he unit weight of the soil in the field was recorded as 126.360 lb/ft3 with natural water content of 16.020 %. In the laboratory, the soil is tested for its maximum and minimum void ratio which were 0.910 and 0.380, respectively, and the specific gravity of soil solids to be 2.780. Determine the following: in situ void ratio , relative density of the soil , percentage decrease in the void ratio if the relative density is increase by 10%

he unit weight of the soil in the field was recorded as 126.360 lb/ft3 with natural water content of 16.020 %. In the laboratory, the soil is tested for its maximum and minimum void ratio which were 0.910 and 0.380, respectively, and the specific gravity of soil solids to be 2.780. Determine the following: in situ void ratio , relative density of the soil , percentage decrease in the void ratio if the relative density is increase by 10%

Fundamentals of Geotechnical Engineering (MindTap Course List)

5th Edition

ISBN:9781305635180

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter3: Weight-volume Relationships And Plasticity

Section: Chapter Questions

Problem 3.5P

See similar textbooks

Similar questions

a soil sample was determined to have a water content of 8% and a degree of saturation of 42%. After adding some water, the degree of saturation was altered to 53%. take the specific gravity of the soil solids to be 2.7. assuming no change in the volume of the voids, determine the following A. void ratio B. water content% C. bulk specific gravity of the mass of the sample in the altered state.
A certain soil specimen is tested in lab. It is found out that the maximum void ratio of the sample is 0.943 and theinimum void ratio is 0.361. If the specific gravity of soil solids is known to be 2.61; A. What is the maximum weight of the soil sample? B. What is the minimum weight of the soil sample? C. What is the relative density, if void raio is 0.651
1. (i) A dry soil has a void ratio of 0.65 and its grain specific gravity is = 2.80. What is its unit weight?(ii) Water is added to the sample so that its degree of saturation is 60% without any change in void ratio. Determine the water content and unit weight.(iii) The sample is next placed below water. Determine the true unit weight (not considering buoyancy) if the degree of saturation is 95% and 100% respectively. 2. A sample of saturated soil has a water content of 35%. The specific gravity of solids is 2.65. Determine its void ratio, porosity, saturated unit weight and dry unit weight 3. For a given soil, the void ratio e, water content w, and specific gravity Gs are found to be 0.50, 15%, and 2.65, respectively. Find: (a) Total unit weight of the soil γt (b) Degree of saturation S (c) Dry unit weight γd if the water in the void is removed 4. A shrinkage limit test for a saturated specimen had the initial volume Vi = 21.35 cm3 and initial weight Wi = 37 gf (…
Problem #1. A soil sample in its natural state has a weight of 5.05 lb and a volume of 0.041 ft3. In an oven-dried state, the dry weight of the sample is 4.49 Ib. The specific gravity of the solids is 2.68. Determine: a. total unit weight b. water content C. void ratio d. porosity e. degree of saturation
A 1000 cc soil sample taken from the field weighs 1950 grams. Laboratory analysis shows that the specific gravity of soil solids is 2.65 and its water content is 13%. The voids ratio at its loosest and densest states are 0.68 and 0.48, respectively. Calculate the following: a.) The in situ void ratio of the soil mass. b.) The dry unit weight of the soil. c.) The relative density of the soil.
A sample of gray silty clay has a mass of 126 kg. Laboratory tests results give a moist density(ρ) of 2.05 g/cm3, a specific gravity of solids (Gs) of 2.67, and a moisture content (w) of 14.7%.First determine all entries in the phase diagram. Then determine the void ratio (e), the porosity(n), the degree of saturation (S), the dry density (ρd), the dry unit weight (γd), and the moistunit weight (γ).
A clay soil is found to have a liquid limit of 75%, a plastic limit of 45% and a shrinkage limit of 25%. If a sample of this soil has a total volume of 30 cm3at the liquid limit and a volume of 16.7 cm3 at the shrinkage limit, determine the following: A. Mass of soil at the shrinkage limit B. Shrinkage ratio C. Specific gravity of solids
A granular soil sample taken from the field has a density of 1900 kg/m3. In a laboratory test, it was found out that the density of the soil solids is 2600 kg/m3, moisture content of 11.5% and void ratios at its densest and loosest states are 0.43 and 0.62, respectively. Determine the following: a. In-situ dry density of the soil, kg/m3. b In-situ void ratio. c. Relative density, %.
A granular soil sample taken from the field has a density of 1900 kg/m3. In a laboratory test, it was found out that the density of the soil solids is 2660 kg/m3, the water content is 11.5%, and the void ratio at its densest and loosest state are 0.43 and 0.62, respectively. 1. Calculate the in-situ void ratio. 2. Determine the relative density of the granular soil.
A soil is mixed at a water content of 16% and compacted in a 1000 ml cylindrical mold. The sample extruded from the mold has a mass of 1620 g, and the specific gravity of the soil grains is 2.69. Find the following: a. void ratio, b. degree of saturation, and c. dry unit weight of the compacted sample. d. If the sample is soaked in water at the same void ratio, what would be the new water content?
3. A clay soil is found to have a liquid limit of 75%, a plastic limit of 45% and a shrinkage limit of 25%. If a sample of this soil has a total volume of 30 cm' at the liquid limit and a volume of 16.7 cm' at the shrinkage limit, determine the following: a. Mass of soil at the shrinkage limit b. Shrinkage ratio c. Specific gravity of solids
100 cm3 saturated sample of quartz sand is weighed, gravity drained, weighed, oven dried, and weighed again. The saturated, gravity-drained, and oven-dried weights are 130g, 110 g, and 105 g, respectively. Given that the soil sample above has porosity of 35%. i. Determine the void ratio of this soil. ii. If 50% of the void space is filled with water, with the remaining 50% filled with air, determine the volumetric water content, θ. iii. and the degree of saturation, S.