Answered: On my lab, involving extraction, it…

On my lab, involving extraction, it says “wash the organic layer with 1.0 mL of 1 M aqueous sodium bicarbonate” what does that mean exactly? Thanks!

Chemistry In Focus

7th Edition

ISBN:9781337399692

Author:Tro, Nivaldo J.

Publisher:Tro, Nivaldo J.

Chapter15: The Chemistry Of Household Products

Section: Chapter Questions

Problem 19E

See similar textbooks

Related questions

Q: Indicate the proper sequence of steps required to prepare a buret for use in this experiment. It may…

A: The steps of the preparation given are,

Q: Give at least three characteristics of chloroform that make it a good extracting solvent for the…

A: In nature alkaloids are found either as acidic salts or free bases.

Q: D- How many extractions of 20 ml portions of DCM are needed to extract 96% of caffeine from 200 ml…

A: The relation between the partition ratio and amount left after n-number of extractions is shown…

Q: 1. We used tab water to extract caffeine from tea instead of using distilled water. How does it…

A: “Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: how would you prepare 25mL of a 15% dye solution beginning with a 20% stock dye solution? find mL of…

Q: After the drying step (with sodium sulfate), there was still water in the solution. What should the…

A: Topic : use of drying agent (Ex - Sodium Sulfate)

Q: Why do you think there is a need to soak the crucible with 10% nitric acid? Why do you think the…

A: An acid is a substance that can play a role in increasing the hydrogen ion (H+) concentration in an…

Q: In the esterification experiment, the organic phase of diethyl ether is washed with 2 portions of 5%…

A: When carboxylic acid (R-COOH) and alcohol (R-OH) reacts with each other, the production of ester…

Q: If you are performing a solvent extraction using 1M HCl (Density slightly > 1.00 g/mL) and diethyl…

Q: Consider a mixture containing 0.5 g of benzil and 0.05 g of benzoin. Your task is to isolate benzil…

A: A mixture of benzil and benzoin are given. a) Isolation of both these compounds is not possible by…

Q: Explain exactly what you would do when performing the following laboratoryinstructions; that is,…

A: To Find: To explain what you would do when performing the given instruction.

Q: After dissolving our impure naphthalene in Methanol, the solution looks red. What could have…

Q: Can you recrystallize these two components with 95% ethanol? Is it possible? If so, make a flow…

A: A question based on introduction to organic chemistry that is to be accomplished.

Q: Please help me answer this. In a test tube, 5 mL of cooking oil and 5 mL of detergent solution were…

A: Since you posted multiple questions as per guidelines we will solve only the first question for you.…

Q: How would you make 500.0 mL of a version of Coomassie Blue stain for gels? Its composition is the…

A: We need to prepare 500 mL of a version of Coomassie Blue stain for gels, The (w/v%) for Coomassie…

Q: While recrystallizing, what should you do if you have solid particles that don’t dissolve even after…

A: Recrystallization is the process by which non volatile organic solids are purified. In this method…

Q: Observations on the reaction of test samples with NaOH. Sample Observations +/- Acetamide Benzamide

A: Amides are condensation products of carboxylic acids and ammonia or its derivatives.

Q: Assuming 2-naphtholc acid (from Question # 12) is a solid, how can you check that it is pure after…

A: The impure substance is a mixture. To check the purity of the whether after being separated is done…

Q: look for at least three extraction methods for perfumery materials.

A: There are several methods which are used for extraction of the perfumery materials from different…

Q: To purify benzil crystals and get rid of any leftover traces of benzoin, what would be the best…

Q: Assume there is confusion as to the nature of a liquid that is being distilled off from 1,4…

Q: Can you show me how to solve this Experiment 3: Wet granulation Rx Calcium carbonate 135 mg Sig.…

A: To enlarge the formulation to make 5 tablets.

Q: If 15 mL of dichloromethane was used at one time for extraction, will the amount of the substance…

Q: Murexide

A: Although caffeine present in natural organic matter is less soluble in polar solvents such as water…

Q: 1.So if you were trying to extract 15mL of an aqueous layer, why wouldn’t you want to use 45mL of…

A: A question based on analytical separations that is to be accomplished.

Q: If we are extracting 7 mg of caffeine using 8 ml dichloromethane . Does it make a difference using…

A: The question is based on the concept of solvent extraction. it is an experimental technique of…

Q: A. Test for Unsaturation To 3 drops of toluene add 3 to 4 drops of 1% potassium permanganate…

Q: You are performing an aqueous extraction, and you forget which layer is the organic layer and which…

A: An addition of Na2SO4 will decrease the solubility of organic compounds in water, thus forcing the…

Q: Given 60.00 g of the compound in 60.00 mL water. Calculate amount extracted using multiple (2 x…

A: Concept- In a multiple extraction procedure, a quantity of solvent is used to extract one layer…

Q: How many mL of resorcinol monoacetate should be used to prepare 1 pint of 15% (v/v) lotion?

A: Given, The volume of resorcinol monoacetate should be used to prepare 1 pint of 15% (v/v) lotion…

Q: what compound would contaminate your product if you forgot to add sodium sulfate before running your…

A: The acid catalyzed dehydration of secondary (or tertiary) alcohol follows E1 mechanism. This is…

Q: Draw an extraction flow chart for the extraction of a mixture of organic acid and phenol.

