Answered: A 50 Ω resistance is connected in…

A 50 Ω resistance is connected in series with a coil having 25 Ω resistance and 150 mH inductance. The circuit is connected to a voltage source of 200 sin ωt. Calculate the instantaneous current.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter18: Resistive-inductive Parallel Circuits

Section: Chapter Questions

Problem 1PA: Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter...

See similar textbooks

Related questions

Q: An RLC circuit has a resonance frequency of 160 kHz and a Q-factor of 100. Its band width is Select…

Q: In a simple RC high pass filter the desired roll-off frequency is 15 Hz & C = 10 µF. The value of R…

Q: Q3) For the following 8-bit Transmitter-Receiver system; write a VHDL code to check received vector…

A: Q3 VHDL Transmitter code: library ieee;use ieee.std_logic_1164.all;entity UART_Transmitter…

Q: In the circuit in Fig.2. Calculate. (i) The value of C to give resonance. (i) Qp by using…

Q: E(s) R(s) Gp(s) T. Let G(z) = (2-1)(2-0.4)

A: Gz =zz-1z-0.4Dz = KGcz=Dz.Gz D(z) = controller G(z) = open loop uncompensated system Gcz…

Q: Ques. 5: The signal is defined as 0<1<1 x(1) = {0.5+ 0.5cos (27t) [3–t 1si<2 2<1<3 otherwise If the…

A: x(t)→Ex(at)→Eawhere E is energy K.x(t)→K2×E

Q: Find a Boolean expression

Q: Q3 IREF-200μA A VDD=0.9V Q4 Q₁ 26 Q5 Q8 2₁ Vss=-0.9V Fig.2 Q3 [15 marks] A CS amplifier has Cc1=…

A: CS refers to common source amplifer, sourec is shared commonly between the input and the output…

Q: Find the equivalent resistance of following circuit and find the total current (i) 9.00 2.50 40.0 V…

A: Given circuit,

Q: opic: Input and Output Characteristics of Transistor in Common Base Configuration Answer in 2-3…

A: CB amplifier is an amplifier sharing a common base the input is given at the emitter and the output…

Q: In the circuit of Fig.1 find V, if L= 2/0° A. %3D

Q: A function is given by F1 (A, B, C) = Σ? (1, 4, 6) implement using a multiplexer

Q: Determine the overall noise figure for a receiver that has two RF amplifiers each with a noise…

Q: Find the Nyquist rate for the signal: x(t) = 4 sin(10лt) + 3 cos (67лt). Select one: O a. 77 O b.…

A: To calculate Nyquist Rate,

Q: A series RL is supplied by a voltage source of 10 Volts. If the R = 5 Ω and XL = 5 Ω , what is the…

Q: For an LTI system given by h(t) = e-(1/3)tu(t+2) determine whether the following properties hold and…

A: LTI (Linear Time Invariant) System: The linear time-invariant system, or LTI system, is a system…

Q: 5. If electric energy costs PhP20/kWh, how much does it cost to use the following appliances per…

A: In this question we will find total energy cost for given appliances....

Q: write the D.E for he Following system,and 1. find the inverse of ZJ if: XC2) XCK) +) yCK)

Q: Convert the following decimal Real number to fixed point binary: 19.62510 Assume 8 bits for the…

Q: Design a simple application of Inverting, Non-inverting, Unity Follower and Summing Amplifier in an…

A: An amplifier, often known as an electrical amplifier or amp, is a type of electronic device that may…

Q: Find V, in the circuit shown in the figure below using Thevenin's theorem. 2 mA 2 tt 8 mA 12 V

Q: 4.10) A buck regulator has an input voltage of 12 V and the required output voltage is 5 V. What is…

Q: Problem 6 Determine the time-dependent current i (t) through the 2H-inductor. Do this circuit…

Q: draw root locus diagrams for the following two transfer functions. With working that includes real…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: We need to send data 2 bits at a time at a bit rate of 2Mbps for FSK modulation. The carrier…

A: Consider there are n=2 bits at a time and the speed of 2 mbps The frequency of the carrier is 10 MHz…

Q: Q: Draw output voltage waveform for this circuit if B=50. +10v +5v -1v Vi 1 2 3 4 t(ms) Vi AC 50k M…

A: We need to find out the output voltage for given circuit

Q: We want to design a causal discrete-time LTI system with the property where the input is 피(m) =…

A: We want to design a causal discrete-time LTI system with the property where the input is:…

Q: 16 V G2 Determine Vo and I Si Vo 4.7Kl 12V

Q: Vsz Rz Iz RI -+ 3 4 R 3

Q: Class C commutation technique is forced commutation technique complementary commutation technique

Q: An 8-bit Shift-right register has 00001101 stored. 0111 needs to be loaded into the register. The…

Q: Q3: Find the Inverse Laplace Transform of the following functions s3+3s2-s-3 e-S+e-2s-3e-3s+e-6s 1.…

A: Inverse Laplace Transform: The inverse function (X(-s)) is found by multiplying both sides by j and…

Q: Consider a resistor of resistivity 1.52 × 10-8 Ω • m. If an electric field of 18 V/m is applied…

A: Given data, A resistor of resistivity(ρ) is 1.52×10-8Ωm The Electric Field (E) is 18 V/m the value…

Q: 1. From the circuit shown, determine a. Open Circuit Voltage from the load terminal b. Thevenin's…

A: Only the 4th part is asked, but we need part 1 for the solution. So we will solve both 1 and 4.…

Q: indicate which of the signals 1, 2 and 3 of diagram 2, corresponds to the output signal of diagram 1…

