Find hybrid parameters for the network in figure 3 V₁ I₁ 192 www.T 292 292 www Figure 3 192 www. 41₁ 292 V₂

Q: E C

A:

Q: B- An amplifier system has NF=8 dB, when the input signal with S/N = 8 dB calculate the SNR at the…

A:

Q: The current shown below is applied across 0.2 H inductor find V₁. iL (A) 44 0.2 H m 5 50 10 20 30 40…

A:

Q: Q41-Q45 refer to the information below: A 6 kV, 3-ph industrial plant bus is supplied from the…

A:

Q: Q13. Which of the following is the main disadvantage of using con (a) Poor performance at high…

A: There are the few questions related to the harmonics their generation ,how to control or eliminate…

Q: Visin30 Determine the output voltage for the circuit of Fig.3 blow. Where the *frequency is 10 KHz…

A: Operational Amplifier: Op-amps  is a divided into noninverting and inverting amplifiers and it is…

Q: D9.4. Let = 105 H/m, = 4 x 10° F/m, a = 0, and p, = 0. Find k (including units) so that each of the…

A:

Q: PROBLEM: in plotting root locus, find the asymptote line angle is/are. R(S) K s(s+ 1)(s² + 4s +13)…

A: Brief description: For the given closed loop transfer function we need to calculate asymptote line…

Q: 15) The saturation current of ap- junction diode is 350 mA and the operating temperature is 295 K.…

A: Brief description: Here we need to calculate the value of reverse biased voltage to get the reverse…

Q: - Ex: consider the block diagram shown below:- R(s) K₁ s+4 K₂ s-1 Y(s) 6 - Determine the following:…

A: Steady state value of output(yss) and steady state error( ess) of the system for input R(s) is…

Q: 3. Determine the inverse z-transform using partial fraction expansion that results to a causal…

A: Given Xz=2z-11-3z-1+z-2+5z-3here we have to find the inverse z-transform we know that Zanun=zz-a…

Q: Draw the equivalent signal-flow graph of the given electrical system below. Assume V(t) be the input…

A: SFG is a graphical representation of the relationship between the variables of a set of linear…

Q: solve parts d and e and f  d in the picture, e and f are: e) The value of K when the root loci…

A: Steps to find the Root Locus  Find the number of Poles (P) Find the number of Zeroes ( Z) Mark on…

Q: › 22 V VGSQ 1.2 ΚΩ IDQ 1 ΜΩ VGS (TH) = 4V VGS (on) = 7 V ID (on) = 5 mA • 0.51 ΚΩ Figure 1: E-MOSFET…

A:

Q: Consider the sinusoidal voltage A. What is the maximum amplitude of the voltage? B. What is the…

A: Given, The sinusoidal voltage vt=80cos1000πt-30° V

Q: When does ANTENA radiation occur and when does antenna not occur?

A: Brief description:  In the question we need to define radiation property of the antenna.

Q: P 0.8 pf lagging + Vo P 0.9 pf lagging

A: Given data, is=9+j0 A, P1=50 W, P2=56 W Circuit diagram is given as,

Q: mixer with a noise figure of 20 dB is preceded by an amplifier with a noise figure of 9 dB and

A: In this question we will find noise figure referred to input....

Q: 6. For the circuit shown in Figure 7.6, determine apparent power S, real power P, reactive power Q…

A:

Q: Problem 3. A coaxial cable has an inner core radius of 0.5 mm and an outer conductor of internal…

A: Given a coaxial cable having, Inner core radius, a = 0.5 mm Outer core radius, b = 6 mm Dielectric…

Q: Two single-phase transformers, one of 100 kVA and the other of 50 KVA are connected in parallel to…

A: Given data, Rating of transformer S1=100 KVA, S2=50 KVA Resistances are given 2% and 5% Reactance's…

Q: Q38-Q40 refer to the table below: The voltage in a 60 Hz, 1-phase system has the following harmonic…

A: Given three harmonics with their RMS voltage values of a single phase 60 Hz system. Let Vn be the…

Q: (a) Why in an AC transistor amplifier is it important to AC couple the input and output?

