An unknown amount of a compound with a molecular mass of 270.57 g/mol is dissolved in a 10 mL volumetric flask. A 1.00 mL aliquot of this solution is transferred to a 25 mL volumetric flask, and enough water is added to dilute to the mark. The absorbance of this diluted solution at 355 nm is 0.495 in a 1.000 cm cuvette. The molar absorptivity for this compound at 355 nm is €355 = 6149 M-¹cm-¹. What is the concentration of the compound in the cuvette? concentration: What is the concentration of the compound in the 10 ml flask? concentration: How many milligrams of compound were used to make the 10 mL solution? mass: M M mg

An unknown amount of a compound with a molecular mass of 270.57 g/mol is dissolved in a 10 mL volumetric flask. A 1.00 mL aliquot of this solution is transferred to a 25 mL volumetric flask, and enough water is added to dilute to the mark. The absorbance of this diluted solution at 355 nm is 0.495 in a 1.000 cm cuvette. The molar absorptivity for this compound at 355 nm is €355 = 6149 M-¹cm-¹. What is the concentration of the compound in the cuvette? concentration: What is the concentration of the compound in the 10 ml flask? concentration: How many milligrams of compound were used to make the 10 mL solution? mass: M M mg

EBK A SMALL SCALE APPROACH TO ORGANIC L

4th Edition

ISBN:9781305446021

Author:Lampman

Publisher:Lampman

Chapter93: Refractometry

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Dissolved 0.273 grams of pure sodium oxalate (Na2C204) in distilled water and added sulfuric acid and titration the solution at 70 ' C by using 42.68 ml of KMn04 solution and has exceeded end point limits by using 1.46 ml of standard oxalic acid (H2 C204) with 0.1024 N. Calculate the normlity of KMn04. Note that the molecular weight of sodium oxalate (Na2C204) 134 and its equivalent weight ; 67 *
The distribution coefficient of hydrogen sulfide between benzene and water at 25 degrees Celsius is 5.9880. What is the minimum volume of benzene at 25 degrees Celsius necessary to extract in a single step 80% of the hydrogen sulfide from 1 liter of 0.15 molar aqueous solution of hydrogen sulfide?a.) 0.1336b.) 23.9520c.) 0.6680d.) 1.5030E.) none of the above
The distribution coefficient for X between chloroform and water is 9.6. Calculate the concentration of X remaining in the aqueous phase after 50.0 mL of 0.150 M X is treated by extraction with the following quantities of chloroform: (a) one 40.0-mL portion, (b) two 20.0-mL portions, (c) four 10.0-mL portions, and (d) eight 5.00-mL portions.
A solution is 1.4×10−2 MM in Ba2+Ba2+ and 1.9×10−2 MM in Ca2+Ca2+. Consider that Ksp(BaSO4)=1.07×10−10Ksp(BaSO4)=1.07×10−10 and Ksp(CaSO4)=7.10×10−5Ksp(CaSO4)=7.10×10−5. What minimum concentration of Na2SO4Na2SO4 will trigger the precipitation of the cation that precipitates first?
1- Calculate I (ionic strength) for a solution that is 0.5 molal in KCI and 0.2 molal in K₂Cr₂O7. 2- 1-When A = 1.05 × 10³ m², C(HCI) = 10.0 mol m³, 1=0.01 A for 200 s, x was measured to be 0.17 m. Calculate t (H¹) 3- Calculate the molar conductivities (A) of KCI solution (0.1 mol L¹), if the conductivity of this solution at 25°C is 0.012896 ¹cm¹. 4- Calculate the Molar conductivity of H (..).The lonic Mobilities of H* ions (u) is -36.23 x10*¹ cm² V¹s¹
To keep ionic strength constant and maintain a more consistent matrix in a solution where ions could be influencing each other, another component is often added to the solution This is an ionic compound, not involved directly with the reaction, called an ionic strength adjuster (ISA) ingredient. What is the ionic strength, μμ, of a solution that contains 0.0280 M (NH4)2SO4 as the ISA ingredient?
What is the molar absorptivity and concentration of caffeic acid? Molar mass= 180g/mol the cuvette= 1cm absorbance= 1.98 Started by adding 0.0019g of caffeic acid in 25 mL methanol. This solution was diluted with methanol in 1:100mL, then again in 1:10 dilution.
Hw.22. A 1 mL aliquot of standard KMnO4 solution A (4.0 ppm) gets added to 10 mL of unknown solution B. This 11 mL solution then has an absorbance of 0.312. The absorbance of unknown KMnO4 solution B is 0.326. Calculate the concentration of solution B in ppm. Use simultaneous equations.
2.) A 0.2185g sample of NaCl was assayed using Volhard Method with 50mL 0f 0.0998N AgNO3 and 11.9mL of 0.1350N NH4SCN. Calculate the % NaCl in the sample.
From the data, give 3 potentiometric plots. Show the equivalence point in the 3 graphs.
175.0 mL of 0.10 M C2H5NH2 with 285.0 mL of 0.20 M C2 H5NH3 Cl Express your answer using two decimal places. ΑΣφ ...... pH
[NaCl] / M [NaCl]/ppm Conductivity / μs Potential/mV 0.1 (10-1) 5,850 8610 -32.3 0.01 (10-2) 585 928 20.5 0.001 (10-3) 58.5 102.4 76.9 0.0001 (104) 5.85 14.02 133.3 0.00001 (10-5) 0.585 3.2 172.9 0.000001 (10-6) 0.0585 2.32 181.9 Unknown A 449 26.3 Unknown B 45.4 89.9