In each of the following situations, what type of filtration device would youuse? (Do not consider centrifugation when answering this question.)a. Remove powdered decolorizing charcoal from 20 mL of solutionb. Collect crystals obtained from crystallizing a substance from about 1 mL of solutionc. Remove a very small amount of dirt from 1 mL of liquidd. Isolate 0.2 g of crystals from about 5 mL of solution after performing acrystallizatione. Remove dissolved colored impurities from about 3 mL of solutionf. Remove solid impurities from 5 mL of liquid at room temperature

Q: What would likely happen if a hot saturated solution were filtered by vacuum filtration using a…

A:

Q: 5. Why is it important that your glassware be dry for Part 2? Postulate as to what would have…

A: From the reaction equation, we can conclude that there is a equilibrium existing between the…

Q: Which of the satements below is/are limitations of Dumas Method? i. The Ideal condition is just an…

A: In Dumas method we assume that vapour of compound generated by heating the sample in water bath…

Q: d) In a typical HPLC column, 150 atm of pressure is required to push the mobile phase through the…

A: In this question, we have to find out the correct answer of given problem by the help of the concept…

Q: When checking the melting point of your impure sample, what temperature should you set as the…

A: In the event that the inexact temperature at which your sample should melt is known, the sample can…

Q: A student was tasked to recover the crystals after recrystallization. He weighed a piece of filter…

A: Given weight of filter paper before filtration = 0.9843g Weight of Filter paper + sample after…

Q: 5. Discuss how melting points of the impure sample and recrystallized sample could have been used to…

A: Melting point is the temperature at which there is a change from the solid to the liquid state i.e.…

Q: A sample of benzoic acid is contaminated with methyl red, a compound that is soluble in cold water.…

A: Gravity filtration only runs from the help on gravitational force , so no other external stimuli is…

Q: How do you filter benzoic acid in water through the apparatus?

A: The process which is used to purify the impure compound from a solvent is known as recrystallisation…

Q: . In the solution step, an unnecessarily large volume of solvent is used.           i. Effect on…

A: Recrystallization is the purification technique. In this technique, the hot solvent is used to…

Q: 5. Let's say naphthoic acid was isolated by vacuum filtration from our procedure explained in the…

A: Both methods are useful for removing moisture. Vaccum drying is most effective and gentle drying…

Q: Vaccum filtration is the major technique used in this experiment. The following step sequences are…

A: The vacuum filter may be described as the approach which is basically used to disparate the solid…

Q: How is recrystallization of an impure solid accomplished?

A: Recrystallization is a technique used for the purification of a solid from impurities.

Q: Which of the satements below is/are limitations of Dumas Method? i. The Ideal condition is just an…

A:

Q: Sublimation is preferred for small scale purification as compared to crystallization because there…

A:

Q: Why is recrystallization not applicable to samples which contain large amount of impurities?

A:

Q: For full contact with the acid, nitrile gloves with at least 0.4 mm thickness are required. The…

A: In order to protect the hands from the acids, it is given that the thickness of the gloves must be…

Q: You have to make 100mL of 0.05M HCI from a 10M HCI stock solution, but the only measuring devices…

A: Given that,  Molarity of Stock HCl solution M1 = 10 M Molarity of dilute HCl solution,M2  = 0.05 M…

Q: When isolating a solid compound after recrystallization, which is the appropriate technique to use,…

A: Recrystallization is an experimental technique of separating pure compound from the solution…

Q: Why does the separation apparatus must be vented after several inversions? to make the stopcock…

A: The mentioned procedure in the question is commonly used technique during extraction.

Q: What are pipeline slurry systems? How do they function?

A: Slurry is a mixture of solid in a molten state. It is denser than liquid and is mobile. The…

Q: Pipetting is much easier when the top of the pipette and the bulb are: Select one: a. Filled with…

A: Pipette is a laboratory tool commonly used in chemistry

Q: 50 g of salt was dissolved in 250 g of water. Find the mass fraction of salt in the extracted…

A: Mass fraction: It defined as WB = mb/m

Q: Which method would be most appropriate for the purification of an off-color crystalline compound? A.…

A: Introduction: Purification is the process of obtaining pure compounds by removing unwanted…

Q: Discuss why synthetic lubricants is preferred over petroleum-based fluids for specific applications.…

A: There  are many Advantages  of synthetic  lubricants over petroleum  based fluids.

