An electric motor with a mass of 20 kg is placed in the middle of a beam that is jointly connected on both sides. Rotor its unbalance is equivalent to a mass of 0.3 kg at a distance of 0.020 m from the axis of rotation. Due to the electric motor force acting on the beam t Sin F F  0 . The rotor is rotating at an angular speed of  = 40 rad / sec. Engine under the influence of force Find the displacement amplitude at the point where it is located (in the middle). The beam mass will be neglected. The beam has a modulus of elasticity E = 200000000000 N / m2 (200 GPa).

Q: train of mass 200 tonnes moves on a level track having a track resistance of 85 Newtons per tonne.…

A: Given:m=200 tonnesF=85 N/tonnePower, P=320 KW

Q: 8. The linear impulse (1) of the force F- (30) N for t-4 seconds is: a. 40 N.m b. 20 N.m c. 16 N.m…

A: Given data: The time is, t=4 s. Write the given expression. F=3t

Q: A body of dimension 2.0 m x 1.0 m x 3.0 m weighs 3924 N in water. Find its weight in air in N.…

A: Given data,  Volume V= 2*1*3=6 m3  Weight in water w= 3924 N

Q: 5) Find the horizontal displacement of the floor (mass m) of the building frame shown in Fig. when…

A: Given that ,  m=2000kgk=0.1MN/mω=25rad/sxg¨=100sinωt mm/s

Q: A thin rod initially lies at rest along the x axis with one end at x = -1.7 m and the other end at x…

A: Density function,λ(x)=0.6x4+3.6x2Now,Mass of rod,m=∫-1.72.3dmm=∫-1.72.3λ(x).dxwhere,dx is length of…

Q: A Locomotive starts from rest and pulls a train, weighing 20 X 106 N down a 1per cent grade. The…

A:

Q: A 2, oz tennis ball is traveling with a velocity of 110i mph when struck by a tennis racket. As a…

A:

Q: Torque and Power Diagrams The brochure of the same passenger car contains the following data, too:…

A: Given data: 1st gear has a reduction of 3.5 2nd gear has a reduction of 2 3rd gear has a reduction…

Q: A 9 kg weight is attached to a spring with constant k = 144 kg/m and subjected to an external force…

A:

Q: Q2: A shaft is driven by a motor which exerts a constant torque while the load taken off the shaft…

A: Given data: The maximum fluctuation energy in one cycle is ∆E=242 N·m. The mean speed of the shaft…

Q: At x = 3 cm, what is the kinetic energy in the mass-spring system? Select the correct answer 16 I

A: Given   Deflection, x = 3 cm Assume   Spring stiffness, k = 27.77 kN/m Find  Kinetic energy, E

Q: A car weighing 500 kg moving with a speed of 10 m/s takes a turn around a circle with a radius of 25…

A:

Q: A mass weighing 24 pounds, attached to the end of a spring, stretches it 4 inches. Initially, the…

A: Let mass attached=m Spring constant of spring =k Apply Newton's second law for the system ,…

Q: DTATING . ·- A 8-kg mass starts out rotating on the enc a 0.5 m massiess arm at v=1.5 m/s in a…

A:

Q: 3. An undamped spring-mass system has a mass that weighs 48 lb and a spring constant 0.5 lb/in. The…

A: This question is related to the spring-mass system. The elastic vibration wherever there's no…

Q: ng a mass of 1000 kg is driven into a brick wall in a safety test. The bumper behaves like a spring…

A: Given, mass of automobile,m = 1000 kg Spring constant, K=4.45×106N/m Compressed length,x = 2.84 cm =…

Q: A motor drives a flywheel having a moment of inertia of 5 kgm². The speed increases from 1600 r/min…

A: Given:- Moment of inertia(I)=5Kgm2 Initial speed=1600rpm Final speed=1800rpm Time(t)=10 sec To…

Q: mA = 150 kg mB = 200 kg mC = 100 kg mD = 250 kg rX = rY = 250 mm Then the magnitude of the balance…

A: There may be unbalanced forces in any system having a rotating or reciprocating element due to the…

Q: 3. An oscillator is subject to an external driving force F(t), which is an exponentially decreasing…

A:

Q: A gyroscope is pulled with a 30 cm long string.  The string is wrapped around a 2.0 mm diameter axle…

A:

Q: A constant couple C = 200i + 300j + 350k N · m acts on a rigid body. The unit vector associated with…

A: Magnitude of angular displacement dO=(0.25)2+(0.35)2+(0.903)2=1.0002 rad ≈ 1 rad  For angular…

Q: 4. In an amusement park rocket ride, cars are suspended from 4.25-m cables attached to the rotating…

A: Given Cable length = 4.25m Radius of structure = 6 m Angle of swing = 45o Mass of rocket = 75 kg To…

Q: A rotating shaft has four masses m,m2,m3 and ma are 160 kg, 305 kg, 280 kg and 255 kg respectively.…