A: For the diagram 1, the signal representing in the AM modulator is as follows- Signal [a]= Carrier…

Q: In the figure below, all impedances are in per unit on a common MVA base. The generators are…

Q: find equivalent Impedance, I=? -jian 75 802 Is loft AM www 50L0° عمل m -j5n C Jlos 762

A: Series combination of impedance is: Z=Z1+Z2 Parallel combination of impedance is: Z=Z1×Z2Z1+Z2

Q: 4. For a gated S-R latch, determine the Q and Q outputs for the inputs in Figure 7-73. Show them in…

A: Given A gated SR latch with input waveforms. We can determine its output waveform with the help of…

Q: 2) Design a non-inverting amplifier with a closed-loop gain of Av: S. The output voltage is limited…

A: Non-inverting amplifier: It is an operational amplifier which has output signal is in phase with the…

Q: At resonance Select one: a. magnitude of capacitive reactance > magnitude of inductive reactance.…

A: Ralation between inductive and capacitive reactance at resonance:

Q: c) Explain the difference between the modulator and demodulator blocks and explain the terms…

A: Difference between modulator and demodulator: In the communication system, modulation and…

Q: þesign a 3-bit synchronous binary counter using JK flip-flop and draw the logic diagram of a 3-bit…

A: Given: A 3-bit synchronous binary counter using JK flip-flop having state table in the form: To…

Q: Q3: Consider that the values of parameters for the stop and wait ARQ protocol are as given below-…

A: Given, Bit rate of the transmission channel = 2 Mbps.Propagation delay from sender to receiver = 1…

Q: FIND: Vo i1 i2 i 20V- 1.5K. 12 Si Si Ge Vo www 0.49K i1 www 0.49K

Q: Draw the diagram of a 2-bit asynchronous ripple counter using T flip-flops and a 5-bit ring counter…

A: We need to draw the diagram of a 2-bit synchronous ripple counter using T flip-flops and a 5-bit…

Q: FIND: Vo1 Vo2 i 20V 1k Vo1 SI 4 0.49K Ge Vo2

A: We need to find out current and voltage for given circuit

Q: Design the bias circuit shown below for CS amplifier. Assume the MOSFET is specified to have Vt-1 V,…

A: The direction in which DC from a battery or power supply flows between the emitter and the base of a…

Q: Q5: find the Fourier series of the following equation - 1< x < 0 | f(x) = {x 0 < x < 1 %3D .1 1<x <…

Q: A magnetic circuit made of mild steel is arranged as shown in Fig.3. The cent.ral limb is wound with…

Q: QI: Check the following statements and see which one is true and which one is false. II. Time…

A: (III) Anything that receives a discrete-time signal as input and produces a discrete-time signal as…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

A 50 Ω resistance is connected in series with a coil having 25 Ω resistance and 150 mH inductance. The circuit is connected to a voltage source of 200 sin ωt. Calculate the instantaneous current.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

You are an electrician working in an industrial plant. A 30-hp three-phase induction motor has a current draw of 36 amperes at full load. The motor is connected to a 480-volt line. A three-phase wattmeter indicates a true power of 22 kW. Determine the power factor of the motor and the amount of capacitance needed to correct the power factor to 95. Also determine the minimum voltage rating of the capacitors. The capacitors are to be connected in wye.
QUESTION 3 An inductor and a 330 ohm resistor are connected in series with a function generator. The current is 89.8mA RMS 5kHz. The reactive power is 3.04 var. Find the value of the inductance. O 12mH O 24mH O 6mH O 18mH
3. Sketch the current waveform for the circuit in Figure below. The diac has a breakover potential of 20 V. IH = 20 mA. 25 V rms R 1.0 ΚΩ
A 46-mH inductive coil has a resistance of 10 ohms. How much current will it draw if connected across a 100-V 60-Hz source? 11.66-j9 3-j5 3-j4 5 cis -60
A 2 Henry coil has a 60 Hz voltage connected to it. What is this coll's approximate inductive reactance? O 120 ohms O 967 ohms O 754 ohms O 356 ohms
Calculate the inductance for a coil with 120 turns, a current of 0.47 mA, and a flux of 1.2x10Wb. a S w R lill
A Star 3Phase source with phase voltage of 400V at 50HZ is connected to a delta connected 3Phase AC Motor. The transmisson line resistance from source to load terminal is 1 Ohm. The internal resistance of each winding of motor is 9 Ohm and the inductance of each coil is 38.2 mH. What is the true power delivered to load? O A) 13099 B) 14999 O C) 15099 O D) None
A 10 Ω resistor, a 0.06-henri inductance and a 300 µf capacitor are connected in parallel to an alternating current source with a frequency of 100 Volts 25 Hz. Calculate its impedance d-) Power.
A moving coil ammeter and a moving iron ammeter are connected in series with arectifier across 110V (r.m.s.) AC supply. The total resistance of the circuit in theconducting direction is 60 ohm and that in the reverse direction may be taken asinfinity. Assuming the waveform of the supply voltage to be sinusoidal, calculate thereadings in each ammeter
A solenoid with an inductance of 0.25 H and a resistance of 100 Q is connected to a 120-V 60-Hz source. The current is: Please check the closest answer that applies. X L 120 V 60 Hz O0.226 2-16.3° A O0.224 2-31.2° A LO
If three inductors connected in series 0.06 H,0.05H,0.1H.What would be the inductive reactance of the circuit?Assume The inductors are connected to a 60Hz line?
For the series RL circuit shown in the figure below, answer the following questions and justify your answer.If the current is kept constant, does the coil have inductance?If the current is kept constant, does the coil affect the current value?Can the reverse emf ever be greater than the battery emf?