The current passing through the resistor 40 when t<0 is * lov # tzo 42 um q 0.02f 323 862 ३०.5M

Q: Q4) For the circuit shown find Z₁, Z2, ZT, 0, I? V +1 5Ω 35 mH 450 µF

A:

Q: The half wave dipole antenna height of transmitter is 175 m and antenna height of receiver is 18 m.…

A: Given:  The height of the transmitter is ht=175 m.The height of the receiver is hr=18 m.The field…

Q: Find the resistance of a material which has a resistivity of 1x109 Ω-m with cross sectional area of…

A:

Q: Consider the following T.F of a certain first order system: Gs = 10/(s+10). Drive an expression for…

A:

Q: B/ Determine the node voltages, Va and Vb, for the circuit of Figure by Nodal analysis method? 3 A…

A: We need to find out node voltage for given circuit

Q: Obtain the transfer function C(s)/R(s) of the block diagram shown in the Fig.(4). G₂ Ge Gr G G₂ OU

A: Given data : The block diagram shown in below,

Q: Given the figure above, determine the switch or switches that must be turned on if the situation…

A: In this questions, we need to tell about which switches will be in close position to circulate the…

Q: The time constant for the following circuit for t>0 is 30 V +1 12 V (+ t=0 b 6Ω www 392 Ω 2 F *

A:

Q: The parameters that are mainly used in * electronics circuits are. Z Parameters Y Parameters H…

A: In this question we will write about two port parameters....

Q: Also, what range of values of K1 will the system be stable? (__<K1<__) And find the value pf K1…

A: Given: The system shown has G1s=1s3+10s2+24s To find: (a) Determine the value of K2 for which the…

Q: Which of these equations is correct (chose one only) ? O 11=h21*11+h12*12 O 12=h21*11+h22*V2 O…

A: We need to choose the correct option.

Q: For the circuit shown the value of VGSQ = a) 12 v. b) 2 v. c) 6.5 v. d) 0 v.

A: It is given that:

Q: Inverse Laplace Transformation: s² +9s +2 ¹(s − 1)²(s + 3) - Find 2-¹[7

A: The formulae used is provided below.

Q: Which configuration will have a zero electric field at the origin? * 2q 5q -3q 3q 2 5q 3q 2q 3 5q…

A: Electric field : Coulomb's law can be determine to calculate the electric field of a point charge,…

Q: 6. Three equal capacitors of 3000μF are connected in series, then the equivalent capacitance Ceq.is…

A: When n equal capacitor connected in parallel then equivalent capacitance will be n * Ceach When n…

Q: Simplify the following block diagram. qo G₁ H₁ G₁ H₂ G₂ G₂

A: Given:

Q: Fig. 7 depicts a block diagram of a system which accepts signal, m(t) and produces output, y(t). The…

A: GIVEN:                       c1(t)=cos(wct)c2(t)=2cos(wct) FIND: (i) Sketch the signal spectrum at…

Q: The parameters that are mainly used in * electronics circuits are Z Parameters Y Parameters H…

A: About electronic circuit parameters

Q: In a television picture tube, electrons are accelerated by an electric field having a value of 1x105…

A: Given data, Electric field, E=1×105 N/C Mass of electron, m=9.1×10-31 kg Charge of electron,…

Q: i. Name two amplifiers from your study that provide a negative voltage gain. ii. Draw these two…

A:

Q: H.W. Consider the following sys. find the of this network. R Jo (s) ; (s) ? Via) с

A:

Q: Which of the following components has the same amount of opposition to current flow at all…

A: The property of material which opposes the flow of current is known as the resistance. The value of…

Q: Find the current through the resistor at t=0+, and at t=1.25s. The switch is closed at t=0 50V 2092…

A: The general expression of current in RL circuit is given as i(t)=VsR(1-e-t(L/R))vS=supply voltage

Q: 3/ Find the impedance parameters for the network shown below V₁ 125 Ω 50 Ω 75 ΩΙ V₂

A: Given circuit :

Q: Calculate the phase and line voltages of three phase star-connected 4 pole small alternator having a…

A: Given data, The total flux is 0.30 Wb. The relative speed is 1500 rpm The number of pole is 4. The…

Q: What is the energy required to build up current of 1A in an inductor of 20 mH?

