B: Similar to Part A, using 97 mL of an aqueous solution containing 7.22 g of the compound with a KD value of 5, how much of the compound would be extracted in total using two 41 portions of diethyl ether? Report the total mass in grams to two decimal places.

Q: A 300-mL aqueous solution containing a 30.0g of compound A is to be extracted with ether. The…

A: Ether and water are two immiscible liquids. When together, these form two layers with ether on top…

Q: On their second titration trial, the CHM 111 student recorded an Initial titrant volume of 9.95 mL…

A: Given : Initial titrant volume = 9.95 mL And final titrant volume = 29.80 mL

Q: The petition coeficiente between benzene and water for carta iLife is approximately 3.9 .you are…

A: The given question employs the Nernst Distribution Law. The partition coefficient between the amount…

Q: If you have 6.76 g of caffeine dissolved in 57.2 mL of water and the extraction coefficient between…

A: Extraction is a technique by which a compound dissolved in a solvent is extracted into another…

Q: 1. Which of the following can most likely increase the yield of recrystallized benzoic acid?  a. A…

A: Recrystallization is the process of purification of a compound in its purest form by separating the…

Q: 8. Which solution is of known concentration that is used to react completely with an analyte? D.…

A: Standard solution is used to react completely with an analyte.

Q: 1,4‐Dimethoxybenzene (0.642 g) was dissolved in 2.0 mL acetic acid in a 25 mL Erlenmeyer flask using…

A: The given problem is related to green chemistry. Given: Reactants- Mass of 1,4‐dimethoxybenzene-…

Q: Can you proceed with sample analysis even without standardizing the titrant solution? Why or why…

A: “Since there are multiple questions and it is not mentioned that which one has to be solved so I am…

Q: In spectrophotometry, does the sample tested contain the allowable concentration of Allura red as…

A: ✓Allura red occurs as a red-brown powder or granule. ✓It can be used for coloring food, drugs, and…

Q: why would you add 10 mL of concentrate to 490 mL of water if  you were instructed to dilute the…

A: Given : To dilute the concentrate to 1 : 50. And total volume of solution to be made = 500 mL =…

Q: Find the molarity of acetic acid prepared by diluting 34.9 mL of concentrated (glacial, 17.4 M)…

A:

Q: 3. What is the name of the indicator used in the Vinegar analysis experiment? 4. Why is it important…

A: The indicator is a chemical substance which indicates the end point. and percent error represent the…

Q: To determine the amount of copper and the identity of the copper compound in the unknown sample, a…

A: Given that -  Initial volume of the copper sample Solution = 100 mL Mass of copper sample = 120.8 mg…

Q: The distribution constant for iodine between an organic solvent and water is 75. Find the…

A: Given the distribution constant, KD = 75  Volume of aqueous layer(water), Vaq = 100 mL molarity of…

Q: A sample of anhydrous NaHCO3 (FM = 84.007) is suspected to be contaminated with either NaOH (FM =…

A: NaHCO3 is present as the Impurity. Now, mass of Na2CO3 Present = 27.2×10-3×0.0125×4×5×105.989 =…

Q: 1. At the end of a reaction, I ended up with a 200 mL aqueous solution containing 20 g of…

A: To solve these problems, we will be using the following equations: KD=XorgVorgXaqVaq .. (1) Here, KD…

Q: Spectrophotometric Determination of a Metal A 100.00 mL of exactly 250.0 mg/L Cu2+ stock solution…

A: To answer why NH3 is added to each standard solution before diluting with distilled water.

Q: A 2.0 g of MgCO3 was dissolved and diluted to exactly 500-mL volumetric  flask. If 50-mL aliquot was…

A: Mass of MgCO3 = 2g Mol. Mass of MgCO3 = 84g/mol Volume of dilution = 500ml Volume of aliquot = 50ml…

Q: The distribution coefficient, k for a compound “A” between hexane and water is 7.5. What weight of A…

A:

Q: In the preparation of a standard stock solution for protein analysis, 50 mg of bovine serum albumin…

A: Mass of BSA in 10mL solution = 50mg

Q: Determination of the ppm Fe in a water sample using the iron-phenanthroline method. Presence of…

A: Given: Determination of the true concentration ppm (Fe) in a water sample using Iron-phenanthroline…

Q: Why must be the primary standard be dried before use

A: A primary standard is a reference solution used to determine the unknown concentration of another…

Q: 10.00 mL of the Unknown Acid A with a concentration of 0.1505M was placed into an Erlenmeyer flask…

