Dan is trying to build a circuit by applying a 34 volt emf to an LR series circuit in which the inductance is 0.7 H and the resistance is 48 ohms. Dan assumed that the circuit has no initial current. What is the value of the current as "t" approaches positive infinity.

Dan is trying to build a circuit by applying a 34 volt emf to an LR series circuit in which the inductance is 0.7 H and the resistance is 48 ohms. Dan assumed that the circuit has no initial current. What is the value of the current as "t" approaches positive infinity.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: An RL circuit has an emf of 5V, a resistance of 50Ω , an inductance of 1H and no initial current.…

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

Q: differential equations A circuit with a 10 ohm resistor and a 4.6 henry inductor is connected in…

Q: A 100V electromotive force is applied to an RC-series circuit in which the resistance is 200 ohms…

Q: Given a series RL circuit that has a resistance of 10Ω and an inductance of 470mH, how long will it…

A: The current across the RLC circuit is given by the expression as shown below: i(t)=i01-e-RtLi0=VR…

Q: An RC circuit has an emf of 10 sin t volts, a resistance of 120 ohms, a capacitance of 0.5 farad,…

Q: Discuss the following ADC architecture briefly. 1. Dual Slope

Q: I have a series circuit with a source of 50V, resistor 400 ohms, capacitor Xc=120 ohms, and a 60 Hz.…

A: If f is the frequency of the input AC signal, then the reactance of the capacitor of capacitance C…

Q: A 275mH inductor with a quality measure of 6 and a 1502 resistor are series connected to a 120V,…

A: Given: Inductance, L=275 mH Resistance, R=150 Ω Quality measure is 6 Source voltage, V=120∠0°V…

Q: An RL circuit has an emf of 5V, a resistance of 50Ω, an inductance of 1 H and no initial current.…

Q: A charge and discharge RC circuit is composed of a resistance R and a capacitance C = 0.1µF. a)…

Q: An electric motor can be modeled as a series combination of a 16-0 resistor and 200-mH inductor. If…

Q: In the circuit below, at t = 0, switch S, is closed and switch S2 is closed 4 seconds later.…

A: Given, Switch S1 closed at t=0Switch S2 closed at t=4 s For t<0iL0-=0=iL0+

Q: The figure below shows a simple RC circuit with a 3.50-µF capacitor, a 3.60-MQ resistor, a 9.00-V…

A: Note: Since we only answer up to 3 sub-parts, we’ll answer the first 3. Please resubmit the question…

Q: The switch in the circuit of figure (2) is closed at t-0, the initial value of the capacitor voltage…

Q: Provide the table V(τ) of the circuit from 1 τ to 5 τ. Assume that the initial charge of capacitor…

Q: What is the general statement of the self-solution in a circuit composed of a linear time invariant…

A: Interconnection of elements like resistors, capacitors, and voltage sources are called Network. Here…

Q: Q2/ For the network shown in figure (Q:), the switch has been open for a long time before closing at…

Q: A network has a 5-μF capacitance in series with the parallel combination of a 12-μF capacitance and…

A: Given data: The value of capacitance in series is: 5 μF The circuit diagram is shown as, The…

Q: Home Work In the figure below, the switch has been open for a significant period of time. The switch…

Q: For the given circuit, (a) what is the inductance and (b) the solution form of V5(t)?

A: The given circuit and the waveform is as shown below,

Q: Cite at least five (5) applications of RC circuits and each example will explain why they are very…

A: Resistors, inductors and capacitors form an integral part of the electrical circuit. The circuit…

Q: An RL circuit has an emf of 5V, a resistance of 50Ω, an inductance of 1 H and no initial current.…

Q: A utility company plans to connect a total of 20 microfarads of capacitance to a 7200V line. To make…

Q: A capacitor is connected into a 1250-V, 1000-Hz circuit. The current flow is 80 A. What is the…

A: Given data, The value of voltage is V = 1250 V. The value of frequency is f = 1000 Hz. The value of…

Q: Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance of…

Q: Consider the circuit shown in the figure. The capacitor is initially uncharged. Find the current…

A: Fig: Given circuit

Q: EUDORA IS LOOKING AT A CIRCUIT THAT HAS A 0.05 HENRY INDUCTANCE AND A 20 OHM RESISTANCE. ALSO, WITH…

Q: An RC circuit has an emf of 10 sin t volts, a resistance of 120 ohms, a capacitance of 0.5 farad,…

A: The solution is given below

Q: Basic Electrical Engineering: Inductance and Capacitance You are an electrician working in an…

A: The AC capacitors are polarity-independent and non-polarized. As a result, an AC capacitor may be…

Q: Charging a Capacitor: An RC circuit includes a

Q: 3. The current through a 10-mH inductor is shown in the figure below. Determine the voltage across…

A: In this question, we need to determine the voltage across the Inductor? We know V= L di/dt

Q: We know that a 50-μF capacitance is charged to an unknown voltage Vi at t=0. The capacitance is in…

A: Draw the circuit diagram.