A: We need to find out energy of given inductor for given current

Q: (B): Obtain the transfer function V₂(s)/V₁(s) of the electronic cct. shown in Fig. (3) Vi(s) C₁ R₂…

A:

Q: 6. Three equal capacitors of 3000μF are connected in series, then the equivalent capacitance Ceq.is…

A: Given, Three equal capacitors are connected in series. Capacitance of each capacitor, C=3000 μF

Q: H.W.@Find the state-transition matrix &(t), Ahe Characteristic equation and eigenvalues of A for the…

A: "According to the Company's policy, we will solve only the first question as the second question is…

Q: -40v O 220 Vz 10 12V Pz max=0.6W RL

A: We need to find out load resistance of given circuit

Q: S.1.) The scalor electric potential V= x²y (2+3). (v) که in empty space is given E find and Pu?

A:

Q: Determine the breakdown voltage of air gaps 2mm 15 mm length under uniform field. Also determine the…

A: It is given that: d1=2 mm=0.2 cmd2=15 mm=1.5 cm

Q: Express the following two signals in terms of the unit step sequence u[t]. Justify your answer with…

A: Unit step signal- If step signal has unity magnitude, so those step signal is known as a unit step…

Q: In an estable multivibrator using a 555 timer, the out put is and the high or logic (1) when the the…

A: Astable multivibrator using 555 timer : An Astable multivibrator using 555 timer is act like a…

Q: (b)- For a feedback system G-k, G,-1/(s'+6s+12) and H=s+2, k20. (bl)- sketch the Root Locus (RL)…

A: The Given Feedback system Gc=k Gp=1s2+6s+12 &amp; H=s+2,k≥0. To sketch the root locus RL To find…

Q: 2.22 For the circuit in Fig. 2.86, find i and iz. 20 mA 6ΚΩ Figure 2.86 For Prob. 2.22. 2 4 ΚΩ

A:

Q: Q1/B/ Sketch the design flow chart for the cooling power electronics microchips.

A: Cooling power electronics microchips : Cooling power electronics microchip is a device which is used…

Q: Q4/Compare between Microprocessor and Microcontroller for the following: 1. Internal Architucture 2.…

A: 1. Internal Architecture: Microprocessor consists of only CPU whereas Microcontroller consists of…

Q: Find Vx in the circuit: 8/30° V + 2 Ω ww j4 Ω 1Ω ell j1Ω 2 Ω ww V + j4Ω Χ -j1Ω -j2V

A:

Q: Find the voltage vo(t) in the circuit of Fig. by means of the Laplace transform.

A: For the circuit given as follows- The s-domain circuit is drawn as shown below-

Q: For the circuit shown below, derive the amplifier gain. Vo V₂ - V₁ V₁ Find the current I if: V₁-2V,…

A:

Q: Q4/ Find the input impedance (Zin) for the circuit shown below j252 Voltage source 5002 L₁ j1022 L₂…

A: Given data,

Q: State the explain kirchoff's law (both kvl kcl)

A: Kirchhoff's First Law – The Current Law, (KCL) Kirchhoff's Current Law or KCL, states that the total…

Q: 47. In NPN BJT, .......current is lowest current. O a. Base. O b. Collector. O O d. Drain. O e.…

A: A BJT is a current controlled Device in which base current control the mode of operation of BJT.…

Q: Convert the logic diagram below to both NAND and NOR implementations. B D 거 E

A: Given here a Logic diagram and asked to implement it with NAND and NOR Gates.

Q: 1) In the mononstable multivibrator using 555 timer, if the output Q = logic (0), what will happen…

A: Answer: 1 ) The capacitor will charge and the transistor will be OFF is correct and remaining…

Q: An ideal transformer has a turns ratio of 8:1 and the primary current is 3A when supplied at 240v…

A: In this question,  We need to determine the secondary voltage and secondary current?  We know  In…

Q: Consider the circuit in Fig. 16.12(a). Find the value of the voltage across the capacitor assuming…

A: Given that      Vst=10 utinitial current through inductor i0=-1Ainitial voltage across capacitor…

Q: In a telephone line of bandwidth 3300 KHz and signal-to-noise ratio S/N=50 dB. What is the channel…

A: Bandwidth is define the effective bandwidth multiply by frequency reuse factor. Channel is the…

Q: B/A shunt generator delivers 450 A at 230 v and the resistance of the shunt field and armature are…

A:

Norton Theorem

In the current circuit law, the Norton theorem (also known as the Mayer-Norton theorem) is a simplification that can be applied to networks generated by a constant line of opposition, power sources, and current assets. In two network terminals, it can be switched on with a current supply and single resistor respectively.