F-7kN Q1: The plate is subjected to the two forces at (A ) and (B) as shown. Determine the magnitude of the resultant of these two forces and its direction measured counterclockwise from the horizontal. FA-9 kN

F-7kN Q1: The plate is subjected to the two forces at (A ) and (B) as shown. Determine the magnitude of the resultant of these two forces and its direction measured counterclockwise from the horizontal. FA-9 kN

International Edition---engineering Mechanics: Statics, 4th Edition

4th Edition

ISBN:9781305501607

Author:Andrew Pytel And Jaan Kiusalaas

Publisher:Andrew Pytel And Jaan Kiusalaas

Chapter1: Introduction To Statics

Section: Chapter Questions

Problem 1.48P: The pole OB is subjected to the 6004b force at B. Determine (a) the rectangular components of the...

See similar textbooks

Related questions

Q: Q3/ Determine the resultant of the force system shown in Fig. 224 300 30 361

A: It is required to determine the resultant force

Q: Determine the magnitude of the resultant force in 0 = 51 degrees and T = 7 kN. Provide the answer in…

A: To find: The resultant force acting at the point of concurrent forces.

Q: QS/ The plate is subjected to the two forces at A and B as shown. Ir e- 60", determine the magnitude…

A: Given data: The magnitude of force at A, FA = 8 kN. The magnitude of force at B, FB = 6 kN. Draw a…

Q: Q (1): When F1-750 N, F2= 510 N, F3-430 N, determine the magnitude of the resultant force and its…

A: We are suppose to solve only one question. Please post other question as a separate question.

Q: If the force vector F=(33i-44j+52k) N. а-5 m;B b-4 m;B с-3 m3B -a a B a 4a) Determine the magnitude…

Q: Q1: Determin the magnitude and direction of the force F so force is directed vertically upward and…

Q: Determine the resultant of the force system shown in fig. and its diarection if F1= 75O N ?and the…

A: Force acting in the y directions are…

Q: P3-7. determine the resultant force and specify its coordinates x and y where it acts on the x-y…

Q: Q3( , - Determine the resultant of forces system shown in Figure with its direction and locate it…

A: To find : The resultant of forces, direction and location from point C. FBD: The FBD of resultant…

Q: Q3/ Determine the resultant of the force system shown in Fig. 224 300 30 3 361

Q: Q1 Determine the resultant force F due to water acting on the 3 m by 6 m rectangular area AB shown…

Q: Determine the magnitude and orientation 0 of Fa so that the resultant force is directed along the…

Q: The eyebolt supports the four forces shown. If the resultant force on the bolt is 3 kN in the +x-…

A: given:

Q: Q2: Determine the magnitude of forces FA and FB acting on each chain in order to develop a resultant…

Q: Fg=7 kN Q1: The plate is subjected to the two forces at ( A ) and (B ) as shown. Determine the…

Q: Q3 / A: 2. For the force system as shown in fig.(3-a) below ; Find the location of the resultant…

A: Law of Mechanical Equilibrium: A body is said to be in mechanical equilibrium if it satisfies the…

Q: F-7 kN Q1: The plate is subjected to the two forces at (A ) and (B) as shown. Determine the…

Q: ituation 2. If the resultant force acting on the support is to be directed horizontally to the…

A: Solution;

Q: F2-1. Determine the magnitude of the resultant force acting on the screw eye and its direction…

A: here we need to take the component of the force in x and y direction Resultant force can be…

Q: Prob. 3: Determin the magnitude and diredan the resultant forces shown in Big 450 N 40 35 40 35 N 00

Q: 02: If ,-1000 N and - 45, determine the magnitude of the resultant force acting on the eyebolt and…

A: F1=1000 Nϕ=45°F2=200 Nφ=60°F3=450 Nθ=tan-134=36.87°

Q: Q1 ) The plate is subjected to the two forces at A and B as shown .If ,determine the magnitude of…

Q: H.W 3: Determine the angle of for connecting member A to the plate so that the resultant force of FA…

Q: Determine the magnitude and direction of the resultant of the concurrent force system that acts at…

A: Given Data, Coordinates of point A = (4,-3,4) Coordinates of point B = (6,5,-3) Coordinates of point…

Q: - Two forces are applied at the end of a screw eye in order to remove the post. Determine the angle…

A: Fnet = 750 N is acting vertically upward Find angle and force F

Q: Problem (1):-Determine the resultant of coplanar force system of the fig.(1) and locate it with…

A: We are restricted to solve one question at a time. Please ask other questions in the next post.…

Q: The plate is subjected to the two forces at A and B as 60°, determine the magnitude of the resultant…

Q: Determine the magnitude and direction of the resultant force acting on the beam. 8 kN 15 kN 40% 11…

Q: Q2/ For the force (F), the rectangular components are Fx -40N. and Fy = 60 N. respectively.…

A: Given data

Q: P3-6. determine the x and y components of the resultant force and specify the distance where this…

A: Consider the diagram shown below for the given beam,

Q: The force F=450 lb acts on the frame. Resolve this force into components acting along members AB and…

Q: P3-7. specify its coordinates x and y where it acts on the r-y plane. determine the resultant force…

A: Calculate the resultant force

Q: Determine the magnitude of the resultant force and F2.

