and i₂. 40 V 12 www www M

Q: A crystal oscillator has these values: L, = 3mH, C, = 0.05 pF, R = 2 kN, and Cp = 10 pF. Calculate…

A:

Q: Consider the unity feedback control system shown R(s) + C(s) G(s) where K G(s) = sn (s+a)

A: The feedback of a unity feedback system is an open-loop transfer function. This type of feedback…

Q: Consider the diode circuit of Figure 1.1. The source voltage Vs = 20 V, the resistances values are…

A:

Q: A coil having a resistance of 25 Ω and an inductance of 150 mH is connected in series with a 80 μF…

A:

Q: A circuit that controls a given digital system has three inputs: x1, x2 and x3. It has to recognize…

A: Given  X1,X2,X3  are digital input . Condition    A  is true only when X3 is true and  ( X4 is true…

Q: Note: Answer (All) questions only Q1: Find The Fourier series for the function defined by 0 < x <4 1…

A:

Q: opic: Input and Output Characteristics of Transistor in Common Base Configuration   Answer in 2-3…

A: CB amplifier is an amplifier sharing a common base the input is given at the emitter and the output…

Q: Determine the monthly energy consumption (kWhr) of the following appliances:

A:

Q: Two coils A and B have, initially, a mutual inductance of 250 mH, and the current in coil A is 2 A.…

A: Given data, The value of current (i)  = 2 A The value of time(T) = 0.2 sec

Q: nd Leq 17 pH Lea ell 72 pH 7 pH ll 4 nH 77 pHE 12 nH 1 nH 14 pH ell ele ell

A:

Q: The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH…

A: Brief description : In the above given question they have mentioned a series RLC circuit. The values…

Q: A three-stage amplifier has stages with the following specifications. Calculate the power gain in…

A: Three stage amplifier The three stages are: First stage-Differential amplifier, Second…

Q: Find the equivalent resistor in following circuit 36 AA 5 10 Ω 10 350 > 20 Ω

A: Given circuit:

Q: AT=5 ps transform-limited pulse propagates in a dispersive medium for which ß2 = 10 ps²/km. Over…

A: Writing the expression for pulse spread,Tp=T2+∆τ2     .......1Here,Tp=pulse spread∆τ=change in…

Q: Consider the following signal: 5 x(n) = 3"+2sin( 1.1 Determine the z-transform X(z) of the signal…

A: Consider the following signal as given below: x(n)=3n+2sin5π6n-π3u(n) 1. We need to determine the…

Q: connected in series. The power being consumed by the 10-ohm resistor is 22.5 watts. Determine the…

A:

Q: A 50 Ω resistance is connected in series with a coil having 25 Ω resistance and 150 mH inductance.…

A:

Q: D THE (a) Logic diagram QDQ(+1) 000 011 100 111 (b) Characteristic table 0

A: Logic gates are divided into seven part . This gate is used in digital electronic, it is based on a…

Q: iv) Find the following line currents, I, I, and I. v) Calculate the following line voltages, Vab,…

A: Since the given system is balanced and Y connected we can analysis it on per phase basis.

Q: Find the transfer function T(s) = x1(s)/F(s) of the given system. x1(t) 8 x2(t) f(t) 14 Imm + 6 + 10…

A: In this question,  We need to determine the transfer function T(s)?  We are solving this problem…

Q: 3) It It Jui Jun R₂ R₂ RV Vo Ru is used to vary the gain. Show that So is given by: Vo = 2 R₂…

A:

Q: Q: Draw output voltage waveform for this circuit if ß-50. +10v +5v -1v Vi 2 3 4 t(ms) Vi AC 50k +10v…

A: We need to find out output voltage for given circuit

Q: Example-6: Two points, A and B, constituting a portion of a two-dimensional shape are moved to…

A: Given,The coordinates of the points are as follows,A=3, 3B=4, 4C=3, 2D=1, 1

Q: Antenna connected to a 150- lossless line, produces a standing wave ratio of 2.6. If measurements…

A: Given characteristic impedance is Zo=150 ohm Standing wave ratio S=2.6 Distance between two…

