deposit of clay underlain a 4.5m thick sand. the degree of saturation of sand is 37%, the void ratio is 0.52. the moisture content of clay is 42 %. the natural groundwater table is located at 2m below the natural ground surface. assume that the sp.gr. of sand and clay are both 2.65. compute: unit weight of sand above the water table effective pressure at point 10m below the ground surface total pressure at point 10m below the ground surface

deposit of clay underlain a 4.5m thick sand. the degree of saturation of sand is 37%, the void ratio is 0.52. the moisture content of clay is 42 %. the natural groundwater table is located at 2m below the natural ground surface. assume that the sp.gr. of sand and clay are both 2.65. compute: unit weight of sand above the water table effective pressure at point 10m below the ground surface total pressure at point 10m below the ground surface

Principles of Foundation Engineering (MindTap Course List)

9th Edition

ISBN:9781337705028

Author:Braja M. Das, Nagaratnam Sivakugan

Publisher:Braja M. Das, Nagaratnam Sivakugan

Chapter2: Geotechnical Properties Of Soil

Section: Chapter Questions

Problem 2.16P

See similar textbooks

Similar questions

A certain saturated sand (S = 100%) has a moisture content of 27.9% and a specific gravity of solids of 2.61. It also has a maximum index void ratio of 0.90 and a minimum index void ratio of 0.33. Compute its relative density and classify its consistency. (Table on the right) Solution: Given the values of mmoisture content, specific gravity and degree of saturation, the void ratio can be estiamted as: e = Thus the relative density is found to be Dr = • According to the table, the soil is classified as %; soil. TABLE 3.3 CONSISTENCY OF COARSE-GRAINED SOILS AT VARIOUS RELATIVE DENSITIES (data from Lambe and Whitman, 1969) Relative Density, D,(%) 0-15 15-35 35-65 65-85 85-100 Classification Very loose Loose Medium denseª Dense Very dense "Lambe and Whitman used the term "medium," but "medium dense" is better because "medium" usually refers to the particle size distribution.
6. The maximum dry unit weight determined in the laboratory for a quart sand is 102 lb/ft3. In the field, the relative compaction is 90%. Specific Gravity of Sand is 2.70. Determine the void ratio at the maximum dry unit weight condition. Determine the void ratio of the sand in the field condition. Determine the hydraulic conductivity of the sand in the field condition if the hydraulic conductivity of the sand at the maximum dry unit weight condition is 0.30 cm/sec. Using Kozeny-Carman equation.
A certain saturated sand (S = 100,) has a moisture content of 25.1 percent and a specificgravity of solids of 2.68. It also has a maximum index void ratio of 0.84 and a minimum indexvoid ratio of 0.33. Compute its relative density and classify its consistency.
Question A 588 cm³ volume of moist sand weighs 1010 gm. Its dry weight is 918 gm and specific gravity of solids, G is 2.67. Assuming density of water as 1 gm/cm³, the void ratio is
2. A specimen (50 mm diameter and 100 mm height) of moist sand weights 3.31 N. Its dry weight is 3.0 N and the specific gravity of the solids is 2.65. Given the maximum and the minimum void ratio of the sand emax = 1.05 and emin = 0.65, respectively. (a) Determine the relative density of the sand. (b) Calculate the saturated unit weight and the effective (or buoyant) unit weight of the sand. (c) Use your own words to describe the meaning of effective (or buoyant) unit weight of the soil.
50 ft thick sand is underlain by 25 ft clay. The ground water table, initially at the ground surface, was lowered to a depth of 25 ft below the ground. After such lowering, the degree of saturation of the sand above water table was lowered to 20%. Saturated and dry unit weight of sand are 135 pcf and 116 pcf respectively. The saturated unit weight of clay is 120 pcf. a. what is the unit weight of the sand above the water table after lowering in pcf? b. What is the vertical effective pressure at the midheight of the clay layer when the water table is lowered 50 ft. Below the ground in psf?
geotech. engineering A Thick layer of clay underlies a sand formation having a thickness of 4m. the groundwater is located 2m below the ground surface. The specific gravity of sand and clay is 2.65 with sand having an average void ratio of 0.52. the clay has a water content of 42%. Degree of saturation above the water table is 0.37. a. Compute the moist unit weight of the sand b. Total stress at a depth 10 m below the ground surface c. Effective stress at a depth of 10 m below the ground surface
A layer of soil profile consists of 3.6m upper layer of sand having a saturated unit weight of 18.88 kN/m3 and a lower clay layer 16m deep waith saturated unit weight of 17.31kN/m3. The clayayer has a void ratio of 1.27. The sand layer has a liquidity index of 64.5% and moisture content of 40%. Plastic limit is 20%. Water is located at the ground surface. A tank 12 m high is located at the ground and contains oil with density of 0.81. A. Determine the effective vertical stress at the mid height of clay layer. B. Determine the consolidation settlement of the clay layer. C. Determine the maximum depth that the cylinder be buried so that the settlement will be minimum.
Solve the following problems. Provide complete solutions and summary of answers. A 4-meter-thick sand overlies a thick layer of clay. The water table is 1.80 meters below the sand surface. The sand has a porosity of 34.64% and a degree of saturation is limited to 36.0% above the water table. The clay has a moisture content of 45.0% and the specific gravity of both sand and clay is 2.68. a. Total Stress at a point 12.0 meters below the sand surface. b. Total Effective Stress at a point 12.0 meters below the sand surface.
A structure is built on a normally consolidated clay of thickness of H(m), where H is the last digit of your student identity number (SID). If the last digit of your SID is zero, take H = 10m. The normally consolidated clay has a natural moisture content of 45% and a Liquid limit of 50%. Ground investigation results show that the clay is overlain by a 15m layer of sand, and the ground water table is at 10m below ground level. The submerged unit weight and bulk unit weight of the sand layer are 15 kN/m³ and 20 kN/m³ respectively. The vertical stress increase at the centre of the clay layer is 100kPa due to the weight of the structure. Calculate the settlement of the structure due to primary consolidation. Take G =2.7.
The coefficient of permeability of a sand at a void ratio of 0.62 is 0.03 cm/sec. estimate the coefficient of permeability at a void ratio of 0.48. a. Using Casagrande equation b. Using kozeny - Carman equation.
A certain saturated sand (S = 100%) has a moisture content of 25.1% and a specific gravity of solids of 2.68. It also has a maximum void ratio of 0.84 and a minimum void ratio of 0.33. Calculate its relative density and classify its consistency