Let's assume that 5.6 g of crude product was isolated, and 4.19 g of pure product was collected after recrystilization 8. Let's assume that the melting point of the recrystallized product was 104-108°C. What conclusions can you draw? Provide a brief discussion of these results.

Let's assume that 5.6 g of crude product was isolated, and 4.19 g of pure product was collected after recrystilization 8. Let's assume that the melting point of the recrystallized product was 104-108°C. What conclusions can you draw? Provide a brief discussion of these results.

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter80: Crystallization: Purification Of Solids

Section: Chapter Questions

Problem 4P

See similar textbooks

Related questions

Q: A 300-mL aqueous solution containing a 30.0g of compound A is to be extracted with ether. The…

A: Ether and water are two immiscible liquids. When together, these form two layers with ether on top…

Q: Which method would be most appropriate for accomplishing the removale of trace amounts of acetic…

A: Answer

Q: Why should the recrystallization solvent have a fairly low boiling point?

Q: 4. Why is important to allow the saturated solution to cool down slowly during the…

A: Recrystallization is purification method. Solid substances are purified using Recrystallization…

Q: Unknown X mixed in a 50/50 ratio with acetaminophen yielded a melting range of 154-162°C · -…

Q: particular extraction proceeds with a distribution coefficient of 6. The system consists of 3.5 g of…

A: Fraction extracted and fraction remains in aqueous layer formula is W1= W0 × (V1/KpV2+V1)^n W0=…

Q: . In the solution step, an unnecessarily large volume of solvent is used. i. Effect on…

A: Recrystallization is the purification technique. In this technique, the hot solvent is used to…

Q: Consider a mixture containing 0.5 g of benzil and 0.05 g of benzoin. Your task is to isolate benzil…

A: A mixture of benzil and benzoin are given. a) Isolation of both these compounds is not possible by…

Q: Suppose we start with 3.0g of contaminated benzoic acid. After recrystallisation we end up with 2.3g…

A: Given Mass of contaminated benzoic acid = 3.0 g Mass of pure benzoic acid = 2.3g

Q: Which of the following would LOWER the purity of the distillate collected from the rubbing alcohol…

Q: Can you recrystallize these two components with 95% ethanol? Is it possible? If so, make a flow…

A: A question based on introduction to organic chemistry that is to be accomplished.

Q: LNH2 You have access to the following solutions for your experiment: 1 M NaOH 1 M HCI 1 M CH3COOH 1…

A: We would use liquid Liquid Extraction for the separation of following substances and acid base…

Q: Explain what will happen to the (i) yield and (ii) purity, of aspirin if the following steps were…

A: Modification in Step Yield Explanation Opting to filter the recrystallized product using only…

Q: Both the physical properties of the API and the excipients are essential to ensure that the…

A: According to Q&A guidelines of Bartleby, we are supposed to answer only one question out of…

Q: Why is methanol chosen as the solvent for recrystallization? What would happen if the student uses…

A: Most of the organic compound is dissolved in alcohol like methanol and ethanol . methanol is easy to…

Q: After a crude product is dissolved in 1.5 mL of hot solvent, the resulting solution is dark brown.…

A: Activated charcoal can be extracted colored impurities from the solution. But the quantity to be…

Q: It is tempting to maximize the amount of product isolated by continuing the fractional distillation…

A: The solution is given below -

Q: What is the reason for using as little ethanol as possible to dissolve the crude product before…

A: For recrystallization, it is recommended to use minimum solvent to support the goal of recovering…

Q: How can a fractionating column be prepared from a standard distillation column? Select one: Pack…

A: The fractionating column is fitted above the distillation flask containing the mixture of liquids to…

Q: Why is the washing of crystals on the filter paper not as effective a process of purification as…

A: Since there are multiple questions, we will answer only the first one. If you require the answers to…

Q: Discuss what this data indicates about the polarity of Methyl-4-Aminobenzoate

A: Since you have asked multiple questions, we will solve first one for you. For remaining question,…

Q: Briefly discuss how to identify the unknown compound by using mixed melting point method.

A: Mixed melting point calculation is a method for the determination of the identity of the unknown…

Q: Suggest methods (aside from recrystallization) that can increase the purity of aspirin in the final…

A: The question is based on the concept of qualitative aspects of the experimental chemistry. we have…

Q: What would happen if the Erlenmeyer flask containing the crude dba in EtOH undergoing…

A: As we know during recrystallisation we dissolve our product into suitable solvent such as here, dba…

Q: 4. What is the purpose of changing the eluting solvent from pentane to ether between the two…

A: "Since there are multiple questions and it is not mentioned that which one has to be solved so I am…

Q: Based on your results, how does rate of crystal growth effect the purity of a recrystallized…

A: When the crystals of any compound are impure due to any reason. They can be recrystallized by the…

Q: Would an organic liquid with a density of 1.006 g/mL make a good extraction solvent? Explain.

A: Density is very important characteristic to keep in mind while choosing the solvent for extraction…

Q: Outline three differences in the experimental set up between fractional distillation and steam…

A: Steam and Fractional distillation have different their principal and boiling point

Q: WHAT FACTORS CAN AFFECT THE YIELD OF BENZOIN CONDENSATION?

A: The solution is shown below.

Q: (i) Name any fraction, which is obtained higher up the distillation column than gas oil, and give…

A: The answer is attached-:

Q: 6.0 mL of cyclohexanol, 8 mL of 85% phosphoric acid, and 10 drops of sulfuric acid are added to a…

A: The percentage yield can be calculated by the formula = Actual yield x 100 /theoretical yield

Q: Nitroethylene, H,C-CHNO, is a sensitive compound that must be prepared with great care. Atempted…

Q: What is the purpose of including a melting point in a procedure? A) As a method of purification - We…

A: Answer (A) Option is correct.

