Answered: List as many experimental as you can it…

Science

Chemistry

List as many experimental as you can it may be used to determine KSP for sparingly so you both salt.

Chemistry: Matter and Change

1st Edition

ISBN:9780078746376

Author:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Publisher:Dinah Zike, Laurel Dingrando, Nicholas Hainen, Cheryl Wistrom

Chapter10: The Mole

Section10.5: Formulas Of Hydrates

Problem 82SSC

See similar textbooks

Related questions

Q: A Nickel bis-dimethylglyoximate complex was deposited with a weight of (2.721g) with the filter…

A: Nickel bis-dimethylglyoximate has a chemical formula of Ni[ONC(CH3)C(CH3)NOH]2 that is formed from…

Q: How to get g31 value? (216,10,5) Show using equation and all derivation

Q: Calculate the value of ΔGo at 5.9oC for the dissolution of an ionic solid with a Ksp of 2.5 x…

A: Conversion of ˚C to K: 0°C=273.15 K5.9°C=5.9+273.15=279.05 K

Q: When methanol is dissolved n water a conducting solution results. Justify your answer.

A: Ionic substances dissolve in water and conduct electricity due to freedom of motion of ions.

Q: From the general balance equation, write the balance expression for a continuous system, at ste…

A: Continuous systems are those types of systems in which the outlet and inlet signals are same at…

Q: Why must the instrument readout for an unknown fall within the range of of readouts for a series of…

A: Serial dilutions are a set series of dilutions, with a constant dilution factor. Standard curve or…

Q: type sensor includes SnO2 layer which changes its resistance with respect to reducing gas…

A: MOS sensors: They detect concentration of different types of gases by measuring the resistance…

Q: Before the endpoint, the Chloride ion which is in excess adsorbed on the surface of AgCl, imparting…

A: In a precipitation titration, analyte and titrant mixes and form an insoluble precipitate. Based on…

Q: Rf value can be matched with to identify the solute Solvent front Solute itself None O Database

A: Given: Retension factor value(Rf value) To find: Identify the solute. Solution: Rf stands fir…

Q: Why magnetic moment of Fe(II) is higher than Mn(II). Discuss in terms of orbital contribution . (…

Q: How to calculate the determinate? Write at least two methods and discuss by detailed examples.

A: Given How to calculate the determinate? Write at least two methods and discuss by detailed examples.…

Q: to.003,20) 25 KNO3 20 15 к 10 P 0.0005 0.001 0.0015 0.002 0.0025 0.003 0.0035 0.004 1/T (K) 2. The…

A: The given graph is :

Q: Determine AG° at

Q: Washing is a vital step for any gravimetric analysis, list down the basis on for the selection of a…

A: Gravimetric analysis : It is a quantitative analysis technique in analytical chemistry which is used…

Q: mixed in aqueous solution. If no rea sure to include the proper phases for

A: Balanced chemical reaction Li2SO4(aq.) + Ca(NO3)2(aq.) ---> CaSO4(s) + 2LiNO3(aq.) Complete…

Q: A single crystal Ni (in FCC) alloy bar is uniaxially pulled along [-123]. The bar starts to yield at…

Q: 2. Calculate solubility parameter for linear PVC and linear Poly-ethylene using group attraction…

A: The enthalpy change on mixing of a polymer and a solvent, whole volume of the solution, volume…

Q: Mention the optimum conditions required for good performance of: i. Chelating agent in metal…

A: (i)A chelating agent of particular economic significance is ethylenediaminetetraacetic acid (EDTA).…

Q: Solute A has partition coefficient K between benzene and water of 1.8 Le. Ais 1.8 times more soluble…

A: ANSWER : option A is correct answer. 1. 12.2 % 2.…

Q: Can you please indicate the ion flow for the image I posted below

A: Here we are required to find the direction of flow of electron in the electrochemical cell

Q: Describe the mechanisms of strength at the peak hardness of a precipitation hardened alloy when both…

Q: What is a Zimm plot?

Q: Explain the effect of donor concentration (doping level) and temperature on electron mobility in…

A: Please find your solution below : The electron mobility tells that how quickly and electron can move…

Q: In the Mohr Method Determination of Chloride, why must the titration be in neutral condition to be…

Q: spectively. Calculate ressure at 298 K

A: The moles and molarity as, NO=4.4130 =0.147Molarity=0.14710 =0.0147

Q: Calculate the molar concentration of the different colour solutions using the data table. (Available…

A: The experiment is based on the process of osmosis.

Q: How we can use limiting current in eļectroanalytical chemistry?

A: Solution - Electroanalytical method - Electroanalytical methods is type of method in. analytical…

Q: For bulk crystalline sample which technique is best ? Give me handwritten answer with explaination?