A: Given - Volume of NaOH =20.33 mL Molarity of NaOH =0.2213M To find - millimoles of Sodium Hydroxide

Q: If the solubility of a compound A in ether is 30g/100 ml, and the solubility of A in water is 15 g…

A: distribution ratio(ξ)=concentration of A in etherconcentration of A in water…

Q: Once you calculate KD (KD is 4.0 g/ml),  calculate how much compound would be extracted by mixing…

A: The amount of compound X which can be extracted into the diethyl ether is; KD=X100 mL diethyl ether5…

Q: What is the minimum distribution ratio (Dc) if 98% of the solute in a 25.0-mL sample in an aqueous…

A:

Q: Professor Forni has hired you as a research assistant and you need to make an X-gal staining…

A: Required concentration of MgCl2 = 2mM                                                       = 0.002…

Q: A yellow compound, dissolved in methylene chloride, is added to a chromatography column. The elution…

A: Chromatography is a laboratory method for the isolation of a mixture. In a fluid called the mobile…

Q: An intravenous solution calls for the addition of 25 mEq of sodium bicarbonate. How many milliliters…

A: An intravenous solution calls for the addition of 25 mEq of sodium bicarbonate. The volume of 8.4%…

Q: The distribution coefficient between methylene chloride and water for solute Y is 15.  An amount of…

A: Distribution coefficient simply denotes how a compound is distributed in a mixture of two immiscible…

Q: what is the role of methanol for extracting chlorophyll?   What molecular force holds your…

A: Chlorophyll is a fat soluble hydrophobic compound. Methanol is hydrophobic solvent. Methanol is a…

Q: Calculate the mass percent of the ascorbic acid in the same show full solution Situation: The…

A: A numerical problem based on acid-base titration that is to be accomplished.

Q: ATION

A: Now, Below are the methods mentioned evaluating the steps,

Q: 1.What is the significance when KD is either a small or large value? 2. Methyl alcohol and ethyl…

A: Hello. Multiple questions have been posted. The first question has been solved. To receive solutions…

Q: Which statement is true? Statement 1: In chromatography, the compound mixture moves along with the…

A: Chromatography is the separation method , in which components present in mixture can be separated by…

Q: Why do you need to swirl the flask constantly during the titrimetric analysis? a. To look cool…

A: Titration: It is an analytical method to find out the concentration of a solution with a known…

Q: Iron (III) can be separated from other metals, such as chromium, by extraction into ether from a…

A: The ratio of concentrations of a solute (here it is iron) distributed between two phases( organic…

Q: QUESTION NO. 2: A 0.385 g sample of sodium chloride was assayed by the Volhard method using 50 ml of…

A: Percent of compound in sample: It is defined as the amount of compound determined divided by the…

Q: When the soft drink Jolt is used in place of Coke in the HPLC experiment, the concentration of…

A: The explanation is given below

Q: What is the conversion of 0.50 ft³ to in³?

A: What is the conversion of 0.50 ft3 to In3 ?

Q: which procedure will produce 200ml of a solution that is 2.5%by volume alcohol of water?

A: The percentage by volume of the solution is 2.5 %. The V/V % can be calculated by the following…

Q: 2. When separating acetone (an organic liquid) from LiBr (a solid impurity), which would be the most…

A: Acetone is an organic liquid so it is volatile in nature while LiBr is solid so it is very less…

Q: What is the dilution factor for Sample 1 if 20 µL of extract is added to 980 µL distilled water?

A: Dilution Factor = total volume of solution divided by the aliquot volume

Q: What is the concentration of HI being serial diluted 6 times with a total dilution factor of 106?…

A: Given: Concentration of stock HI solution = 120 mM = 0.120 M                             (Since 1 M…

Q: A compound has a distribution coefficient of 14 between water and diethylether. If 350 mg are…

A: Given the distribution coefficient between water and diethyl ether, K = 14 Here the organic phase is…

Q: Draw flow chart for the extraction of mixture containing         a. Acid and Base

A: Given : mixture of an acid and base.  To find : Draw a flow chart of acid base extraction.  Solution…

Q: 4. In this experiment it takes about 10 microliters of solution to produce a spot 1 cm in diameter.…

A:

Q: Identification Complete each statement. Write your answer at the end of each question. 92. To…

A:

Q: If you have 6.61 g of caffeine dissolved in 72.3 mL of water and the extraction coefficient between…

A: The extraction coefficient can be described as the ratio of the concentration of the substance in…

Q: To which sample solution the spike will be add? the distillate>130C the mass standard the…

A: A spike is  a known quantity  of analyte added to a sample of test solution whether to redponse to…