In a television picture tube, electrons are accelerated by an electric field having a value of 1x105 N/C. the acceleration of the electron (in m/s2) is: (mass of electron 9.1x10-31kg and charge of electron - 1.6x10-19c) Select one: O a. -1.76x10¹6 O b.-6.56x10¹6 O c.-9.28X1016 O d. -3.28x10¹6 e.-13.12X10¹6

In a television picture tube, electrons are accelerated by an electric field having a value of 1x105 N/C. the acceleration of the electron (in m/s2) is: (mass of electron 9.1x10-31kg and charge of electron - 1.6x10-19c) Select one: O a. -1.76x10¹6 O b.-6.56x10¹6 O c.-9.28X1016 O d. -3.28x10¹6 e.-13.12X10¹6

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

A forward voltage of 1.75V shifts to the left at a rate 2.65mV per degree centigrade in temperature from 25°C to -35°C. What is the new forward voltage of the diode? * Your answer Find the reverse saturation current of a Silicon diode that displays a forward current of 20 mA at 0.75 V when the Thermal Voltage is 0.038 V. ( Express your answer in 3 decimal places. Your answer can be in p (pico) or n (nano) unit. e.g. only 5 nV. Upload your solution in the file upload question but type Final Answer here. * Your answer
A diode is tested at the presence of dc+ac source, where the diode's average current level (dc level) is 0.2 mA. Find the temperature (both in Kelvin and Celsius) if the dynamic resistance is approximately 200 ohms
5. A voltage source produces a "Triangle" wave and is connected to a series diode and resistor circuit as shown. D1 KH D V1 #1 V R1 R Using the nominal piecewise linear model for a diode, determine from the following possibilities the graph that best represents the voltage across the resistor? (Delete those that do not apply) (Blue curve VR, dashed curve V1). Then determine which graph best represents the voltage across the diode.
The velocity of electrons in an intrinsic silicon material is 80 m/s at a certain temperature. The silicon whose length is 5 cm is subjected to an electric field of 10 volts. Determine the mobility of the electrons in the silicon.
6) You work as an engineer in a company and you have been given the assignment of measuring the electrical conductivity and the band gap (Eg) of a new intrinsic semiconductor material at 20 and 100 °C. You cut this material in the form of a rectangular prism with a length of 30 cm, a width of 1 cm and a thickness of 2 cm, and you applied a potential difference of 1 V by placing electrodes on the faces shown in the figure. In this case, you measure a current of 0.8A at 20 °C and 12A at 100 °C. According to this information a) calculate the electrical conductivity of the material at 20 and 100 °C and b) the band gap of this material. 30 ст 2 ст 1 cm
Q?: Fill in the following blanks with suitable words : 1. Conductivity of a material depends on: and 2. can break the bonds in semiconductor crystals and create free electrons. 3. Mobility and Sheet resistance in semiconductor are measured by 4. Name of the force which bend electron trajectories in magnetic field 5 5 At room temperature, the current in an intrinsic semiconductor is due to is unevenly doped 7. During reverse bias of the diode there is a small current of the order of micro 6 Each semiconductor material in a ampere due to 2.
Assuming that the Zener diode turns on, how much is the current that circulates through the load resistance. Select one: A. 10 mA B. 15 mA. C. 19 mA. D. 34 mA.
Electrons in silicon have a mobility of 1000 cm / V - sec. The electric field is applied to make the electrons reach a velocity of 3 x 10 cm / sec. Assume that the mobility is constant and independent of the electric field. What voltage is required to obtain this field in a 5 um thick region? How much time do the electrons need to cross the 5 um thick region?
Determine the reading of the ideal voltmeter connected across a silicon diode shown in figure. 1 k2 D 5 V Assume the forward voltage of diode to be 0.7 V. Find also the current through the diode.
A small concentration of minority carries are injected into a homogeneous semiconductor crystal at one point. An electric field of 10 V/cm is applied across the crystal and this moves the minority carriers by a distance of 1 cm in 20 ms. What will be the mobility of the minority carriers?
In semiconductors the saturation drift velocity of both electrons and holes occur at the same value of an applied electric field. of Select one: O True estion O False
A single phase uncontrolled half wave rectifier with a highly inductive load has an RL load. It has a source of 100V and 3.5A current flowing through the load with an angular frequency of 100rad/s. If it has an extinction angle of 226°. What is the value of the inductance (in millihenry) and resistance?