Q1: Answer the following questions:1) The hexadecimal number 'Al' has the decimal value equivalent to(A) 80(B) 161(С) 100(D) 1012) The output of a logic gate is 0 when all its inputs are logic 1. The logic is either(A) a NAND or an EX-OR(B) an OR or an EX-NOR(C) an AND or an EX-OR(D) an NOR or an EX-NOR3) The Gray code of the Binary number 1100111 is(A) 1011011(B) 1010100(C) 1001001(D) 1011014) When simplified with Boollean Algebra (a+b)(a+c) simplifies to(A) a(B) a+a(b+c)(C) a(1+bc)(D) a+bc5) -31 is represented as a sign Binary number ( using Sign-magnitude form) equal to(A) 00011111(B) 10101001(C) 01110010(D) 001011016) The Binary number 110111 is equivalent to decimal number(A) 25(B) 55(С) 26(D) 347) With 4 bit, what the range of decimal values if the number is 2's complementsigned number.(A) -32 to +31(B) -2 to +1(C) -8 to +7(D) None of thesePage 1 of 38) The number 130 in octal is equivalent to decimal number(A) 96(B) 86(C) 88(D) None of these9) The result of adding hexadecimal number B6 to 3A is(A) DO(B) FF(С) ЕО(D) None of these10) In a 4-variable Karnaugh map, a 2-variable product term is produced by(a) a 2-cell group of 1s(b) an 8-cell group of 1s(c) a 4-cell group of Is(d) a 4-cell group of OsQ2: Answer Two only:A) Simplify the circuit in Figure (1) as much as possible, and verify that the simplified

1) option B is correct. The detailed solution is provided below.

Answered: Q1: Answer the following questions: 1)…

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter22: Sequence Control

Section: Chapter Questions

Problem 6SQ: Draw a symbol for a solid-state logic element AND.

See similar textbooks

Similar questions

(c) Figure Q3(c)(i) shows a register and Figure Q3(c)(ii) shows the input waveforms (CLOCK and Data in) to the circuit. A1 A9 A10 A2 Function generator A3 A11 A12 AS A13 A6 A14 A7 A15 Data in Bop.7) ip.r 82p.7) Logic analyser U1 U2 U3 U4 UO 6. 1. 6 1 6 INVERTER 3 CLK 3 CLK oCLK CLK 5 K K 5 K K 4027 Clock Function generator Figure Q3(c)(i) (i) Determine the type of register as shown in Figure Q3(c)(i).
Perform floating point binary addition to the following: A: 1 10000011 10110111010000000000000 B: 0 10000000 10010011000100101000000 The result of A+B must be in be in 32-bit floating point. You can also check the answer in decimal.
Question1: Read the following table, and design a logic circuit that can convert the binary code from 2421 to Excess-3. Four Different Binary Codes for the Decimal Digits Decimal ВCD 8421 Digit 2421 Excess-3 8, 4, –2, –1 0000 0000 0011 0000 1 0001 0001 0100 0111 0010 0010 0101 0110 3 0011 0011 0110 0101 4 0100 0100 0111 0100 5 0101 1011 1000 1011 0110 1100 1001 1010 7 0111 1101 1010 1001 8 1000 1110 1011 1000 1001 1111 1100 1111 1010 0101 0000 0001 Unused 1011 0110 0001 0010 bit 1100 0111 0010 0011 combi- 1101 1000 1101 1100 nations 1110 1001 1110 1101 1111 1010 1111 1110
Design a combinational circuit with 3-inputs and 1-output. The output is equal to logic-1 when the binary value of the input is less than 3. And the output is logic-0 otherwise.
Design the following combinational logic circuit with a four-bit input and a three-bit output. The input represents two unsigned 2-bit numbers: A1 A0 and B1 B0. The output C2 C1.C0 is the result of the integer binary division A1 A0/B1 B0 rounded down to three bits. The 3-bit output has a 2-bit unsigned whole part C2 C1 and a fraction part CO. The weight of the fraction bit CO is 21. Note the quotient should be rounded down, i.e. the division 01/11 should give the outputs 00.0 (1/3 rounded down to 0) not 00.1 (1/3 rounded up to 0.5). A result of infinity should be represented as 11.1. A minimal logic implementation is not required. (Hint: start by producing a truth table of your design).
T: Answer thne f. questions: 1) The hexadecimal number ´Al' has the decimal value equivalent to (A) 80 (B) 161 (C) 100 (D) 101 2) The output of a logic gate is 0 when all its inputs are logic 1. The logic is either (A) a NAND or an EX-OR (B) an OR or an EX-NOR (C) an AND or an EX-OR (D) an NOR or an EX-NOR 3) The Gray code of the Binary number 1100111 is (A) 1011011 (B) 1010100 (C) 1001001 (D) 101101 4) When simplified with Boollean Algebra (a+b)(a+c) simplifies to (A) a (B) a+a(b+c) (C) a(1+bc) (D) a+bc 5) -31 is represented as a sign Binary number ( using Sign-magnitude form ) equal to (A) 00011111 (B) 10101001 (C) 01110010 (D) 00101101 6) The Binary number 110111 is equivalent to decimal number (A) 25 (B) 55 (C) 26 (D) 34 7) With 4 bit, what the range of decimal values if the number is 2's complement signed number. (A) -32 to +31 (B) -2 to +1 (C) -8 to +7 (D) None of these
Design a 5 bits input logic circuit that can be output F to go active (High) under the following conditions: - All inputs are logic 1" - An odd number of inputs are logic 1" - Non of the inputs are logic 1"
Design a logic diagram to display a digit 5 using 7-segment display
ehcu.org/pluginfile 100% 10 / 11 locations, count how many times is 0 and how many times 1 is. Questions:- 1- Write a program in assembly language to perform the following logic ci BL CL DL [5100]- 2- How we can perform the NEG and NOT instructions by using different instructions. 3- Write the following program by using different instruction or instructions for each instruction on the program. MOV AL , 00 MOV BX , FFFF XOR CL , FF NEG BYTE PTR [DI] AND CX , LG
The numbers from 0-9 and a no characters is the Basic 1 digit seven segment display * .can show False True In a (CA) method of 7 segments, the anodes of all the LED segments are * "connected to the logic "O False True Some times may run out of pins on your Arduino board and need to not extend it * .with shift registers True False
4. a. Design a Combinational circuit with three inputs, (A, B, and C) and four outputs, (U, V, W, and X) with the 2- i/p NOR gate only for the following logic. When the decimal value of the input is 4, 5, 6, or 7 the binary output is one less than the input (input-1). When the decimal value of input is 0, 1, 2, or 3, the output is two greater than (input +2) the input. b. A majority circuit is a combinational circuit whose output is equal to 1 if the input variables have more no. of 1's than 0's. The output is 0 otherwise. Design Using Boolean laws, three input Majority circuits with P, Q, and R as input, output Function T and its complement, Prove.
Basic Combinational Logic Circuits 2. Write the output expression for logic circuit: A B B X

SEE MORE QUESTIONS

Recommended textbooks for you

Electric Motor Control

Electrical Engineering

ISBN:

9781133702818

Author:

Herman

Publisher:

CENGAGE L

Electric Motor Control

Electrical Engineering

ISBN:

9781133702818

Author:

Herman

Publisher:

CENGAGE L

SEE MORE TEXTBOOKS