A single phase Half wave AC voltage controller has a resistive load of 16 ohms with input supply voltage of 240 V, 50 Hz. The delay angle of the thyristors is, a = 2T/5. Determine a) The rms output voltage and current. b) Input power factor and Input curren c) Average output voltage and current.

A single phase Half wave AC voltage controller has a resistive load of 16 ohms with input supply voltage of 240 V, 50 Hz. The delay angle of the thyristors is, a = 2T/5. Determine a) The rms output voltage and current. b) Input power factor and Input curren c) Average output voltage and current.

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Related questions

Q: What is the use of DC-DC boost module 0.9-5v to 5v? How does it work?

A: A DC-DC boost converter module (boost converter) is a DC-DC power converter module that boosts…

Q: Derive the transfer function of a two phase AC Servo Motor giving relationship between control…

A: AC servo motor has two stator fields placed at right angles to each other. one is reference…

Q: Can you get a DC signal from the Digital Multi-Meter? If not, why?

Q: A single-phase full-wave converter controls a separately excited DC motor speed. A full converter…

A: Given: A single-phase full-wave converter controls a separately excited DC motor speed. A full…

Q: Describe the construction and working of BLDC motor in detail.

A: A brushless DC motor comprises a rotor as a lasting magnet and stator as polyphase armature…

Q: A 210V, 900rpm, 160 A separately excited dc motor has an armature resistance of 0.072. It is fed…

A: Given: For motor: Terminal voltage (Vo)=210 V Rated armature Current (Ia)=160 A Armature resistance…

Q: uppose a shunt regulator voltage is 250V, the armature current is 30A. field coils are required to…

A: A DC machine is classified in two types. DC motors DC generators Above question is based on DC…

Q: Explain the AC Operation Of Electrodynamics'" Instruments in detail.

A: Electrodynamic type instrument: Two fixed coils, a moving coil, a control spring, a…

Q: What is dc and what is ac ?

A: Electricity can flow in two directions, alternating current (AC) or direct current (DC). The passage…

Q: What are the applications of the induction regulator?

A: An induction voltage regulator is a type of electrical machine in which the output voltage may be…

Q: separately-excited d.c. motor is supplied via a half-control full-wave single-phase rectifier…

A: Given data: Ra=6Ω T=1.8 NmVrms=240 V Since the thyristors are fired at 110°, obtain the…

Q: Describe the effect the switching control signal frequency has on the output voltage and current of…

A: There is a reasonable effect of switching control signal frequency on the output voltage and current…

Q: What is the ripple factor and what causes it? Discuss and explain how this factor can be used as a…

A: When a sinusoidal voltage is converted into dc, the output voltage waveform inherently contains…

Q: Q5- Adjust a fire angle for a three-phase full-wave semi-controlled converter to feed the separately…

Q: Discuss about Power Thyristor's DC and Ac switching.(with Diagram)

A: Power Thyristor DC circuit is as follows: - This basic "on-off" thyristor terminating circuit…

Q: Using RHR-1, show that the emfs in the sides of the generator loop in Figure 23.23 are in the same…

A: Magnetic field is always run from north direction pole to south direction pole. If the current is…

Q: Propose two suitable protection systems that could be applied to the DC Power Regulator System and…

Q: Draw the harmonic current waveform and harmonic order for current drawn by an adjustable speed motor…

A: The speed of motor drive is controlled by the combination of rectifier and the inverter. The…

Q: In the experiment of dc motor drive using three phase half wave rectifier, when the torque load…

A: Load torque of motor is directly proportional to armature current.

Q: The speed of a separately excited dc motor is controlled by a single-phase full-wave converter in…

A: As per the guidelines , we supposed to answer first three parts. please ask other parts separately.…

Q: Choose the converter which is used for converting Fixed bi-directional voltage to Variable…

A: We need to tell which option is correct for the given statement.

Q: 4- What are disadvantage of zener shunt regulator ?

A: Brief description: Zener shunt regulator uses zener diode as a main component in the design. Zener…

Q: One the following is not an advantage of BLDC motor over conventional DC motor.

Q: provide advantages, disadvantages and then discuss different applications of the DOL motor starter…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again. The…

Q: Describe the operation of a phase shift method

A: Intoduction - Phase shift method of SSB generation - The phase shift technique used in SSB producing…

Q: An audio power amplifier delivers an 80-volt peak 35 Hz sine to a subwoofer. If the subwoofer…

A: Given data, Peak voltage Vp=80 V Frequency f = 30 Hz Impedance Z=4∠-300

Q: How many parallel paths are there in the following armature windings: (a) six pole duplex-wave? (b)…

Q: With an AC source of 230 V, 50 Hz, a single phase half controlled bridge rectifier is used to fed a…

Q: i) The field of separately excited DC Motor is excited by a separate single phase voltage source of…

A: Hello. Since your question has multiple sub-parts, we will solve the first three sub-parts for you.…

Q: A phase control circuit is mainly composed of a TRIAC in series with the load resistance, RL,…

A: Triac: It is a three terminal semiconductor device and is a current control device. this is…

Q: 12. For a full-wave phase control circuit draw the output voltage and current waveforms when firing…

Q: Why is the conduction angle greater with an inductive load than with a purely resistive load?