A: Given: Masses,m1=160kgm2=305kgm3=280kgm4=255kgAngular position of the…

Q: Q2 A flywheel of mass 4 Kg and radius gyration of 0.5 m runs at a speed of 600 rpm with a variation…

A: Maximum fluctuation in energy is given by  Emax= I w2Cs I - moment of inertia, w(omega) - speed, Cs…

Q: An open circular cylinder of 20 cm diameter and 120 cm long contains watr up to a height of 80 cm.…

A:

Q: • A steel cable whose cross-sectional area is 2.5 cm² supports a 1000-kg elevator. The elastic limit…

A:

Q: 1. The equation of motion for forced oscillations is given below. Then, the rate of doing work (in…

A: 2d2xdt2+2×12dxdt+40x=12cos12t2d2xdt2+24dxdt+40x=12cos4t on comparingMx¨+cx˙+kx=Fcosωt som=2 kgC=24…

Q: 20. A Wind Generator with the following data is installed at a wind site. Upward wind velocity: 14…

A:

Q: A car wheel with a radius r=0.40 meters rotates at 8 rad/sec. Find the distance travelled in 50…

A:

Q: show a derivation of the kinetic energy rotation about a fixed axis by proving an equation of T=1/2…

A:

Q: In the system shown in the figure, the spring stiffness k = 2 × 103 N/m and the total massof the…

A: a) The free body diagram at the instant t, the mass system displaced x distance from the initial…

Q: A truck and trailer must be able to accelerate at 0.3 m/s2 up an incline of 1 in 20. The truck’s…

A: Given, Slope = 1 in 20 a = 0.3 m/s2 T = 900 Nm mt = 12000 kg mtr = 9000 kg

Q: The coefficint of friction is A 3.0 kilogram block is sliding down a 25° incline at a constant…

A: Mass of a block, m=3.0 kgInclination angle, θ=25o

Q: State whether the following statement is True or False: 1- Moment of inertia tells us how the energy…

A: Given: There are six statements and we have to tell whether the statement is true or false.

Q: This equation is called Kutzbach criterlon for the movability of a mechanism having plane motion.…

A: AS per expert guide lines we are supposed to answer only first three parts of a solution .

Q: Q4. The 3-kg ball is connected to a spring with spring constant k = 160 N/m and unstretched length…

A: Given data: m=3kgk=160 kgxi=0.6 mxf=1.5 mF=240 N Need to determine the work done by the spring.

Q: A runner lands on her front foot with a force of 2043 N acting at 0 = 70 degrees to the horizontal.…

A: As given that front foot force =2043 N, with the inclination of θ=70 with the horizontal  the…

Q: The position of a 2 kg object is given as r(t) = Bt² + 5, where z is in meters and t is in seconds.…

A:

Q: A couple moment M of magnitude 4 N•m is applied to a gear. Which of the following is the rotational…

A: Given,  Magnitude of the couple , M = 4Nm No. of revolution of the gear , n =1

Q: When the force F = 2i + 9j + 5k N acts on a spherical body with a mass of 5 kg for 2 seconds, it…

A: Solution:

Q: PROBLEM 2.4 A car travels at 24.0 m/s north for 40.0 min and then shift east and travels at 30.0 m/s…

A: Car's displacement is 6.79 x 104 m.

Q: Determine the equivalent spring constant of the system where the spring will be located in the…

A: Equivalent mass wrt mass mKinetic energy of the system12Meqx˙2=12mx˙2+12I0θ˙2+12Isα2

Q: 20 sin(@t) A B D 150 225 225 75 N 50 N K = 2,5 kN/m C= 33 Ns/m

A:

Q: Q) A )A shaft carries five masses 1, 2, 3 , 4 and 5 are attached to a shaft and revolve in the…

A:

Q: 2- find the center of mass, the velocity of the center of mass, the momentum the kinetic energy of…

A:

Q: Figure 2 G 0.75 m B 2 m 1.5 m Figure 2 shows a 2000 kg lorry with a center of mass at G. Starting…

A: 5) option D is correct All of the is correct 6). For constant acceleration, V^2=u^2+2*a*s…

Q: Given: A= 5i + 4j + 6k lbm B= 2i + 4j + 9k kgm C= 20i + 20k N Find the orthogonal component of A to…

A:

Q: Find the value of heat, efficiency rate, work in 68 spin and power in 0.87 second if an engine…

A: Givenn=68 spint=0.87sQ=3760J/spinW=547J/spinPart 1W=-200J -ve for work done on the systemQ=100J +ve…

Axial Load

When a bar of the uniform cross-section is acted by a load, such that the load acts along the longitudinal axis of the bar, such kinds of loadings are known as axial loadings. In general terms, a load is an external force acting on a component. An axial load acts perpendicular to the geometric cross-section of the component. Based on the direction of the application of the load, an axial load can be tensile or compressive. The analysis of bodies under the action of axial loads is generally studied under the branch of mechanics, known as statics.