Q: Calculate the [Cu2+] and [IO3–] in a solution made by saturating pure water with solid Cu(IO3)2. Use…

Q: For a species that is distributed between an aqueous sample and an organic extraction phase, the…

Q: Problem: Compute for the normality of 27 mL sodium hydroxide used to titrate 6.55 g of potassium…

A: “Since there are multiple questions and it is not mentioned that which one has to be solved so I am…

Q: Need

Q: What is HOMO LUMO and include reference link

A: A question based on molecules that is to be accomplished.

Q: Calculate the ionic strength for a solution that is 0.02497 molar M3X1 (with ions M1+ and X3-).

A: ionic strength = 0.12485 M.

Q: Data Report Sheet: Spectrophotometric Determination of an Equilibrium Constant.

A: Equation obtained from the calibration curve is y = 4339.8x + 0.0258 where y = Absorbnace x =…

Q: Calculate the (Ex/GS) atomic ratio for 3s---3p (oppose) in Mg* at 3000k?

A: Given that For Mg+ Temperature = 3000K Orbital --- 3s - 3p

Q: B alance this reocbion using Simple whole -number Coefficients. What is the cetricient For Ze?

A: Balanced chemical equation

Q: NEED FULLY CORRECT HANDWRITTEN SOLUTION FOR THIS.

A: Given that, an equilibrium reaction is 2CO2(g)↔2CO(g)+O2(g). a. We have…

Q: Underline the organic solvent(s) given that would work for the extraction: dichloromethane-water,…

A: Pair of organic solvents which is suitable for extraction is, in which both solvents are not…

Q: Find the initial solution using Vogel's approximation method. It is necessary to fill all the cells,…

A: Given, For each row find the least value and then the second least value and take the absolute…

Q: The Butler Volmer (BV) rate equation should be introduced in electrochemistry because: The Nernst…

A: Electrochemistry is branch of chemistry in which we deal with both oxidation and reduction reaction…

Q: What is the sign and value of the Nernstian slope for potentiometric analysis of S²- when Ecell is…

A: We knew that nernst equation for half cell reaction. Ecell = E°cell - (2.303RT/nF )logKc

Q: 1. 1/3 of the incident light flux passes through a layer of aqueous solution with a thickness of 4.2…

A: The amount of light that is absorbed by the solution and reflected depends on the concentration of…

Q: To the presence of hexane HBr addition PEROXIDE leads to the output: subject to

A: Markovnikov's rule says that when the addition of unsymmetrical molecules like H2O, HX, HOX, etc. to…

Q: ime of Time at dicator color equivalence point, s ange, s

A: Molecular equation, HCl(aq.) + NH3(aq.) ---> NH4Cl(aq.) Complete ionic equation, H+(aq.) +…

Q: Given the volume of 0.2000 M NAOH used determine the concentration of 10.00 ml sample each from…

A: Given, Volume of NaOH for Aq layer = 12.55 mL Volume of NaOH for Or layer = 15.27 mL Concentration…

Q: Using the Debye-Huckel limiting law equation, Please compute ( not qualitatively) the hydroxide ion…

Q: An aqueous solution of compound X was placed in a cuvette 1 cm thick and its light absorption…

Question

List as many experimental as you can it may be used to determine KSP for sparingly so you both salt.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Introduction

VIEW

Explanation

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

I am allowed to Work with someone but due to covid I have to work virtually and I am lost ....I provided the data that I have to go by Use the graphs in the file to determine the concentration of the unknown solution and to answer the other questions from the lab pack.
In the Mohr Method Determination of Chloride, why must the titration be in neutral condition to be carried out? Determine and provide the side reactions if it is done in basic solution. Also determine if carried out in acidic conditions
can give you give solution with what is given under the problem? thank you. sorry i submitted earlier without photo
ASSume an excesS of of Zn? t Iz fac) +Zn Iz faa) 2.
Give detailed Solution ..no need handwritten answer
What are the applications of re-crystallization in gravimetric analysis? answer at your own words and answer should be to the point, not any irrelevant words
Calculate a the solubility product constant for Ag2CO3 and b the value of Kw using the following data: Ag2CO3(s)+2e2Ag(s)+CO32(aq)E=0.47VAg+(aq)+eAg(s)E=0.7996VO2(g)+2H2O(l)+4e4OH(aq)E=0.401VO2(g)+4H+(aq)+4e2H2O(l)E=1.229V
If You Answer both part I will highly obliged to you Thanks in Advance My Respected Expert sir......
Give detailed Solution of both sub parts..don't give Handwritten answer
!/,$),:):&,&:!,&:$,&!
The concentration of CO in the air can be determined by passing a known volume of air through a tube containing I2O5, resulting in the formation of CO2 and I2. I2 is removed from the tube by distillation and collected in a solution containing excess KI, producing I3-. I3- is titrated with a standard solution of Na2S2O3. A 4.79 L air sample was sampled as described here, requiring 7.17 ml of 0.00329 M Na2S2O3 to reach the endpoint in a typical analysis. If the density of the air is 1.23×10^-3 g/ml, what is the amount of CO in the air in ppm? (CO: 28 g/ml)
Give detailed Solution of all sub parts if you not then don't give answer..I will give you upvote....