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: Q1 :- Single-Phase full wave ac voltage controller working on ON-OFF technique with n=25 cycles &…

A: As per Bartleby guidelines we are allowed to solve only one question, please ask the rest again.

Q: Draw the equivalent circuit of a DC Motor, Separated Excited DC Motor and Compounded DC Motor. Label…

Q: 2. (a) With neat figure, explain how we can change the series/shunt field current of a DC motor and…

Q: Design a simple ON-OFF transistor switch to control a 12 volt DC motor

A: The simple ON-OFF transistor switch to control 12 volt DC motor contains some equipment is as…

Q: . Draw the circuit diagram for the four machine types that can be obtained from the DC shunt wound…

A: This is a good problem on dc machines topic of electrical engineering. Look below for solution.

Q: A DC, separately excited motor is connected to a fan-type load. The armature circuit of the motor is…

A: DC Motor: DC Motor is an electromechanical device which converts electrical energy to mechanical…

Q: Derive the expression of the RMS load voltage for a full wave ac voltage controller operating with…

Q: A separately excited dc motor is controlled by a single phase semi converter. The ac supply voltage…

A: Note: As per Bartleby Portal, I am solving three subpart of the question.…

Q: Q1. An SCR full bridge converter supplies power to a 560 V, 50 A, separately excited DC motor with…

Question

A single phase Half wave AC voltage controller has a resistive load of 16 ohms with input supply voltage of 240 V, 50 Hz. The delay
angle of the thyristors is, a = 2T/5. Determine
a)
The rms output voltage and current.
b)
Input power factor and Input curren
c)
Average output voltage and current.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

Step 2

Step 3

Step 4

Step by step

Solved in 4 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A single phase full wave AC voltage controller has a resistive load of 5 ohms and an input voltage of Vs = 240 V (RMS), 50 Hz. The delay angles of both thyristors are set to 45 degrees. The maximum RMS and average current ratings of the thyristor are equal to: Select one: O a. 33.94A and 21.6A O b. None of these O c. 24A and 10.8A O d. 48A and 26.09A Clear my choice
a. A 80 V rms is stepped down to 18V rms by a transformer. The output from the transformer is rectified using a half wave rectifier circuit and connected to a 47.5 2 load resistor. Draw a circuit diagram of this arrangement and the waveform at each stage.
h) Explain the methods of voltage control used in AC-AC converters.
A three phase full wave rectifier is shown below along with the peak input phase voltage Vm=169.7V. The load is purely resistive. The rectifier delivers Ipc = 100 A and the source frequency is 60 Hz. The DC output voltage is Vpc=280.7V and. The RMS transformer secondary current is equal to 81.72A, the output RMS voltage is equal to VRMS=280.93V and the output resistance is equal to 2.8070. The TUF would be equal to: Secondary a平a字a辛 R 太D。太D。太D. Select one: 0.875 Ob. 0.955 O C. 0.551 O d. 0.432 Compared with power transistors, thyristors have the following characteristic
3. A three phase bridge rectifier is supplied by 380 Volt line voltage through a Star/delta connected transformer of which turns ratio is 1. The firing delay angle is a=30° and the load is resistive R=2.2 Ohm. Draw the circuit diagram and mark the followings on this figure : average values of output voltage, the currents and voltages of each transformer leg.
3. A single phase half-wave converter is operated from 230V, 50 Hz source and the load R=1202. For a firing angle of 30°, determine: (a) Rectification efficiency (b) Form factor (c) Voltage ripple factor.
1. Single phase half-wave converter has a purely resistive load of R and delay angle is a= n/2 determine: (a) Rectification efficiency (b) Form factor (c) Ripple factor.
Draw the schematic of the Bidirectional Full Wave Control and its load voltage waveform.
[4] The half wave ac controller has rms output voltage equal to input rms Vs at.......... (5] In single phase bidirectional ac controller, the RMS output voltage can be varied between zero to.............. of input voltage
In the full-wave rectifier circuit of figure , the transformer has a turns ratio of 1:2. The transformer primary winding is connected across an AC source of 230V (rms), 50 Hz. The load resistor is 50ohms. For this circuit, determine the peak-to-peak ripple in the output voltage
A single phase half-wave AC voltage controller provides output RMS voltage of 50V when the triggering angle (a) is 90°. For the same a, what is the output RMS voltage if the AC voltage controller changed to full-wave type.
What is the ripple factor and what causes it? Discuss and explain how this factor can be used as a metric to improve the quality of the designed AC to DC converting system