A: Transistor amplifier- It is a condition in which a transistor works as amplifier and used to…

Q: Q3: Find hybrid_parameters for the network in figure re ΤΩ ΖΩ Figure 2 ΖΩ ΤΩ 141, 228

A:

Q: Modulation and Demodulation: 1. Define detection process? 2. What are the different types of…

A: Modulation and demodulation Modulation is the process of encoding information in a transmitted…

Q: A2 For the circuit shown in Figure A2, assuming R₁ = 10.2 km, R₂ = 1k0, R3 = 500, R4 = 1.5 km, R5 =…

A:

Q: A straight wire carrying a 2.88-A current is placed in a uniform magnetic field of magnitude 0.274 T…

A:

Q: Considering the system shown below: R(s) (s+a) (s+b) S PID controller Plant G(s) G(s) a. Set-up the…

A: The proportional integral derivative controller produces an output, which is the combination of the…

Q: Q2: Based on the logic circuit given in Figure 1. Design a shift register that displayed the input…

A: Given,Clock frequency=500 KHzTclock=1f=1500×103=1000500×10-6Tclock= 2μsecNo. of clock pulse required…

Q: 2. For the circuit shown in Figure 7.2, determine apparent power S, real power P, reactive power Q…

A:

Q: 5S²+25-4 s (S+1) (S+2) (S+ 3) Taking Laplace transform Partial fractin

A:

Q: Find the instantaneous voltage across a 8-μF capacitor when the current passing is i = 2sin (60t +…

A: We need to find out the voltage across capacitor for given current

Q: :An industrial heater has a nameplate that reads Vrms 233 Hz 59 kVA 104 lagging 0.70 ?What is the…

A: Given data, Vrms=233 Vf=59 HzKVA rating 104Power factor cosϕ = 0.7

Q: 10 Ω j4 Ω + E₁ Μ ~) Vs 2:1 The Ioad on the right is absorbing 650 W - j200 VAR. V, = 80 / 0° V. I1…

A:

Q: 1863 224 2,525 10 ㅛ ft IDB-SmA Up=-60 2U R₂ 1k If VCE is SV in the circuits and green led is on,…

A:

Q: Consider the circuit below. R₁ m + + vi(t) vo(t) a. Obtain the transfer function H(s) = Vo/V₁. b.…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub parts for…

Q: Find the complete Response of the Capacitor Voltage for t>o Don't use Laplace transform d²Uc df² +4…

A:

Q: 8A 0 www 2A 3S 365 Ris 403V 402 40A RE% 41 42 B Fig. 1.65 Fig. 1.66 Fig. 1.67 5. Compute the values…

A: The given circuit is shown below:  On applying K.C.L at the above nodes,…

Q: Tutorial Problems 1. Derive the Thevenin's hence determine the curr resistor.

A:

Q: The rectangular-shaped current pulse shown is applied to a 0.1 micro F capacitor. The initial…

A: The Given Capacitor C=0.1mF The Initial voltage on the capacitor is 15V To derive the expression for…

Q: R1 Vs R2 +21 www R3 R4 ?For the circuit shown in the figure above, what is the value of the…

A: Brief description:  In the above given question we need to calculate the value of capacitor voltage…

Q: R(S) K s(s+ 1)(s² + 4s +13) C(s)

A: Given unity feedback control system  The root locus is a graphical representation in s-domain and…

Q: An audio power amplifier delivers an 80-volt peak 35 Hz sine to a subwoofer. If the subwoofer…

A: Given data, Peak voltage Vp=80 V Frequency f = 30 Hz Impedance Z=4∠-300

Q: is P Vo P 0.8 pf lagging 0.9 pf lagging ?For the circuit shown above, what is the input power factor…

A: Power factor- It is the ratio of the total power and the utilized power which means it indicate that…

Q: A- For the circuit shown in figure 3 draw the output voltage waveform across the SCR and the current…

A: Silicon controlled rectifier: The SCR is a semiconductor devise its a belong three-terminal…

Q: A 280 V, separately excited DC motor with armature resistance of 1 Q and constant fiel excitation…

A: In this question we will find speed of separately excited dc motor when additional resistance is…

Q: 1.2 The prefix micro stands for: (a) 106 (b) 10³ (c) 10-3 (d) 10-6

A:

Q: Use Thevenin to determine the current and voltage at the 10 ohm resistor. 1 20 Ω 2 10 Ω 3 www 120 V…

A:

Q: .For the following voltage and current phasors, calculate the apparent power in VA V = 191 4 230…

A:

Q: 2. Let X[k] be the DFT of x[n] = {0, 1, 2, 3, 2, 1, 0, 0). (c) For Z[k] =(-1) X[k], obtain the…

A: Let X(k) be the DFT of x[n]=(0,1,2,3,2,1,0,0} For Z(k)=(-1)kX(k) , we need to obtain the inverse DFT…

Superposition Theorem

The superposition theorem is applied to linear systems. For such systems, the output from two different inputs equals the sum of the outputs from each input separately. On applying this theorem many times we get the output from any number of inputs equal to the sum of the outputs from the individual inputs separately.