A student calibrated a eudiometer by first recording the mass of the empty eudiometer followed by filling the eudiometer to the 50.00 mL line with deionized water at 22°C and recorded the mass. The mass of water was 49.012 g. What measured reading from the eudiometer would correspond to a true volume of 47.89mL?

A student calibrated a eudiometer by first recording the mass of the empty eudiometer followed by filling the eudiometer to the 50.00 mL line with deionized water at 22°C and recorded the mass. The mass of water was 49.012 g. What measured reading from the eudiometer would correspond to a true volume of 47.89mL?

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter27: Molecular Fluorescence Spectroscopy

Section: Chapter Questions

Problem 27.9QAP

See similar textbooks

Similar questions

You begin preparation of the calibration curve to measure absorbance vs concentration of FeSCN²+. To do so, you add 1.58 mL of 0.200 M Fe(NO3)3 to a cuvette and then directly add 316 µL of 0.001 M KSCN. What is the resulting concentration of FeSCN2+, assuming complete conversion of SCN´¯ to FeSCN²+´ Enter your answer in units of mM to four digits after the decimal.
In a laboratory 100 mL of phosphorus solution with concentration 1,0 mg/L is needed when the spectrophotometer is calibrated. The solution is prepared in a 100 mL volumetric flask from the stock solution of phosphorus by diluting with water. The concentration of this stock solution is 50 mg/L. Calculate the volume of the stock solution needed.
The absorbance of a cationic iron(II) sample solution was measured in a spectrophotometer, but the instrument returned an error because the absorbance was too high. The sample was then diluted by using a pipette to take 100.0 μLμL of the sample and injecting it into a cuvette already containing 2.00 mLmL of water (total volume is 2.00 mLmL + 100.0 μLμL). The absorbance value of the diluted solution corresponded to a concentration of 7.71×10−6 M M . What was the concentration of the original solution? Express the concentration to three significant figures with the appropriate units.
Discuss 5 advantages and disadvantages of palm oil source of oleochemicals in Malaysia.
A beverage drink mix sample is prepared by mixing a packet of beverage powder in a gallon (3.78 L) of water. A sample for analysis is prepared by diluting 10.00 mL of this solution in a 50.0 mL volumetric flask. When measured using a colorimeter, this diluted solution has an absorbance of (3.49x10^-1). The calibration curve for the experiment yielded a linear fit of y = 21655x+(4.7850x10^-2) and an R2 value of 0.9911. Determine the molar concentration of food dye in the analyzed sample.
A volumetric calcium analysis on triplicate samples of the blood serum of a patient believed to be suffering from a hyperparathyroid condition produced the following data: mmol Ca/L = 3.55, 3.65, 3.14. What is the 95% confidence interval for the mean of the data, assuming(a) No prior information about the precision of the analysis?(b) s → σ = 0.056 mmol Ca/L?
professor Scimemi has accepted you as a Master’s student and you are involved in a project that studies the cellular basis of neuropsychiatric diseases. For your electrophysiology recordings you have to make a recording solution containing (in mM): 119 NaCl, 2.5 KCl, 2.5 CaCl2, 1 MgCl2, 26.2 NaHCO3, 1 NaH2PO4, 22 glucose. You need 800 ml of it. How much KCl do you need to weigh out? Hint: we only care about KCl here. (MW KCl is 74.55 g/mol
The absorbance of a cationic iron(II) sample solution was measured in a spectrophotometer, but the instrument returned an error because the absorbance was too high. The sample was then diluted by using a pipette to take 100.0 μL�L of the sample and injecting it into a cuvette already containing 2.00 mLmL of water (total volume is 2.00 mLmL + 100.0 μL�L). The absorbance value of the diluted solution corresponded to a concentration of 6.22×10−6 M � . What was the concentration of the original solution?
Time required to elute substance Z when N = 1000 = when N = 2000 The two quantities cannot be compared due to insufficient information. when N = 1000 > when N = 2000 %3D when N = 1000 < when N = 2000
You begin preparation of the calibration curve to measure absorbance vs concentration of FeSCN2+. To do so, you add 2.422 mL of 0.200 M Fe(NO3)3 to a cuvette and then directly add 215 µL of 0.001 M KSCN. What is the resulting concentration of FeSCN2*, assuming complete conversion of SCN' to FeSCN2+? Enter your answer in units of mM to four digits after the decimal.
use ion exchange method in analytical separation to separate mercury and nickel from polluted water using analytical steps and protocols.
Please