hree components in a mixture have varying distribution constants between the mobile phase and the stationary phass One of the components has a very low distribution constant, Would this component likely elute first or last and how would you design an experiment or modify the components of the separation to make it perform in the opposite manner?

hree components in a mixture have varying distribution constants between the mobile phase and the stationary phass One of the components has a very low distribution constant, Would this component likely elute first or last and how would you design an experiment or modify the components of the separation to make it perform in the opposite manner?

Macroscale and Microscale Organic Experiments

7th Edition

ISBN:9781305577190

Author:Kenneth L. Williamson, Katherine M. Masters

Publisher:Kenneth L. Williamson, Katherine M. Masters

Chapter5: Distillation

Section: Chapter Questions

Problem 4Q

See similar textbooks

Similar questions

A method of quantitative determination of the concentration of constituentsof a sample analyzed by gas chromatography is area normalization. Thiscomplete elution of all sample constituents is required. Thearea of each peak is measured and corrected for the detector response to the diffe- renteseluatos. This correction involves dividing the area by an empiricalcorrection factorDetermined. The concen ration of the analyte is found from the ratio between itscorrected and the total corrected area of all peaks. For a chromatogram containing threerelative areas were determined as 16.4; 45,2; and 30.2, in the order ofincreased retention time. Calculate the percentage of each compound if therelative responses from the detector are 0.65, 0.73 and 0.85, respectively.
In gravimetric analysis, volatile electrolyte is used in peptization step a. to form small nucleib. to easily dry precipitatec. to reprecipitate the analyteexplain please
Physical Chemistry for Engineers Question: Correlate degree of association/dissociation to the distribution coefficient.
(a) In High Performance Liquid Chromatography (HPLC), the separation method is by partition of the solute (analyte) between the mobile phase and the stationary phase. Explain how this leads to separation of analyte mixtures; (b) Describe the structure and materials use in a typical column used for HPLC. Thereby explain why high pressures have to be used in HPLC; (c) Discuss how the need for high pressures also imposes requirements on the injector;
Q. No. 5 Write functions and procedure of analysis of various volatile organic molecules by using Gas chromatography
-Describe the equations for the measurement of mass and mole fraction in dimensionless concentration. I want a clear solution for me to understand
What are other experimental methods other than the cryoscopic method by which the molecular weight of a non-volatile solid substance may be determined. Explain the process.
in fractional distillation, how do you tell which liquid is in which fraction and which fraction has a mix of liquids if you are trying to seperate cyclohexane and toluene?? what would the density and boiling point of the first fraction be
[attached is the given data] Questions: What is the weight of sodium chloride (in grams) required to adjust the tonicity of the solution?
Match the following: Freezing point depressionThe effect of supercoolingFreezing point of pure solventRegion where liquid is coolingRegion where liquid is freezing I have attached a picture for this question. I guessed the answers to be B,D,E,F,A but i am not sure if it is correct
How many grams of GaAs04 are required to prepare 2800 mL. of dissolution 0.035 N. ?
Do you agree/disagree with the following statement below? State your reasons. "Classical precipitation gravimetric analysis is best used towards the end of quantitative analysis while classical volumetric analysis is best used as the first technique to quantify analytes."