Q: 4.10) A buck regulator has an input voltage of 12 V and the required output voltage is 5 V. What is…

A:

Q: O F[7:0]=[1011 0010] O F[7:0]=[1011 0111] O F[7:0]=[1100 1001] O F[7:0]=[0011 1001] O F[7:0]=[1001…

A:

Q: The following is given for a series R-L-C circuit: resistor (R) = 8 Ohms, an inductor (L) = 32 mH…

A:

Q: In Figure 2.2 is shown the fixed bias circuit of a Silicon transistor with B = 180. Determine the…

A: We need to find out unknown resistance value for given circuit

Q: A four-pole, three phase, 50Hz, star connected AC generator has 24 stator slots. There are 6…

A:

Q: Given: Questions: 10 2 j4 2 What is I2 ? Answer = ° A I1 I2 E, 3E V. What is I1 ? Answer = ° A What…

A: This problem can be done by using transformer basics and transformation ratio

Q: If an AM modulator has a carrier frequency of 1.1MHz and the input signal has a frequency of 2kHz,…

A: Given data is shown below. For an AM modulator carrier frequency fc=1.1MHz Message signal frequency…

Q: An inductive load consisting or R and X in series feeding from a 2400-V rms supply absorbs 288 kW at…

A:

Q: Solve I1, I2, and I3 using Nodal Analysis. Please explain the first part with the reasons why is it…

A:

Q: which among the h parameter are the least important Choices: hf,ho,hr,hi

A: generally input impedance,output impedance and voltage gain are our major concern while studying…

Q: 1. Use nodal analysis and find the voltages across z1, z2, z3 and z4. Use node A as your reference…

A:

Q: Topic: Input and Output Characteristics of Transistor in Common Base Configuration   Answer in 2-3…

A: The transistor can be configured in three different biasing configurations,  Common-Base…

Q: Find the total number of watts (P), VARS (Q), VA (S), PF, and the current I. Draw the power…

A:

Q: Find the Nyquist rate for the signal: x(t) = 4 sin(10лt) + 3 cos (67лt). Select one: O a. 77 Ob. 134…

A:

Q: Given the following voltages: el = - = -100sin(wt-π/3), e2 = 250cos(wt+ π/6), e3 = 150sin(wt+ π/4),…

A: Polar and rectangular form: Polar and rectangular form is a representation of the point in the…

Q: 4) Vid Vo let vo.

A:

Q: Symmetrical Components 4) Given Va= 10243°, Ub= 142-134°, Vc = 12/110°. a) find Vo,U₁ and V₂.

A:

Q: create block winding diagram with the given winding table on the picture below

A: Here it is asked to create a winding diagram for the given winding table. Z=10 (conductors). P=4…

Q: B. In a series of tests to determine the parameters of an eight pole, three-phase 3300 V, 50 Hz, 500…

A: As per Bartleby policy we can answer only three subparts. Please repost the question again for…

Q: 3. List the losses in SPIM. 4. What are types of SPIM. 5. What are the disadvantages of SPIM. 6.…

A:

Q: Q: Draw output voltage waveform for this circuit if B=50. +10v +5v -1v Vi 2 3 4 t(ms) 50k +10v 10k…

A: We will find out the output for given circuit

Q: 2X a) 12 Cos (ax') dydx

A: The above Integration can be solved by using substitution method.  The solution is given below.

Q: A)- Determine the line currents and phase voltages. *Determine the lamp resistances by Ohm's Law,…

A: Given data, The power consumed by the lamp is 25 Watt. The average voltage VP  is 27.20 V The…

Q: An analog-to-digital (A/D) converter has a 15-bit binary input. The input analog voltage range is 0…

A:

Q: Given a material for which Xm = 4.2 and within which B = 0.4ya, T, for y = 2 find H = Blank 1 a, A/m…

A: Given a material for which Xm = 4.2 and within which B = 0.4ya₂ T, for y = 2   The  values of H, m,…

Q: Q: Draw output voltage waveform for this circuit if ß-50. +10v +5v -1v Vi 2 3 t(ms) 50k +10v -10k…

A: We need to find out output voltage for given circuit

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.