Indicate the proper sequence of steps required to prepare a buret for use in this experiment. It may behelpful to refer to the lab manual for the LLT experiment.• Step 1: Wash with soap and water.• Step 2: Rinse with distilled water.Step 3: [ Select]• Step 4: [ Select]Step 5: [ Select][Select]Fill with NaOH solution.Remove bubbles from tip.Rinse with a small volume of NaOH.> > >

The steps of the preparation given are,

Answered: Indicate the proper sequence of steps…

Chemistry: The Molecular Science

5th Edition

ISBN:9781285199047

Author:John W. Moore, Conrad L. Stanitski

Publisher:John W. Moore, Conrad L. Stanitski

Chapter13: The Chemistry Of Solutes And Solutions

Section: Chapter Questions

Problem 89QRT

See similar textbooks

Similar questions

1. Describe the cleansing action of soap and detergent.
explain the mechanism of cleansing action of soap.
Please don't provide hand writtin solution..... I need Explation solution and step solution...
no need for solution.
Hi! Please provide a complete and neat solution. Thank you!
During the lab procedure a filtered pipette was used to measure out 1.0 mL of the saturated salicylic acid solution. The filter had a bit of cotton on the tip. What component of the mixture was being filtered out?
1. Solubility Test Table 1. Results for the solubility test. OBSERVATION* INFERENCE SAMPLE Ethyl acetate ** Нехаne Methanol Water Coconut oil Vitamin E Beef fat Miscible (soluble) or immiscible (insoluble) ** polar or nonpolar Sudan IV Test Table 2. Results for Sudan IV test. OBSERVATION* INFERENCE SAMPLE Нехаne Ethyl acetate Methanol Water ** Coconut oil Vitamin E Beef fat Homogeneous or heterogeneous mixture ** polar or nonpolar
Please help me answer this. In a test tube, 5 mL of cooking oil and 5 mL of detergent solution were added and shaken.The two did not mix. Explain 3 properties on the cleansing action of soap/detergents.
Procedure A: Molarity (M=g/MM/L) Step 1. Place one-eighth of a teaspoon (this weighs approximately 0.5 grams) of NaCl (table salt) in the graduated cylinder provided. Then add distilled water to that graduated cylinder until the level of the water reaches 45.00 mL. Mix thoroughly about 1 minute. Pour solution into a somewhat clear cup. Remember what this looks like for Procedure B. Questions: Is this a saturated solution? Why or why not? Take a picture and insert a picture (compress your image) of your solution here. Save this solution for Step 2. Calculations: Determine the Molarity of this solution using the formula M = g/MM/L. You know the grams (one-eighth of a teaspoon weighs approximately 0.5 grams), look up the Molar Mass of NaCl, and convert your mL to L to solve the problem.) Show your calculations for Molarity here. C % 31 D < hp & * ✔
PLEASE MAKE THE SOLUTION COMPLETE, UNDERSTANDABLE AND READABLE. Please write the solution in the paper.
1. Obtain a 50-ml burette, 5-mL volumetric pipette and a pipette bulb from the stockroom. Setting up the burette and preparing the NaOH 2. Rinse the inside of the burette with distilled water. Allow the distilled water to drain out through the tip in order to ensure that the tip is also rinsed. 3. Now rinse the burette with a small amount of NaOH (aq). To do this, add about 5-mL of NaOH (aq) to the burette, then twirl the burette on its side (over the sink) to rinse its entire inner surface. Then allow the NaOH (aq) to drain out through the tip. M Burette Pipette 4. Fill the burette with NaOH (aq) up to the top, between 0-mL and 5-ml. Use a funnel to do this carefully, below eye-level, and preferably over the sink. After this you will need to flush the tip of the burette - your instructor will show you how to do this. Now measure the volume at the level of the NaOH precisely, and record it as the "Initial Burette Reading" on your report. Also record the exact molarity of the NaOH (aq),…
Which is not required in recrystallization? a. solution is filtered at high temperature b. moderate volatility solvent c. saturated solution d. solvent must dissolve the impurities

SEE MORE QUESTIONS

Recommended textbooks for you

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

Chemistry: The Molecular Science

Chemistry

ISBN:

9781285199047

Author:

John W. Moore, Conrad L. Stanitski

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS