An AC series circuit has a load of 100 ohms, 0.5 henry and 10 millifarad and being supplied by a sine wave voltage of 100sin(10t). Calculate the total impedance, total current, voltage drop of the resistor, inductor and capacitor. also the plot phasor of the current and voltag

An AC series circuit has a load of 100 ohms, 0.5 henry and 10 millifarad and being supplied by a sine wave voltage of 100sin(10t). Calculate the total impedance, total current, voltage drop of the resistor, inductor and capacitor. also the plot phasor of the current and voltag

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: Exercise 2: Resistances connected in Series-Parallel across a Sinusoidal AC Supply Calculate the…

A: In the circuit, pure Resistances connected in Series-Parallel across a Sinusoidal AC Supply We are…

Q: if the sinusoid is expressed as V=Vsin (ot + 6), what is the value of in degrees? Note that the…

Q: Q Find the capacitance C necessary to improve the power factor to 0.95 lagging in the circuit shown…

A: Z = 20∠30°Z = 20(Cos 30°+j Sin 30°)Z = 20 32+j2Z = 103+j 10ΩBoth branches are parallel,Total…

Q: Consider the following circuit consisting of an AC generator V-V.sin(et), a capacitor C, an inductor…

A: Given circuit diagram is shown below. Here the AC generator is V=Vosinωt Volts. We need to find the…

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A: The solution is given below

Q: Question 5 If a current 5.0 A lags the applied voltage 230 V by an angle o, it can be resolved into…

A: The solution can be achieved as follows.

Q: Find the ff. on the AC circuit below having a 120Vrms as a signal source V1. a.) Total Impedance ZT…

A: Disclaimer: Since you have asked multipart questions, we will solve the first three subpart for…

Q: A DC-DC Chopper Circuit with an RL Load has an output current waveform shown below with a duty cycle…

A: In the question, Find the source voltage if output current waveform is given. Duty cycle=50%…

Q: ) A 200mA, 50Hz AC current source (of negligible output impedance) is connected across the same RL…

Q: ELECTRICAL CIRCUIT: Solve the problem and show your complete solution. The maximum values of the…

Q: A series circuit consisting of a 50 – ohm resistor, 0.5 – henry inductor, and a 100 – microfarad…

Q: A coil has an inductance of 478µH. What is its reactance in 1000Hz ac circuit? 3.00ohms if connected…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: A 50 Hz, alternating voltage of 150 V (rms) is applied independently to:

A: Vm=2Vrms =2×150Vm=212.13 V a- For purely resistive, phase angle- ϕm=0 i=Imsinwt=Im sin…

Q: The waveforms below represent one full cycle of the applied voltage vs and the supply current is.…

A: We can tell phase nature of waveforms by observing their peak positions with respect to time.

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

Q: 1. What is the phase relationship between R, L, and C components in a series AC circuit? 2. What is…

A: The solution is given below

Q: An AC voltage of 230 v is applied to a circuit consisting of a resistance of 10 ohms in series with…

Q: V=100*sin(wt-75°), i=5*sin(wt-45°) V=100*sin(wt+35°), i=5*sin(wt+35°) V=100*sin(wt+20°) ,…

A: The given expression is- V=100×sinωt-75°, i=5×sinωt-45°V=100×sinωt+35°,…

Q: 1) For the circuit given in the figure (a) Draw the voltage and current reflection diagrams. (b)…

A: For the circuit given in the figure a)draw voltage and current reflection diagram b)plot voltage and…

Q: A 120V adjustable frequency ac source is connected in series with a resistor, an inductor, and a…

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A: In this question, Find the total impedance Z = R+jX Current in the circuit I. Write the waveform…

Q: Draw the sinusoidal waveform of the AC voltage and current for the given loads below. Describe the…

Q: -j3N Is IL IR Vc Vs j6n 3 ViR 120 Figure QI(b) (b) An ideal voltage source is connected with one…

A: In this question, Ideal voltage source and frequency is supplied to the capacitive and inductive,…

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as show in Figure…

Q: What is the frequency in Hz =____________________ What is the angular frequency =__________________…

Q: ow do we figure out what our phase relationship in a series reactance and resistive circuit?

A: Question How do we figure out what our phase relationship in a series reactance and resistive…

Q: A load is connected across a 25,000 Volts, 60 Hz source and draws a current of 90 A rms. If the…

Q: 2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b)…

A: Given

Q: A capacitor is connected to an AC source, the current is a) leading or lagging? b) by many degrees?…

A: In this question we will write about inductor ans capacitor voltage and current relationship and…

Q: (b) Referring to the waveforms shown in Figure Q1(b), 60 A 60° -20 V. Figure Q1(b) (i) Sketch the…

Q: Describe what happens to the power in this RLC series circuit as the capacitance decreases. Explain…

A: Given: A series RLC circuit as shown below and a table for real power, reactive power, power…

Q: An impedance coil having a resistance of 15 ohms and an inductance of 0.08 henry is connected in…

A: Given -: All the resistance, inductance & capacitance are connected in series hence the same…

Q: Q2. A series of motor (Load 1) and lighting (load 2) are connected to an AC source as shown in…

A: As per Bartleby guidelines we are allowed to solve only three subparts, please ask the rest again.

Q: 2. Refer to the Figure 2. a) Determine the total impedance of the circuit in polar form. b)…

A: In this question, Voltage Vs and current I phasor are given. Find the total impedance Z? We know…

Q: If a current 5.0 A lags the applied voltage 230 V by an angle o, it can be resolved into two…

Q: What is the peak current in a AC circuit with a 50 ohm resistor, 3.3 mH inductor, and a 480 nF…

A: This is the series RLC circuit and concept of resonance Use fundamental formulas

Q: VBR VRY VYB Figure Q1 (a) Q1 (a) Calculate the percent voltage unbalance for the phasor form in…

A: symmetrical components is analysis power in unbalanced system . symmetrical components is used in…

Q: An AC circuit has a frequency of 400 Hz. A 16-Ω resistor, a 0.0119-H inductor, and a 16.6-µF…

A: Given data are: f=400 Hz R=16 Ohms L= 0.0119 H C = 16.6 Micro Farad The…

Q: (c) Figure 2 shows an AC circuit with the following components: L1 = 100mH, R1 = 1000 and C1=100µF.…

Q: Q1: Explain in detail, the power factor and its value for the following AC circuits ahown figure…

A: To solve above problem, one should have basic idea about working of AC circuits. In ac circuits…

Q: Q2. Assuming a sinusoidal source and a uniform load current, analyze the following circuits, draw…

A: To draw their waveforms and mathematical relations for each circuit

Q: 1. a) Sketch the phasor diagram, using current as the reference phasor, for a load consisting of a…

A: given data:

Q: For the ac network of Figure Q5, calculate the following; i. The total impedance; ii. The inductance…

Q: A telephone receiver has an impedance of 306 ohms at 800 cps and a resistance of 60 ohms. For what…

Q: Q.3: A non-sinusoidal voltage source (e,-10+15sin1000t- 100cos2000t-75sin3000t) Volt is applied to…

A: When more than one frequency components are present in the input supply and given to RLC circuit…

Q: FET: Plot the plot the AC & DC load line and Find the Q point. IDSS = 5 mA VGSOFF = - 5V

A: The given circuit diagram is shown below, Here,IDSS=5mAVGS(off)=-5V

Question

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor, and a 4 capacitor. (a) Draw the circuit diagram. (b) Compute the series impedance. (C) Determine the current I delivered by the source. Is the current lagging or leading the source voltage? What is the power factor of this circuit?
A resistor & a capacitor are connected in series across 230V, ac supply. The current taken by the circuit is 4 A for 50 Hz frequency. The current is reduced to 2 A, when the frequency of supply is decreased to 40 Hz. Determine the value of resistor & the capacitor.
TOE This is a photo of a capacitor that corrects the power factor in an AC setup, in DC it is used in electronic board for appliances and other small devices. Tell me something about this photo.
Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
The below figure shows the waveform of the voltage and current in a purely inductive AC circuit. Voltage Current Using the voltage phasor as the reference, the current phasor Lags by 90° Is in phase with the voltage Leads by 90° Lags and then leads by 160°
A sinusoidal voltage has a value of 100 volts at 2.5 milliseconds and completes one cycle.It takes 20 milliseconds. Then find the maximum cost and the time to reach it for the first time
1. Enumerate five formulas for five series connected inductances across Vt source and draw the circuit. 2. Enumerate five formulas for five parallel connected inductances across Vt source and draw the circuit.
An inductor of 150hms and resistance of 10 Ohms are connected in series to a 230V, 50 Hz ac supply. Determine the active and reactive power and power factor in the circuit.
4) Determine the value of voltage across resistor and capacitor5) Convert in rms values
A 230 V, 50 Hz a.c. supply is applied to a coil of 0.06 H inductance and 2.5 resistance connected in series with a 6.8 F capacitor. Calculate impedance and power consumption and power factor. Now ,In above a.c. circuit, A inductor of 0.2H is connected in parallel with the power supply, find new power factor and power consumption.
A)For the inductive element of Figure 2 , the voltage and current in phasor form is B)the value of impedance and capacitance for capacitor in figure 2 is