Answered: Q.3: A non-sinusoidal voltage source…

Q.3: A non-sinusoidal voltage source (e,-10+15sin1000t- 100cos2000t-75sin3000t) Volt is applied to the circuit shown beside. Determine the total dissipated power in the circuit? 50 5mH 50μF

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter2: Fundamentals

Section: Chapter Questions

Problem 2.7P: Let a 100V sinusoidal source be connected to a series combination of a 3 resistor, an 8 inductor,...

See similar textbooks

Related questions

Q: A non-sinusoidal voltage (e=20+15sin1000t+ 10sin3000t+5sin4000t) Volt is applied to the circuit…

Q: H.W E = 12 V For the network determine the sinusoidal Expression for the voltage V; using…

Q: 680. Given a sinusoidal voltage source in series with R,L, and C. The sin voltage source has a…

A: RLC series circuit is given

Q: Question 5 If a current 5.0 A lags the applied voltage 230 V by an angle o, it can be resolved into…

A: The solution can be achieved as follows.

Q: If voltage and current waveforms of the circuit given in the figure are v = 120 sin(314t) and i =…

Q: [ Prob. 3] The voltage is = 20 sin ( 377t + 15 ) volts %3D and the current is = 4 sin ( 377t - 15 )…

A: if the source waveform is of the form vm sin( wt ) than w is the frequency in rad/sec. active power…

Q: Given the circuit shown below while assuming a sinusoidal steady state, 500 250 0 2 A 10 V1 •j 50 0…

Q: A impedance of Z = 2553.13°Q is connected across a source with a voltage of 169.706 sin (157.080t)…

A: f) To find the simplified power waveform equation

Q: Q3: If v = 40 V at a=30° and t=1 ms, determine the mathematical expression for the sinusoidal…

A: Given, v=40V a=30 t=1ms

Q: Q4: For the network in Fig.below and the applied signal: a. Determine the sinusoidal expressions for…

A: Given : In the question they have mentioned an electrical circuit having voltage source and…

Q: What is the equation of the current in B in the function of sin given that Two electric devices A…

Q: (d) Calculate the following for the AC signal V(t) - voltage at time t (seconds) given by the…

A: The solution is given below

Q: 2. What is the value of a sinusoidal voltage at 5 us (micro second) from the positive going zero…

A: 2) To find the value of a sinusoidal voltage at 5 microseconds Given: Vp = 20 v and f = 50 kHz

Q: Implement the given circuit as shown using Falstad Simulation. R Find the RMS Voltage across the 15…

Q: The following circuit is powered by a polyharmonic voltage whose expression is: v(t) = 100+141.sin…

A: Given:V(t)=100+141sin(1000t)+70.7sin(2000t) V(t) contains three frequency voltage, response for each…

Q: The sinusoidal voltage source in the circuit below operates at a frequency of 50 Hz. Match a value…

A: In the given question we have only resistors in the registers we don't have any significance of…

Q: 7. A source of 100 Volts rms is supplying a resistance 80 ohms in parallel with a 200mH inductor. To…

Q: 1µF Is(t) Find a value of inductance less than 100 Henries, which ensures that the current, Is(t),…

Q: Q3(a) Given the sinusoidal voltage v(t) = 50 cos(30t + 10°) volts, determine: (i) the amplitude Vm,…

A: Given, The sinusoidal voltage vt=50cos30t+10° V

Q: Example: For the circuit shown, if the applied non-sinusoidal e=150sin1000t+100sin2000t+75sin3000t…

Q: Given an AC source having a voltage v(t)=28sin(305t + 30°) V, find the frequency of the voltage…

A: we need to find out frequency of the voltage waveform.

Q: Two loads are connected in parallel to an AC source and take effective currents of 10Amp and 40Amp…

Q: Q3) An 880VA, 220V, 50Hz, load has a power factor of 0.8 lagging. What value of parallel capacitance…

Q: 4. If voltage and current waveforms of the circuit given in the figure are v = 120 sin(314t) and i =…

A: Given V = 120 sin(314t) and i = 10 sin(314t + π/6)

Q: 1 k2 + VL 1 µF Vs Z0 In the above figure the source frequency is 1000 rad/sec and the amplitude of…

Q: a) For the sinusoidal AC voltage, v(t) = [6 sin(500t) + 2] V, determine the following: (i) peak to…

A: GivenV(t)=6sin(500t)+2 v

Q: is FIG.