A: For value of F2F2 cos40o =F1 cos30o F2 cos40o =200× cos30o F2 =226.103 N ,

Q: Q/ Determine the magnitude of the resultant forces acting on the screw eye and its direction…

A: Given data: Applied forces are 2 kN and 6 kN Need to determine the magnitude and the direction of…

Q: äböi 25 Determine the resultant force for the forces system shown in fig 37 Mm 120N A looN

Q: Three forces act on a hook. Determine the magnitude of the resultant of the force. Neglect hook…

Q: Determine the magnitude of the resultant force acting at A. Given that FB = %3D 869 N and FC = 981

Q: Determine the magnitude of the resultant force if the load at E is increased by 29

Q: B: The plate shown below is affected by the forces FA and Fs, by assuming the value of 0, calculate…

Q: Determine the angle for connecting member A to the plate so that the resultant force of F sub A and…

A: If two or more forces operate on an object, it is possible to find the resulting force by adding up…

Q: The force Fehown below is applied on the perticle and expressed as a Carteslan vector F -91-8J-5k…

Q: The plate is subjected to the two forces at A and B as 60°, determine the magnitude of the resultant…

A: forces into x and y components, FAx = 8sin(60) = 4√3FAy = 8cos(60) = 4FBx = 6sin(40) = 3.857FBy…

Q: B: The plate shown below is affected by the forces FA and FB, by assuming the value of 0, calculate…

Q: The force F = 120 lb acts on the frame. Resolve this force into components acting along members AB…

Q: If the magnitude of the resultant force is to be 200 N, directed along the negativey axis, determine…

Q: Determine the x and y components of each of the forces shown. - 008- Dimensions in mm 800 N 600 424…

Q: Q/ Determine the magnitude of resultant force for system shown below and its * location according to…

Q: If the magnitude of the resultant force is to be 9 kN directed along the positive x axis, determine…

Q: If the resultant force acting on the hracket is to he 750 N diroctod along the positive s axis,…

Question

6-7 kN
Q1:
The plate is subjected to the two forces at (A) and
(B) as shown. Determine the magnitude of the
resultant of these two forces and its direction
measured counterclockwise from the horizontal.
FA-9 kN

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Q3 / The rectangular plate is supported by hinges along its side BC and by the cable AE. If the cable tension is 300 N, determine the projection onto line BC of the force exerted on the plate by the cable. Note that E is the midpoint of the horizontal upper edge of the structural support. Ans. Tec = 251 N C 400 mm D E 25 T= 300 N A 1200 mm
4-151. Currently eighty-five percent of all neck injuries are caused by rear-end car collisions. To alleviate this problem, an automobile seat restraint has been developed that provides additional pressure contact with the cranium. During dynamic tests the distribution of load on the cranium has been plotted and shown to be parabolic. Determine the equivalent resultant force and its location, measured from point A. 12 lb/ft 0.5 ft w 12(1 + 2x) Ib/ft 18 lb/ft
3-94. Replace the parallel force system acting on the plate by a resultant force and specify its location on the x-z plane. 0.5 m 2 kN 5 kN 1m 3 kN 0.5 m
The tower is held in place by three cables. If the force of each cable acting on the tower is shown, determine The coordinates of force vector FDA
*3-104. The building slab is subjected to four parallel column loadings. Determine the equivalent resultant force and specify its location (x, y) on the slab. Take F, - 8 kN and F - 9 kN. 12 kN 6kN 6m 12 m. 16 mi
3/15 Find the angle of tilt e with the horizontal so that the contact force at B will be one-half that at A for the smooth cylinder. 45 45
The line of action of the 3110-lb force runs through the points A and B as shown in the figure. Determine the x and y scalar components of F. A (-7, -2) Answers: Fx- Fy- y, m B (8,4) F = 3110 lb -x, m lb lb
The cable AB prevents bar OA from rotating clockwise about the pivot O. If the cable tension is 820 N, determine the n- and t-components of this force acting on point A of the bar.
2-9. If the resultant force acting on the support is to be 1200 lb, directed horizontally to the right. determine the force Fin rope A and the corresponding angle a. 900 Ib
3-91. The weights of the various components of the truck are shown. Replace this system of forces by an equivalent resultant force and specify its location measured from point A. 175KN 27.5 kN V8.75 kN 4.2m -1.8 m- 0.9 m 0.6 m
Q4'The forces FI, F2, and F3, all of which act on point A of the bracket, are specified in three different ways. Determine the x and y scalar components of each of the three forces. (25 Marks) F2= 500 N F1 = 600 N 3. 35 0.1 m 0.2 m- 0.3 m F3= 800 N B -0.4 m- 1.
P3-7. specify its coordinates r and y where it acts on the r-y plane. determine the resultant force and 200 N 200 N 100 N 1m,