Q: to a DC source at t-0. If the inductor has l current Io-2A flow in opposite n of the final current,…

A: In this question, we have given series RL circuit with dc source and we have to find out circuit…

Q: You are given 10 resistors that are each 30 Ω. Construct a circuit with a resistance of exactly 85…

A: Note : "Since you have posted a question with multiple sub-parts, we will solve first three…

Q: 2. Eudora is observing a certain circuit consists of an inductance of 0.05 henry having a resistance…

A: In this question, Find the current I and charge Q at steady state conditions. If R= 45 ohm L =…

Q: capacitor, and a 10.5 V voltage source. --> The student discharges C1 and charges C2 to 10.5 V.…

Q: Q4. The current through a 1- µF capacitor is shown in Figure Q4. Sketch voltage v(t) scaled with…

A: The voltage across the capacitor can be calculated by using the voltage formula.

Q: A circuit supplied by 230V, 50HZ, is shown in Figure B5 below, is used to find the unknown value of…

A: The circuit given in the question is a ac bridge circuit excited by 230V, 50Hz supply and the value…

Q: The capacitor in the circuit below initially has no voltage. All components may be assumed to be…

Q: Batteries and AC current are often used to charge a capacitor. A common example of capacitor use is…

A: Given circuit: C1=0.5 μFC2=1 μFC3=1 μFV=10 Vr=1 Ω

Q: An RL circuit has an emf of 5 V, a resistance of 50 ohms, an inductance of 1 H, and no initial…

Q: Problem 4 The current through a 12-mH inductor is 4 sin 100t A. Find the voltage, across the…

A: Need to find energy and voltage

Q: Prob 2: Sometimes it is desirable to use the miller effect to "amplify" the capacitance,…

Q: A circuit supplied by 230V, 50HZ, is shown in Figure B5 below, is used to find the unknown value of…

Q: In the circuit at right, a 100 mH inductor and a 5 N resistor are connected by a switch to a 6 V…

Q: Let the inductance element with the value of L=6 H and the initial condition current iL(0)=1A be…

Q: Since the capacitance specified in the circuit below is limited in the range of 1-10nF, find the…

A: Fig: Given circuit calculate capacitive and inductive…

Q: For the circuit of Figure 2. Assuming that the capacitor voltage and inductor current are equal to…

A: Given circuit diagram : We know that at t =0 Vc(0) =0 Vc(o+) =0 Vc=VR=VLVL = L di(t)di…

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Dan tries to build the circuit

VIEW

Value of current

VIEW

steady state current

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Similar questions

An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
A 22-k resistor and a 0.02-F capacitor are connected in series to a 5-V source. How long will it take the capacitor to charge to 3.4 V Select one: a. 0.501 ms b. 0.66 ms c. 0.44 ms d. 0.70 ms
An alternating current flowing through a circuit has a maximum value of 70A, andlags the applied voltage by 600. The maximum value of the voltage is 100V, and bothcurrent and voltage waveforms are sinusoidal. What is the value of the current whenthe voltage is at its positive peak?
The initial rate of current rise in an RL circuit is 300 amp per sec when 120 volts is suddenly impressed. What is the inductance of the circuit?
An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coil
1. A purely resistive circuit the current is leading by 90° with respect to voltage. 2. A purely inductive circuit the current is lag behind the voltage by 90°. 3. A purely capacitive circuit the current is lead by 90° with respect to the voltage. 4. A capacitor element stored magnetic energy. 5. An inductor element stored electrical energy. 6. Resistor elements consume power. 7. Angle between current and voltage is called power. 8. The power factor angle for a purely resistive is zero. 9. The power factor angle for a purely inductive load is -90°. 10. The power factor of a purely capacitive is leading.
I need answer with explaination In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A 6-ohm resistor is connected in parallel with a 300 uF capacitor and the circuit is supplied by a 10A 60Hz current source. Find the instantaneous current through the resistor and the capacitor.
Using the series circuit in Figure 3 consisting of a voltage source V, the resistor R and the fully uncharged capacitor C, how to find the value of the capacitance C considering as known data the time constant of the circuit T and the value of the resistor R? V ww R
A load is composed of a 4 ohm resistance connected in series with a 3 ohm inductive resistance. The load is connected across a 120 source. Compute: (a) current (b) voltage across the resistance (c) voltage across the inductor Explain each step.
An R-L series circuit contains a resistor and an inductor. The resistor has a value of 6.5 V. The circuit is connected to 120 V and has a current flow of 12 A. What is the inductive reactance of this circuit?
Sketch or lay out the diagram of the system. The specificities are as follows: Resistors 2 and 3 are laid out in parallel with each other; Resistor 1 and Capacitor 1 are in series with each other and with Resistor 2; The loop is traced so that the value of resistor's voltage is negative. Determine the current flowing in the RC series circuit. Find the voltages used by each resistor.