The open-circuit terminal voltage of a three-phase, 60-Hz synchronous generator is found to be 15.4 kV rms line-to-line when the field current is 420 A. a. Calculate the stator-to-rotor mutual inductance Laf- b. Calculate the open-circuit terminal voltage if the field current is held constant while the generator speed is reduced so that the frequency of the generated voltage is 50 Hz.

The open-circuit terminal voltage of a three-phase, 60-Hz synchronous generator is found to be 15.4 kV rms line-to-line when the field current is 420 A. a. Calculate the stator-to-rotor mutual inductance Laf- b. Calculate the open-circuit terminal voltage if the field current is held constant while the generator speed is reduced so that the frequency of the generated voltage is 50 Hz.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

B) fill in the blanks: that of rotor MMF. 1)In a 3-phase synchronous motor the speed of stator MMF is ......... 2)The synchronous reactance of the synchronous machine is....... 3) When two transformers are operating in parallel, they will share the load as under...... 4)A synchronous motor is operating on no-load at unity power factor. If the field current is increased, power factor will become..
Two 30 AC generators are such that one has twice the linear dimensions of the other. The field windings of each are excited to give identical sinusoidal air gap flux density waveform. Both have the same number of stator slots and identical winding patterns. The conductors per slot in big generator in K times that of the smaller one. The value of K to get equal no-load voltage at same frequency is (a)8 (b) 8 1 (d) 7 (c) 4
A short shunt compound generator supplies 100A at 110V. Armature resistance is 0.050 and the shunt field resistance is 570 and the series field of resistance is 0.042. if the SPL is 852, determine a)Eg b)Copper lossesin b.1)armature b.2)series b.3)shunt c)n
2.2 A three-phase synchronous generator has a reactance of 1.5 p.. and negligible resistance. It supplies a rated current of 1.0 p.. at 1.0 p.u. terminal voltage to a lagging load of 0.9 power factor. Determine the rated excitation voltage in p.u. and the internal load angle. Construct the performance chart of the generator in 2.1 (above) assuming its rating is 450 MVA.
A 50-MVA, 30-kV, three-phase synchronous generator has a synchronous reactance of 8 Ohms/phase and negligible armature resistance. The generator is delivering 50 MVA at 0.8 pf leading to an infinite bus at the rated voltage. Determine the excitation per phase E and the power angle &. Select one: O a. E = 22.78 KV and 8= 15.67 deg. O b. E = 14.115 KV and 8= 25.85 deg. O c. None of these O d. E = 13.96KV and 8= 29.74 deg. O e. E = 27.47KV and 8= 22.84 deg. Impedances are marked in perunit on a 100MVA, 100 KV base. The load at bus 2 is S2= 16MW - 132 MVAR, and the load at EN ? 1:4 4/1- TOSHIBA
. Two dc shunt generators A and B are rated at 100 and 150 kW at 110 V respectively, Their external load characteristics may be considered as straight line. The voltage drop In the terminal voltage from no-load to full-load Is 10 V for A and 20 V ſor B. Determine the operating voltage when these generators are operated in parallel to supply a load of 220 kW.
7 A three-phase, 60-cycle, 32-pole synchronous generator has a sinusoidally distributed air-gap flux of 0.025 weber/pole. The armature core has 324 slots. The armature winding is Y-connected. There are two coil sides per slot and two turns per coil. The coil pitch is 9 slots. Find the generated voltage between the line terminals. Ans. 2,445 V
A long shunt compound generator delivers a current of 10A at 200V and has a series field resistance and shunt field resistance of 1 ohm and 200 ohms respectively. Then line current is a. 2A b. 1A c. 9A d. 10A
A 250-V, 50-kW shunt generator has 1000 turns on each pole of its field winding. On no load a current of 3:5 A in the field winding produces a terminal voltage of 250 V, but on full load the shunt current has to be increased to 5 A for the same terminal voltage at the same speed. Calculate the number of series field turns per pole required for level compounding.
A 3-phase, 60 Hz, 6 pole alternator has an air gap flux which is sinusoidally distributed. The stator has 5 slots per pole per phase and each slots contains 4 conductors arranged in two layers. The coil pitch is 12 slots, with normal excitation and rated speed, the voltage induced per conductor is 25 V. The open circuited emf of this Y-connected machine between lines is?
and t A common base of 100 MVA and 25 KV is selected. What is the current base (Ig) Select one: O a. 4 KA O b. None of these O c. 6.25 kA O d. 2.309 KA A 100-MVA, 60-kV, three-phase synchronous generator has a synchronous reactance of armature resistance. The generator is operating with an excitation per phase E= 47.116 power before losing synchronism (stability limit). and the armature c Thus, the maximum generated power is Pmax =
What are the conditions in paralleling of these DC Generators:a. Shuntb. Seriesc. Compound