Q: Which of the following devices should be used to heat the distillation flask? a) heating mantle b)…

A: Distillation process involving the conversion of a liquid into vapour that is subsequently condensed…

Q: Measure 0.400 g of KMNO. using a 50-mL beaker as the sample pan. Make sure to press the tare button…

A: Concentration of a solution is the indicator of amount of solute present per fixed amount of solvent…

Q: Q1:What effect would each of the following have on the observed melting point and melting point…

A: a) a thick walled tube may show an increased melting point for your sample.The melting point range…

Q: Give at least five factors to consider when performing chromatography (paper, thin-layer, liquid,…

A: Chromatography is a technique that is used for the separation of components of a mixture.  The…

Q: Examples of this are solid particles and liquid droplets. * vocs SPM НAPS None of the above

A: Correct answer is SPM(suspended particulate matters) An aerosol is a suspension of fine solid…

Q: You have completed your recrystallization process, but you did not get any crystals back after you…

A: Recrystallization is a process which is used to purify the compounds. The principle behind…

Q: What measuring device would you use to measure the volume under each ofthe conditions described…

A: (a) To measure 5 mL solvent for crystallization we can use a measuring cylinder of 5 mL capacity. A…

Q: As part of the discussion, explain your results from Part 2 within the context of Le Châtelier's…

A: The equilibrium system is: [Co(H2O)6]2+(aq)+2 Cl-(aq) ⇌   [CoCl2 (H2O)2 ] (aq) +4 H2O(l)   (pink)…

Q: What type of elution uses different proportions of solvent during separation process?

A: Elution is a process of separating one from a mixture by using eluent or solvent. By solvent…

Q: In liquid, extraction, why is it necessary to turn the separatory funnel upside down and to open the…

A: Liquid-liquid extraction is also called solvent extraction is a method of separating compound from…

Q: a) Compounds with low boiling points tend to spend less time in the gaseous state than compounds…

A: The questions are based on the concept of gas chromatography. it is an instrumental technique of…

Q: 6. The following are disadvantages of using filter paper in gravimetry, which is not included? а.…

A: 6) c is the correct answer.  IN the Gravimetry we uses the ashless filter paper to achieve the…

Q: how to use Gas Chromatography in Cosmetics Provide a procedure on how to do this example that you…

A: Principle of Gas Chromatography :- Gas chromatography differs from other forms of chromatography in…

Q: Which of the three methods, (Use of Separatory Funnel, Decantation or Use of Pasteur Pipette) do you…

A: Given : Separators funnel, Decantation or use of Pasteur pipette.  Transferring large volumes of…

Q: Why should the washing solvent be cold in the suction filtration step?

A: Suction filtration is the final step for separating the compound from the solution during the…

Q: Which is the most appropriate way to dispense liquid using a dropper (vertical, 45° angle, or…

A: Dropper is a device used to transfer small quantities of liquids.

Q: A piece of filter paper is placed in the TLC developing chamber to: Choose one: provide a lining…

A: The correct option is (c) It is because filter paper in used in developing chamber  as it absorbs…

Q: What might happen to your melting points if you do not cool the MelTemp between runs? The melting…

A: The temperature at which the solid becomes liquid is called melting point.  Melting point is a…

Q: 1. Why do certain components move further on the stationary phase than others? 2. Why was it…

A: 1. Why do certain components move further on the stationary phase than others?  Size of the…

Q: 1. Which property of compounds is responsible for the separation in a TLC? Explain with an example.…

A: Please find your solution below : 1. Thin layer chromatography is a technique used to separate the…

Q: Coarse Dispersion What will be the results after you reconstitued a cefixime 60 ml a powder for…

A: A question based on colloidal solution, which is to be accomplished.

Q: a) What is capillary electrophoresis used for? b) Describe electrophoresis. c) Describe…

A: Since you have posted multipart of question as per the guidelines i have solved first three subparts…

Q: What do you think would happen to your recrystallization solution if you did not use a pre- heated…

A: Re-crystallization process is a process in which the compounds which are not soluble in cold solvent…

Q: why do we have to order samples (from least concentrated -most concentrated) when measuring the…

A: A question based on qualitative analysis, which is to be accomplished.