A: In this question we have been provided with a mixture of Organic acid and phenol, now we need to…

Q: Solubility of Amines in Acid Put 2 ml of water in a 10x75-mm test tube. Add 5 to 10 drops of…

A: Upon addition of acids the aniline forms the ionic compounds and becomes soluble in water but upon…

Q: Your HRP sample had a concentration of 2.0 mg/mL and you added 10 uL to a tube containing 10 uL of…

A: Concentration of HRP sample = 2.0 mg/mL

Q: What is the reason for using as little ethanol as possible to dissolve the crude product (aspirin)…

A: Recrystallization is a process which is used to purify the compounds. The principle behind…

Q: Which of these can be rinsed down the sink? the left over liquid from a distillation of 1-butanol…

A: The correct answer is Option (4) None of them should go down the sink.

Q: What is the purpose of washing the crude product with petroleum ether before filtration?

Q: You have 100 mL of solvent available to do an extraction. Which will give a better separation? O A.…

Q: 2. Is it possible to purify a compound by recrystallization using a mixture of solvents? Why or why…

Q: Why is it required to add drying agent like sodium sulphate to the organic layer which may contain…

A: In an organic solution, there are often traces of water present because water is slightly soluble in…

Q: Using the table on slide 7, what ORGANIC solvent could you use to do an extraction of something from…

A: Since you have posted multiple questions, we will answer the first one for you. To get the remaining…

Q: (extraction, reactive extraction, recrystallization). Write a few sentences for each technique…

A: Please find your solution below : Isolation of organic compound is a process in which individual…

Q: You have 100 mL of solvent available to do an extraction. Which will give a better separation? a. 1…

A: The solvent extraction is more effective when the extraction is repeated with small amounts of…

Q: Which of these can be rinsed down the sink? the left over liquid from a distillation of 1-butanol…

A: The process of separation of two compounds on the basis of differences in their boiling point is…

Q: Explain exactly how you would perform the following laboratory instructions; that is, write a short…

A: The separation of two immiscible substance is termed as extraction and thus the extraction of two…

Q: In the aspirin synthesis experiment, what is the reason for using as little ethanol as possible to…

A: We have to see some condition before we recrystallize our compound like,. The solvent should not…

Q: Write an equation to show how you could recover the parent compounds from their respective salts (1,…

A: Given salts,

Concept explainers

Micelles and Biological Membrane

Micelles are the type of lipid molecules that organize themselves in spherical shape in aqueous solutions. The production of the micelle is a reply to the amphipathic behavior of fatty acids. It means that they consist of both hydrophobic regions and hydrophilic regions. In micelles, polar head groups (hydrophilic groups) produce an outer layer associated with water whereas nonpolar tails (hydrophobic groups) are organized in the interior.

Question

On my lab, involving extraction, it says “wash the organic layer with 1.0 mL of 1 M aqueous sodium bicarbonate”

what does that mean exactly?

Thanks!

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

Hi, can somebody help me please to answer this question. Write a detailed procedure on how to recrystallize benzoic acid contaminated with both a little salt and a sand from water. Thank you!
How do you separate sodium hydroxide from the crude mixture?
Please help me answer this. In a test tube, 5 mL of cooking oil and 5 mL of detergent solution were added and shaken.The two did not mix. Explain 3 properties on the cleansing action of soap/detergents.
4. What is the purpose of the methanol and acetone washes?
Indicate the proper sequence of steps required to prepare a buret for use in this experiment. It may be helpful to refer to the lab manual for the LLT experiment. • Step 1: Wash with soap and water. • Step 2: Rinse with distilled water. Step 3: [ Select] • Step 4: [ Select] Step 5: [ Select] [Select] Fill with NaOH solution. Remove bubbles from tip. Rinse with a small volume of NaOH. > > >
Please help me answer this. In a test tube, 5 mL of cooking oil and 5 mL of detergent solution were added and shaken. What will be the result? Explain 3 properties on the cleansing action of soap/detergents.
How does the analyzed vinegar sample conform with the FDA standards?
you weigh your crude sample (1.538 g) and recrystallize with hot isopropanol. How do you know how much isopropanol to add?
Table 1. Emulsion Formation Emulsion has formed (Yes or No) NO es 1. From the results in Table 1, can you say that the soap is an emulsifying agent, a substance able to cause nonpolar and polar substances to mix? How did you reach your conclusion? Fron Sample Water Water plus oil Water plus oil plus soap Hydrophilic head LAB WORKSHEET- Experiment 11 Ester Hydrolysis and Soap Making Na 0. No. of Layers Cloudy or Clear Clear Clear cloudy 2 2 water is t 2. The products of the saponification reaction you performed were fatty acid sodium salts and glycerol. Shown below is a long chain fatty acid sodium salt. The molecule is amphiphilic because it has a polar end (hydrophilic head) and a nonpolar portion (hydrophobic tail). HO Hydrophobic tail is able a) What part of the molecule interacts with water? Polar bond interacts w/water CH3 b) Which part of the molecule interacts with a nonpolar substance like grease? nonpolar interacts w/ grease 32
During the lab procedure a filtered pipette was used to measure out 1.0 mL of the saturated salicylic acid solution. The filter had a bit of cotton on the tip. What component of the mixture was being filtered out?
write an equation for this lab and explain the observations that would occur: measure out 10 mL portion of 10% sodium sulphate into a clean test tube. Add 8 drops of 50% sulphuric acid and swirl. Count the number of drops (swirl after each drop) of 30% calcium chloride needed to produce a precipitate of calcium suplhate.
Show the complete solution.