Oil of SG = 0.87 and a kinematic viscosity v = μ/p = 2.2 x 10-4 m²/s flows through the vertical pipe shown below at a rate of Q = 4 x 10-4 m3/s. a)Determine the manometer reading, h. b)If the flow is up rather than down the pipe, determine the manometer reading, h. c)What flowrate (magnitude Q and direction) will cause h = 0? SG=0.87 4 m 20 mm SG= 1.3

Oil of SG = 0.87 and a kinematic viscosity v = μ/p = 2.2 x 10-4 m²/s flows through the vertical pipe shown below at a rate of Q = 4 x 10-4 m3/s. a)Determine the manometer reading, h. b)If the flow is up rather than down the pipe, determine the manometer reading, h. c)What flowrate (magnitude Q and direction) will cause h = 0? SG=0.87 4 m 20 mm SG= 1.3

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

At one point in a pipeline the water's speed is 3.00 m/sand the gauge pressure is 5.00×10^4 Pa a) Find the gauge pressure at a second point in the line, 11.0 mm lower than the first, if the pipe diameter at the second point is twice that at the first. Express your answer in kilopascals.
Inlet and throat diameters of a horizontal venturimeter are 280 mm and 100 mm respectively. The liquid flowing through the venturimeter is water. Pressure intensity at inlet is 15 N/cm2, while pressure at throat is 50 kPa. Find flow rate of water in lit/min, assuming Cd is 0.7 and also draw the neat sketch. i) Actual flow rate = _______________________ lit/min.
Q.2 Among two horizontal parallel plate 10mm apart one plate is moving horizontal and other stationary at 1 m/s. If the pressure difference will be from the section to section 100 mm apart as 98.1kpa and dynamic viscosity of the fluid μ = 0.1. Determine U=1m/s A. The shear stress on the top of the plate. B. The velocity distribution and discharge. C. Maximum and mean speed. 10 mm $ 100 mm Y
A sealed tank filled with a fluid which is maintained at 0.35 bar gauge and 20 0C. The fluid discharges to the atmosphere (1.013bar) through a small opening at the side of the tank (z1 = z2 ). a) Calculate the velocity of fluid leaving the tank; assume the flow to be compressible and the process to be frictionless adiabatic.b) Calculate the velocity of fluid leaving the tank if the flow is incompressible and the process to be frictionless.c) Compare the calculated velocities and comment on the result. Take for fluid,α=1.0P=kρɤ ɤ =1.4R=287 J/kg.KMach number<0.3, incompressible flow. (Fluid Mechanics Question) (Please solve step by step)
1. A pressure gauge attached to a pipe is reading 1.34 m of Hg at a place where the atmospheric pressure is 10.33 m of water. The approximate absolute pressure at the mountain isa. 930 kPab. 181 kPac. 280 kPad. 100 kPa 2. The flow is said to be unsteady and non-uniform when,a. The flow velocity is not changing with time but changing with spaceb. The flow velocity is changing with both time and spacec. The flow velocity is changing with time but not changing with spaced. The flow velocity is not changing with both time and space 3. The below figure shows a pipe with a circular cross section of diameter D mm on the left end and a square cross section with side D mm on the right end. Mercury enters the left end with a velocity 1 cm/s and leaves the right end with a velocity V2. Find V2 (neglect losses in the pipe).a. Cannot be find since length is not givenb. Cannot be find since diameter is not givenc. 7.85 mm/sd. 12.73 mm/s 4. 1 kg water is flowing through an inclined pipe at…
In shut off valve experiment, the 3/ 6th of valve position, the discharge is found as of 6 lit/s for the 27mm diameter pipe. Find the velocity and Reynolds number of the flow. Take the viscosity of water as 1.14x10 Ns/m?. (Enter only the value in the box by considering the unit given in bracket. Do not write the unit in the boxes) Velocity of water (unit in mm/s) = Reynold's number
Ql:- A 80 mm diameter of pipes and 300 mm long slides by its own weight of 1.7 kN inside a large cylinder of 80.2 diameter. The clearance between the eylinder and pipe is filled with oil of 5 stokes viscosity and s.g 0.92, find the velocity of sliding the pipe.
1.3 A pipe discharges 142 lps of water into a reservoir at a point 1.85 m below the water surface. At point A the diameter is 25.4 cm and the center of the pipe is 1.25 m above the water surface. At the discharge end the pipe is 30.5 cm. If the head loss from A to the reservoir is 0.7 m, determine the pressure in A. 1.4 The absolute viscosity of a fluid at atmospheric conditions is 8 x 10-3 kgf-s/m2. Find this viscosity in: a) Reyn; b) Poise; c) lbf-s/ft2; d) Pa-s.
A 300 mm x 150 mm venturimeter is provided in a vertical pipeline carrying oil of specific gravity 0.9, flow being upward. The difference in elevation of the throat section and entrance section of the venturimeter is 300 mm. The differential U-tube mercury manometer shows a gauge deflection of 250 mm. Calculate: b) 9 The discharge of oil, and i) ii) The pressure difference between the entrance section and the throat section. Take Cd=0.98 and specific gravity of mercury as 13.6.
A 300 mm x 150 mm venturimeter is provided in a vertical pipeline carrying oil of specific gravity 0.9, flowing upward. The difference in elevation of the throat section and entrance section of the venturimeter is 300 mm. The differential U – tube manometer shows a gauge deflection of 250 mm.Calculate i) The discharge of oil ii) The pressure difference between entrance and Throat section. Take : coefficient of discharge of venturimeter is 0.98
Q3/ Water flows in Venture meter as shown in Fig. No. (5). Coefficient of velocity is (0.96) and coefficient of contraction is (0.62). If a= 0.6 (m), b=1.2 (m), d1= 0.8 (m) and d2= 0.2 (m). Find Q and v of water flowing through the throat d1 d2 C.L- Hg Fig. 5
1. Solve the following and draw the figures Í. A 30 cm x 15 cm venturimeter is inserted in a vertical pipe carrying water, flowing in the upward direction. A differential mercury manometer connected to the inlet and throat gives a reading of 30 cm. Find the [Ans. 154.02 lit/s] ii. If in the problem 13, instead of water, oil of sp. gr. 0.8 is flowing through the venturimeter, determine the [Ans. 173.56 lit/s] III. The water is flowing through a pipe of diameter 30 cm. The pipe is inclined and a venturimeter is inserted in the pipe. The diameter of venturimeter at throat is 15 cm. The difference of pressure between the inlet and throat of the venturimeter is measured by a liquid of sp. gr. 0.8 in an inverted U-tube which gives a reading of 40 cm. The loss of head between the inlet and throat is 0.3 times the kinetic head of the pipe. [Ans. 22.64 lit./s] discharge. Take Ca = 0.98. rate of flow of oil in litres/s. Find the discharge.