Compute the magnitude of the voltage in units of Volts (enter value only, not units) for a componet with phasor current and impedance specified below - I = 2AZ0° Z = 10445°

Q: What is the value of the equivelent admittance? 30

A:

Q: What is the RMS value of 169sin 377t?   Answer: 119.5 volts

A:

Q: The number of disc insulators used in a suspension insulator setup with string efficiency 85 %,…

A:

Q: Find the closed loop gain for op amp for the circuit showen

A:

Q: What is the reactance of 3.00 microfarad capacitor? What is the impedance of the capacitor in series…

A: Given: C=3 μFR=300 Ω

Q: 3.2 A 4.16 three-phase primary feeder is shown in Figure 3.23. The Karop = 0.00298639% drop/kVA-mile…

A: Given Kdrop=0.00298639 %/ kVA-mile Krise=0.003343539 %/ kVAr-mile

Q: Given a single phase inductance Lm.1) ,1phase = 12 mH, what is the mutual inductance between stator…

A: Given:Single phase inductance Lm,1 phase=12 mH

Q: In phasor representation of alternating quantity, one Complete cycle represents 120° rotation of…

A: We need to tell about given statement is true or false.

Q: In a 10 km long three phase conductor diameter of 2.5 mm the conductors are arranged symmetrically…

A:

Q: the diferent contrel strutegies. Emplain imith oppreprinte novoforme used for obtaining chopper. de…

A:

Q: In class A chopper with R-L load, the continuity of current increases as     duty cycle decreases…

A: Inductance has to be increased To increase the continuity of current the period of time should be…

Q: "In a R-L series circuit, applied voltage is in phase with the total current."  True  False   "In…

A: 1. impedance of RL circuit is R+jXL  So, impedance angle ∅ = tan-1WLR So, current in Rl circuit…

Q: 72. In 132 kV system, the phase to ground capacitance is 0.01 µF and inductance is 6H. The voltage…

A:

Q: The p.u. impedance value of an alternator corresponding to base values of 13.2 kV and 30 MVA is 0.2…

A:

Q: Choose the correct answer: In a three-phase system phase shift between a phase current and its…

A:

Q: A 50 Hz, 13.6kv, 3-phase arternator with grounded neutral has inductance of 12 mH per phase and is…

A: Note- As per the Bartleby guideline for the question having more than three sub-part , only three…

Q: The mutual inductance coupling coefficient standard unit is ... * Mho Ohm Henery Unit-less

A: 1. In order to obtain a highly links between two windings the coupling coefficients will be equal to…

Q: The number of disc insulators used in a suspension insulator setup with string efficiency 85 %,…

A:

Q: C1 (ii). Three ldentical capacitors are connected in delta to 435 Volts, F = 50 Hz, 3 phase supply.…

A: we need to finnd out reactance and the capacitor value.

Q: 1. Explain why the phasor and the impedance have the same angle.

A: In the given  question we discuss the phasor diagram  A phasor is a vector that has an arrowhead at…

Q: Define three cases on which real and reactive power flow gets affected. Draw the phasor diagrams of…

A: The three cases on which real and reactive power flow gets affected are as following,   CASE-1 When…

Q: calculate the loop inductance and capacitance of 1 phase line with two parallel conductor spaced…

A: Loop inductamce of the two wire transmission line can be calculated using the following relation L =…

Q: Compute the amount of capacitive reactance  needed to correct  the power factor.

A:

Q: What is the magnitude of the impedance of this circuit element?

A:

Q: 1. A resistor of102, an inductor of o.012H, and a capacitor of 90 µF are connected in series with a…

A:

Q: A microwave with ratings shown in Figure 2 is being supplied with a single phase 120 VAC, 60 Hz…

A: As per the guidelines, we supposed to answer the first three-part of the question at a time so…

Q: c) A four-story office building has a required load of 60000volt amperes and single-phase 240volt…

A: A conductor is an  device that allows the flow of a charge in one or more places. A standard…

Q: (d) A non-liner load is connected to a 110 V, 50 Hz power supply. Determine whether the current of…

A: It is given that: V=110Vf=50Hzharmonic=3rd

Q: Suppose I have two peak phasor voltages, V, = 100245° and V, = 75Z-60°. Circle Your Choices: The…

A: In this question we will find RMS value , frequencies etc of given phasor...

Q: The waveform shown in Fig. 2 represent a common cause of component failure known as

A: as shown in the figure the sudden change in the voltage is occurs and the time for the changes is…

Q: a- Phase angle equal zero b- The applied voltage lead the current by 90°. c- The average power equal…

A: We are authorized to answer the first question since the exact one wasn’t specified. Please submit a…

Q: In phasor representation of alternating quantity, one Complete cycle represents 360° rotation of…

A: Phasors  are used to represent AC quantities in electrical engineering.

Q: A star connected Alternator excitation voltage and terminal voltages per phase respectively are 180V…

A: Alternator: It is used to convert the mechanical energy to electrical power in the form of…

Q: What is the vertical component

A:

Q: 2 The conductors in a single phase ine are 6m above the guünd. Each conductors are spaced 3m a pant.…

A:

Q: j 200 Figure 4.8 E L 10. For the circuit of Figure 4.8, determine the source current and the current…

A:

Q: 72. In 132 kV system, the phase to ground ca- pacitance is 0.01 µF and inductance is 6H. The voltage…

A:

Q: APPLICATION  OF IMPEDANCE AND ADMITTANCE IN AC CIRCUIT

A: we need to answer what are the APPLICATION  OF  IMPEDANCE  AND ADMITTANCE IN AC CIRCUIT .

Q: Draw and explain the phasor diagram for two transformers in parallel.

A: Transformer connection in parallel :  The parallel Operation of a Single Phase Transformer means…

Q: A two-wire DC splitter of 1Km length and resistance of each conductor (m/00030.0) and feeds the…

A:

Q: b. Determine the inductance per km per phase of a single circuit 460 KV line using two bundle…

A: You posted two question at a time.we have limited time to solve your question.you did not mentioned…

Q: The voltage drop across two series – connected units A & B are 60 & 90 Volts respectively . Assume…

A: The solution is given below

Q: Lissajous Choose... Figures Done Choose... STEP UP THE CURRENT STEP UP THE VOLTAGE FREQUENCY PHASE…

A: Need to find correct answer

Q: A phasor is ____________. • a line representing the magnitude and direction of an alternating…

A:

Q: QAMuses two carriers, one in-phase and the other quadrature. Explain?

A:

Q: The series capacitance causes real power loss in the conductor. Select one: O True O False

A: Capacitor is can supply leading VAR to the line and does not consume any real or active power in the…

Q: The mathematical relation between impedance and admittance locus are Reciprocally Opposite Mirrored…

A: Relationship between admittance and impedance Z=1/Y Both

Q: A series circuit consisting of 9 ohm and 50.809mH inductance is connected across 220 volts 60Hz…

A:

Q: What will be the inductance of each conductor in a three phase, 3 wire system when they are arranged…

A:

Q: 29. Obtam FIR Lineas phase and cascade deali zation of the system function - It

A: The transfer function of an FIR system is given. The same can be implemented using delays,…

Nodal Analysis

In the analysis of any electric circuit, nodal analysis is the method of determining the potential difference or voltage between different nodes in an electric circuit. A node is a point where two or more branches connect each other. In the nodal analysis, the voltages are determined in the terms of branch currents. The nodal analysis is also known as the node voltage method or branch current method. The nodal analysis method is one of the several applications of Kirchhoff's Current Law (KCL).