Q: Assume that you are provided with an 18 cm fractionating column having an HETP of 6 cm to distill a…

A: To determine the composition of first drop of distillate

Q: What is the reason for using as little ethanol as possible to dissolve the crude product (aspirin)…

A: Recrystallization is a process which is used to purify the compounds. The principle behind…

Q: propose experimental design on the separation of components of the mixture of benzoic acid and…

Q: What is the purpose of washing the crude product with petroleum ether before filtration?

Q: Why is it required to add drying agent like sodium sulphate to the organic layer which may contain…

A: In an organic solution, there are often traces of water present because water is slightly soluble in…

Q: A crude nonacidic product mixture dissolved in diethyl ether contains acetic acid. Describe an…

A: We have a crude non acidic product mixture dissolved in diethyl ether contains acetic acid. We have…

Q: Draw a five-step Schematic diagram of the procedure on how to separate pure crystals of CuSO4 , Alum…

A: Answer - CuSO4 - Copper(II) sulfate, also known as copper sulphate, are the inorganic compounds…

Q: Why is it dangerous to attempt a distillation in a completely closed system

A: Distillation : a process of separating mixture of compounds based on difference in their boiling…

Q: Under what conditions can a good separation be achieved with a simple distillation?

A: Simple distillation is a method of separating two compounds from a mixture on the basis of their…

Q: What process is required to purify the ethanol from the fermented broth? Extraction Distillation…

Q: Write all the steps of recrystallization of impure naphthalene from methanol. How to identify the…

A: In this question, we have to find out the correct answer of given problem by the help of…

Q: What is the purpose of testing distilled water and laboratory ethanol in the testing of ethanol?…

Q: 1. What can you conclude if your dry aspirin sample has a lower melting point than the literature…

A: We’ll answer the first question since the exact one wasn’t specified. Please submit a new question…

Q: Compare simple and fractional distillation for the separation of HEXANE and TOLUENE

Q: A fractional distillation of this mixture is carried out: what is the nature of the recovered…

A: Total mass of sample = 80 g Mass of water = 60 g Mass of nitric acid = 80-60 = 20 g number of moles…

Question

Let's assume that 5.6 g of crude product was isolated, and 4.19 g of pure product was collected after recrystilization 8. Let's assume that the melting point of the recrystallized product was 104-108°C. What conclusions can you draw? Provide a brief discussion of these results.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Sample Preparation in Analytical Chemistry

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, chemistry and related others by exploring similar questions and additional content below.

Similar questions

The reaction starts with 0.75 g of piperonal and generates 1.08 g of a solid Recrystallization of this crude product from acetic acid afforded 0.75 g of pure bromopiperonal. Based on this information calculate and report in the appropriate spaces below A) the crude yield, B) the percent recovery from recrystallization, and C) the total yield for the reaction. NOTE: Report all yields as whole numbers. mal prad 7.5 points crude wield = 0.00 (Please type answer no write by hend)
2) What’s the principle of extraction and recrystallization ? 2) What’s the best method to separate the compound? Why
TRUE OR FALSE, if false then give the correct word to make the statement true then explain 1. Sublimation occurs when a solid has a relatively high vapor pressure at a temperature [above] its melting point. 2. To isolate the desired chemical, a single extraction is [more efficient] than extracting the compound numerous times. 3. The compounds are separated in liquid-liquid extraction based on their relative solubilities in two [immiscible] liquids.
How do you obtain napthalene,napthol and benzoic acid from a sample using recrystallization?
After a crude product is dissolved in 1.5 mL of hot solvent, the resulting solution is dark brown. Because the pure compound is reported in the literature to be colorless, it is necessary to perform a decolorizing procedure. Should you use pelletized Norit or powdered activated charcoal to decolorize the solution? Explain your answer.
3. Describe the characteristics that a crystal obtained through recrystallization must have, the final crystal, not the solvent.
A mixture of the two compounds shown below is dissolved in ether. Using the information given in the experiment, select all the correct statements regarding the extraction and isolation of the two compounds. lose 0000 X OH A. X can be extracted from the organic layer using sodium hydroxide. B. Y can precipitate out of the aqueous layer by the addition of sodium hydroxide to the salt of Y. C. X can precipitate out of the aqueous layer by the addition of sodium hydroxide to the salt of X. D. Y can be extracted from the organic layer using sodium hydroxide.
How was the precipitate obtained after filtration? By scraping from the filter paper and transferring to a watch glass. By redissolving in hydrochloric acid. By drying the precipitate on the filter paper using a desiccator. By charring the filter paper and igniting the product in a crucible.
During recrystallization, an orange solution of a compound in hot alcohol was treated with activated carbon and then filtered through fluted paper. On cooling, the filtrate gave gray crystals, although the compound was reported to be colorless. Explain why the crystals were gray and describe steps that you would take to obtain a colorless product.
An organic chemistry laboratory Extraction; the extraction of crude naphtalene- benzoic acid mixture. Naphthalene is a suspect carcinogen and is toxic to aquatic life. Find an alternative pair of molecules that adhere better to the principles of green chemistry and can be separated by extraction using green' solvents. (kindly answer fully)
Look up the structures and melting points for acetanilide and salicylic acid.Predict whether the rate of cooling during a recrystallization process will have any effect on thepurity of the crystals formed.
We want to extract terpenoids from an aqueous sample by continuous liquid-liquid extraction. Which of the following solvents is not suitable for this purpose? Why? Propanone (acetone), dichloromethane, heptane.