Q: 1.Under dc conditions ,find the energy stored in the capacitors. I ka ww- 30 µF sov 20 aF 6 kQ…

A: For DC conditions capacitor acts as open circuit. So replace the capacitor with open circuit and…

Q: 1 Xc = waC V = IX XR = R X = waL First consider an AC voltage source with a driving frequency wa and…

A: The voltage drop across resistor is the product of current flowing through it and the resistor…

Q: A sinusoidal voltage with maximum value (336 V), and a Frequeney its value (50 Hz), was applied on a…

A: As per the guidelines given to us, we can only provide the solution of first three subpart in multi…

Q: A building with inductive loads has an average consumption of 40kW and 26 kVAR. What is the average…

Q: 1. Fill in the table by converting the values into the equivalent forms. Unless otherwise specified,…

A: In this question we will convert given quantities to other asking form.....

Q: (2) A certain alternating voltage is described by the equation : v = 170 sin 628 t volts = Vp sin w…

A: Compare the given equation with the standard equation V=vpsin ωt volts

Q: FN.Q3- In the RLC circuit, vs(t) = 330.Sin(628t) Volt, R= 470, C=220µF andL=65 mH. Determine the…

Q: Volts 20 10 5 10 15 20 25 30 35 40 45 50 t (ms) -10 - -20 Given the above graph. Which general…

Q: If a current 5.0 A lags the applied voltage 230 V by an angle o, it can be resolved into two…

Q: Given a sinusoidal voltage v(t) =200cos(377t + 30degrees) volts. What is the smallest positive value…

A: Sinusoidal signal is a periodic signal. The signals which repeats itself after a certain period T…

Q: A sinusoidal voltage with maximum value (336 V), and a Frequency its value (50 Hz), was applied on a…

A: Since we only answer up to 3 sub-parts, we’ll answer the first3. Please resubmit the question and…

Q: For a source which has: • Vrms = 345 V • P= 8195 W • pf = 0.95 What is the rms current?

A: In this question we need to find RMS current .

Q: SCR SCR U1 U2 V1 LOAD •R V SCR SCR U4 U3

Q: i need the answer quickly

Q: using the circuit below. if Vth = 40 Volts and Rth = 130 Ohms. Rth ww Vth Current flowing through RL…

Q: In a linear circuit, the voltage source is v, = 12 sin(10°t +24°) V (a) What is the angular…

Q: Q2. Assuming a sinusoidal source and a uniform load current, analyze the following circuits, draw…

A: To draw their waveforms and mathematical relations for each circuit

Q: Given a sinusoidal voltage source in series with R,L, and C. The sinusoidal frequency is 600 Hz. R=2…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Given V, = 20 sin(@t + 60°) and V, = 60 cos(wt – 10°) . What is the phase angle %3D between the…

A: To solve above problem, one should have clear understanding of phasor quantities: In practical…

Q: (b) Why sinusoidal wave is widely used? Calculate real power, reactive power, apparent power, power…

Q: A series circuit of RLC with following parameters, R=15 ohm, L-20 m H Farad. VT=169.7 sin (337t-30)…

Concept explainers

Coulomb’s Law

Coulomb's law states that the attraction or repulsion force between two charged things is proportional to the product of their charges and inversely proportional to the square of their distance. It has an effect along the line that connects the two-point charges.

Question

I need the answer as soon as possible

Q.3: A non-sinusoidal voltage source (e,-10+15sin1000t-
100cos2000t-75sin3000t) Volt is applied to the circuit
shown beside. Determine the total dissipated power in the
circuit?
5mH
50μF

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Shown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
Shown in the figure below is an "RC" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 11.58 Volts and is running at a frequency of f = 1.326e+04 Hz. resistor has a resistance of R = 3750 2 and the capacitor has an capacitance of C = 3.17e-09 Farads. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit tot = Determine the numerical value of Ztot = Determine the numerical value of Pztot= Determine the current through the circuit: • I(PEAK) = • I(RMS) = Determine the voltage across the resistor: Amps Amps S2 C degrees
The source in the circuit shown is a sinusoidal source. The supply voltages across various elements are marked in the figure. The input voltage is: 3V- ww -14 V-10V moon It
Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of using a single 14 V dc voltage source.
60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?
Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source.
The below figure shows the waveform of the voltage and current in a purely inductive AC circuit. Voltage Current Using the voltage phasor as the reference, the current phasor Lags by 90° Is in phase with the voltage Leads by 90° Lags and then leads by 160°
Problem Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V dc voltage source.
The maximum value of sinusoidal voltage is given by Vm= 1 V, What is the value of Peak to Peak voltage?
Quistion.4. a) A sinusoidal voltage is applied to the resistive circuit in figure.Q.4. a. Determine the following: i. Ims ii. Iavg iii. Ip iv. Ipp 10V 1.0 ΚΩ Figure.Q.4.a
An alternating current is given by the expression i = 200 sin (314t + T/6) amperes. The maximum value is and the frequency of the current is
The current through a 15kohm resistor is given below, using Ohm’s Law to find the voltage, convert to polar form, complete the math, then convert back to the waveform at i1 = 3.5sin(2500t) mA and i2 = 2.3sin(200t – 60°) mA