Please fast An open tank has a vertical partition and on one side contains gasoline with a density p = 800 kg/m3 at a depth of 9.5 m, asshown in the figure below. A rectangular gate that is 9.5 m high and 2 m wide and hinged at one end is located in the partition.Water is slowly added to the empty side of the tank. At what depth, h, will the gate start to open?Assume h, = 9.5 m.PartitionStop-h,WaterGasolineHingeConcepts: The pressure in a fluid is a function of the specific weight of the fluid and the height relative to a reference.Pressure is constant on horizontal planes of a continuous mass of fluid.Sum of the moments is zero for equilibrium(a) What is the specific weight of the gasoline?(b) What is the force of the gasoline on vertical gate?(c) Where does the force of the gasoline act with respect to the hinge?(d) What is the moment of the force of the gasoline around the hinge?(a) y = iN/m3(b) F = ikN(c) h = i(d) M = ikN-m

An open tank has a vertical partition and on one side contains gasoline with a density p= 800 kg/m³ at a depth of 9.5 m, as shown in the figure below. A rectangular gate that is 9.5 m high and 2 m wide and hinged at one end is located in the partition. Water is slowly added to the empty side of the tank. At what depth, h, will the gate start to open? Assume h = 9.5 m. Partition Stop. Water h Gasoline

An open tank has a vertical partition and on one side contains gasoline with a density p= 800 kg/m³ at a depth of 9.5 m, as shown in the figure below. A rectangular gate that is 9.5 m high and 2 m wide and hinged at one end is located in the partition. Water is slowly added to the empty side of the tank. At what depth, h, will the gate start to open? Assume h = 9.5 m. Partition Stop. Water h Gasoline

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

8. An open tank has a vertical partition and on one side contains gasoline with density 700 kg/m' at depth of 4 m, as shown in fig. (2.8). A rectangular gate that is 4 m high and 2 m wide and hinged at one end is located in the partition. Water is slowly added to the empty side of the tank. At what depth, (h) will the gate start to open. Partition Stop Gasol ne Water Hinge Figure (2.8)
Ethanol with a density of 789 kg/m moves through a constricted pipe in steady, ideal flow. At the lower point shown in the figure below, the pressure is P, = 1.90 x 10“ Pa, and the pipe diameter is 7.00 cm. At another point y = 0.35 m higher, the pressure is P, = 1.10 x 104 Pa and the pipe diameter is 3.50 cm. P (a) Find the speed of flow (in m/s) in the lower section. m/s (b) Find the speed of flow (in m/s) in the upper section. m/s (c) Find the volume flow rate (in m/s) through the pipe. |m³/s
J- The tank shown has the form of a frustum o a cone. How long will it takes to empty the tank from full capacity? Orifice diameter is 0.10m C = 0.60. 2m
Q3/ A) Five Liquids of different specific gravity G are put in an open Tank shown in Figure (3). The Liquids are: Liquid No. (1) is Mercury, G# = 13.6 Liquid No. (2) is Heavy Oil, GH.o = 0.9 Liquid No. (3) is Sea Water, G,w =1.08 Liquid No.(4) is River Water, G =1 Liquid No. (5) is Solution, Gs = 1.2 Write the Number of each Liquid in the correct place in the Tank Mention the reason of that. %3D %3D Fluid No. ( Fluid No. ( Fisid No. ( Flsid No. ( { Fleid No. (
A 5-m container having the dimensions 1.2x1.2 m² has a sharp-edge orifice 100mm located at its side 400mm from the bottom. It contains water 3m deep when it is at rest. When the volume of water in the tank is kept constant and C = 0.60, determine the discharge in the orifice when the vessel a) is at rest, b) has moved with a velocity of 8 m/s opposite to the jet, and c) has a constant acceleration of 4.905 m/s² opposite to the jet.
An oil of density 892 kg/m³ is flowing in a pipe having an internal diameter 5cm. This pipe is connected to another one with diameter 7.5cm which branches into two smaller pipes each one having a diameter of 3.75cm. If the flow rate in the first pipe is 1.388 x 10 m³/s, calculate: a- The mass flow rate in the first pipe and in the branches of the second pipe. b- The average velocity in the first pipe and in the branches of the second pipe.
1. A car ferry is essentially rectangular with dimensions of 8 m wide and 100 m long. If 60 cars, with an average mass per car of 1400 kg, are loaded on the ferry, how much farther will it sink in water? A. 32.5 cm oz C. 15.6 cm SED. 10.5 cm B. 20.8 cm 2. If the pressure at a point 1.8 m below a certain liquid is 27.5 kPa, what is the specific gravity of the liquid? A. 1.632 C. 1.321 B. 1.455 D. 1.557
An closed cylindrical tank 4 m in diameter and 10 m high contains 4 m of oil sg = 0.9. An orifice 100 mm in diameter islocated at the bottom of the tank Cc = 1.00 and Cv = 0.97. Compute the time to discharge all the oil.
Q4 A pump is used to circulate the water from the lower to the upper reservoir through a pipe system shown in the figure below. The difference in elevation between these reservoirs is 200 m. find the head delivered by the pump and its power if the discharge is 100 L/s? KL = 1.0 "exit Pump KL = 1.5 elbow = 5.0 Pipe length 500 m Pipe diameter 0.25 m K₁=0.8 Pipe roughness=0.004 m HKL
An open cylindrical tank 2m in diameter and 4m high contains water to a depth of 3m. It is rotated about its own vertical axis with a constant angular speed w. If w = 4 radsec, what is the volume of liquid spilled? Unit of the Correct Answer: rpm An open cylindrical tank 3m high and 1.5m in diameter contains 2m high of water. If the cylinder rotates about its geometrical axis, what constant angular velocity can be attained without spilling any water? Unit of the Correct Answer: rad/sec
Three liquids given the following properties are poured into the cylindrical container with a diameter of 3 meters and a height of 6 meters. First fluid poured: sg = 1.0 , V = 17.6715 m^3 Second fluid poured: sg = 0.81 , V = 10.6029 m^3 Third fluid poured: sg = 2.94 , V = 7.0686 m^3 Assuming that the container is closed after pouring the fluids and the stable state in the container is reached, determine the pressure at the height of 4-m from the bottom of the tank
A circular vessel 2m in diameter and 3m high is one third filled with liquid A having specific gravity of 1, one third filled with liquid B having a specific gravity of 2 and the remaining one third filled with liquid C having a specific gravity of 3. At the bottom of the vessel is a 900 cm2 standard circular orifice. Find the total head of the liquid in the container. C = 0.60 SHOW FIGURE/DIAGRAM