is maintained at 18ºC throughout the year, while the walls of the room are nominally at 24°C and 14°C in the summer and winter, respectively. The exposed surface of a person in the room may be assumed to be at a temperature of 32°C throughout the year and to have an emissivity of 0.90. The coefficient associated with heat transfer by natural convection between the person and the room air is approximately 2 W/m2·K. Calculate the following. a. heat flux due to convection in W / m^2 b. Heat flux due to radiation in the summer in W / m^2 c. Heat flux due to radiation in the winter in W / m^2
Under conditions for which the same room temperature is maintained by a heating or cooling system, it is not uncommon for a person to feel chilled in the winter but comfortable in the summer. Consider a room whose air temperature is maintained at 22°C throughout the year, while the walls of the room are nominally at 24°C and 12°C in the summer and winter, respectively. The exposed surface of a person in the room may be assumed to be at a temperature of 32°C throughout the year and to have an emissivity of 0.90. The coefficient associated with heat transfer by natural convection between the person and the room air is approximately 2 W/m2-K. Calculate the following. Heat flux due to convection: qbonv W/m? Heat flux due to radiation in the summer: Trad i W/m? Heat flux due to radiation in the winter: gad W/m? i Physical Properties Mathematical Functions
Under conditions for which the same room temperature is maintained by a heating or cooling system, it is not uncommon for a person to feel chilled in the winter but comfortable in the summer. Consider a room whose air temperature is maintained at 22°C throughout the year, while the walls of the room are nominally at 26°C and 16°C in the summer and winter, respectively. The exposed surface of a person in the room may be assumed to be at a temperature of 32°C throughout the year and to have an emissivity of 0.90. The coefficient associated with heat transfer by natural convection between the person and the room air is approximately 2 W/m2-K. Calculate the following. Heat flux due to convection: i W/m? Heat flux due to radiation in the summer: gad W/m2 i Heat flux due to radiation in the winter: Trad W/m? i
Under conditions for which the same room temperature is maintained by a heating or cooling system, it is not uncommon for a person to feel chilled in the winter but comfortable in the summer. Consider a room whose air temperature is maintained at 16°C throughout the year, while the walls of the room are nominally at 30°C and 14°C in the summer and winter, respectively. The exposed surface of a person in the room may be assumed to be at a temperature of 32°C throughout the year and to have an emissivity of 0.90. The coefficient associated with heat transfer by natural convection between the person and the room air is approximately 2 W/m2.K. Calculate the following. Heat flux due to convection: q'onv W/m? Heat flux due to radiation in the summer: i W/m? Heat flux due to radiation in the winter: qad W/m? i ||
1. A 1000-W iron is left on the iron board with its base exposed to the air at 20°C. The convection heat transfer coefficient between the base surface and the surrounding air is 35 W/m². °C. If the base has an emissivity of 0.6 and a surface area of 0.02 m², determine the temperature of the base of the iron. 2. The inner and outer surfaces of a 5-m x 6-m brick wall of thickness 30 cm and thermal conductivity 0.69 W/m °C are maintained at temperatures of 20°C and 5°C, respectively. Determine the rate of heat transfer through the wall, in W.
It is designed in such a way that the internal temperature of a commercial heat treatment furnace can reach up to 165 oC. All surfaces of the furnace consist of firebrick (10 cm), insulation material and sheet metal (3mm) from the inside out. Given that the outdoor temperature is 22 oC, the outer sheet will be allowed to go up to 35 oC, which is a temperature that will not be disturbed by hand contact. In this case, determine the insulation material thickness to be used. Insulation material thermal conductivity coefficient is 0.066 insulation W / m oC, 60 W / m oC for sheet metal and 115 W / m oC for firebrick. Indoor heat transfer coefficient will be accepted as 25 W / m2 oC and 12 W / m2 oC for outdoor environment.
It is designed in such a way that the internal temperature of a commercial heat treatment furnace can reach up to 165 oC. All surfaces of the furnace consist of firebrick (10 cm), insulation material and sheet metal (3mm) from the inside out. Given that the outdoor temperature is 22 oC, the outer sheet will be allowed to go up to 35 oC, which is a temperature that will not disturb in contact with hands. In this case, determine the insulation material thickness to be used. The thermal conductivity coefficient of the insulation material is insulation 0.066 W / m oC, 60 W / m oC for sheet metal and 115 W / m oC for firebrick. Indoor heat transfer coefficient will be accepted as 25 W / m2 oC and 12 W / m2 oC for outdoor environment.
A vertical 4-ft-high and 6-ft-wide double-pane window consists of two sheets of glass separated by a 1-in air gap at atmospheric pressure. If the glass surface temperatures across the air gap are measured to be 65°F and 40°F, determine the rate of heat transfer through the window by (a) natural convection and (b) radiation. Also, determine the R-value of insulation of this window such that multiplying the inverse of the R-value by the surface area and the temperature difference gives the total rate of heat transfer through the window. The effective emissivity for use in radiation calculations between two large parallel glass plates can be taken to be 0.82.
To control the aeration and the temperature, a composting plant stores compost in tall 1-m diameter cylindrical heaps. These compost cylinders are exposed to air at 20°C. The thermal conductivity of the compost heap is 1.12 W/m-K. The air around the compost has an average convection coefficient of 8 W/m2.K. The compost generates heat uniformly at 400 W/m³. Neglect any heat transfer from the top and bottom surfaces of the heap and neglect radiation. what is the surface temperature of the compost heap under steady conditions? 32.5 C
A concrete wall, which has a surface area of 20 m2 and is 0.30 m thick, separates conditioned room air from ambient air. The temperature of the inner surface of the wall is maintained at 25°C, and the thermal conductivity of the concrete is 1 W/mK.(a) Determine the rate of heat loss through the wall for outer surface temperatures ranging from −15°C to 38°C, which correspond to winter and summer extremes, respectively. Display your results graphically.(b) On your graph, also plot the rate of heat loss as a function of the outer surface temperature for wall materials having thermal conductivities of 0.75 and 1.25 W/m⋅K. Explain the family of curves you have obtained
A 2-m-long, 4-cm-diameter electrical wire extends across a room at 20°C, as Shown in Fig. below. Heat is generated in the wire due to resistance heating, and the surface temperature of the wire is measured to be 252°C in steady operation. Also, the voltage drop and electric current through the wire are measured to be 80 V and 2 A, respectively. Heat loss transfer by radiation was 40 W from the surface of the wire. Heat transfer coefficient for heat 20 C transfer between the outer surface of the wire and the air in the room. 2 80 V T 252 If the heat generation by electrical wire increased up to 200 W, what is the surface temperature of the wire, assuming no change heat transfer coefficient?
An uninsulated 100-mm diameter steam pipe runs for 25-meters inside a room whose walls and air are at a temperature of 25°C. The superheated steam inside the pipe maintains the temperature at the pipe surface at 150°C. If the natural convection heat transfer coefficient of the air outside the pipe is 10- m2-K and the surface emissivity is 0.8, compute for the total rate of heat transfer from the surface of the pipe in kW.