A series RLC AC circuit has R = 425 Q, L=1.25 H, C = 3.50 µF, o=377 s-1, and AVmax= 150 V. (a) Determine the inductive reactance, the capacitive reactance, and the impedance of the circuit. (b) Find the maximum current in the circuit. (c)Find the phase angle between the current and voltage. (d) Find both the maximum voltage and the instantaneous voltage across each element. (e) Calculate the average power delivered

A series RLC AC circuit has R = 425 Q, L=1.25 H, C = 3.50 µF, o=377 s-1, and AVmax= 150 V. (a) Determine the inductive reactance, the capacitive reactance, and the impedance of the circuit. (b) Find the maximum current in the circuit. (c)Find the phase angle between the current and voltage. (d) Find both the maximum voltage and the instantaneous voltage across each element. (e) Calculate the average power delivered

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Similar questions

List the five capacitor replacement rules.
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
Shown in the figure below is an "RLC" circuit driven by an AC power source. The AC power source has an RMS voltage of Vps(RMS) = 9.35 Volts and is running at a frequency of f = 113000 Hz. The resistor has a resistance of R = 1980 , the capacitor has a capacitance of C = 1.08e-09 Farads, and the inductor has an inductance of L = 3.71e-03 Henries. mm Vps Write the FORMULA for the total impedance of the circuit Ztot = Write the FORMULA for the phase of the total impedance of the circuit øztot Determine the numerical value of Ztot = 2384 Determine the numerical value of @Z tot Determine the current through the circuit: ● R www I(PEAK) = I(RMS) = ● ● Determine the voltage across the inductor: • VL(PEAK) = Volts Volts VL(RMS) = Amps Amps Determine the voltage across the capacitor: Vc(PEAK) = Volts Volts Vc(RMS) = = 33.85 a capacitive switcher Ω degrees C If a second circuit were connected in parallel with the resistor, this circuit would be considered as: O a high-pass filter a radio tuner O…
Find the phase and amplitude of the voltage on the inductance. C = 100uF L = 0.15H R =120 VR V. Vc I Vs 100V, 50HZ
A series R–L–C circuit comprises a 5µF capacitor, a 4ohm resistor and a variable inductance L. The supply voltage is 10∠0◦ V at a frequency of 159.1 Hz. The inductance is adjusted until the p.d. across the 4 ohm resistanceis a maximum. Determine for this condition (a) the value of inductance, (b) the p.d. across each component and (c) the Q-factor of the circuit.
The attached image shows a circuit with an AC voltage source, a resistor, inductor, and capacitor connected in series. The circuit has the following characteristics: Resistor resistance: 10 ohm Capacitor capacitance: 0.05 F Inductor inductance: 13 H Current Amplitude: 4 A Voltage amplitude across the source: 60 V Frequency at the source: 0.3 Hz Voltage amplitude across the resistor: 35 V Voltage amplitude across the capacitor: 37 V Voltage amplitude across the inductor: 80 V (a) Calculate the RMS voltages from the amplitudes above. From the RMS voltages across the capacitor, inductor and resistor, calculate the RMS voltage of the AC source. Hint: Vrms = V0/sqrt(2) Vrms = sqrt( (Vrms,R)2 + (Vrms, L - Vrms, C)2 ) (b) Calculate the RMS value of the current (c) Using the resistance, capacitance, inductance, and the frequency of the AC voltage, calculate the impedance Z. From this, and the previously measured value of Vrms, find the RMS value of the current in the circuit.
4. Find Idc, Vdc and the capacitance that will force the Vr(pp) to 2mV. Draw the output waveform across the capacitor. Fin=60HZ. TX1 D1 Ge Vac Lst 230V Lp 1 RL 12-0-12 Center tapped CL 1k D2 Ge 2
1) convert to rectangular form. 2) Convert to polar form. Please show all work
A resistor with a resistance of 50 2 is connected in parallel with an inductor with an inductance of 0.175 henry. The power source is 60 Hz. What is the impedance of the cir- cuit? Letod ed
Find the impedance of a series connection resistor and an inductor.the inductance is L=1mH.the resistance is R=1kohm and the angular frequency is 2.10^5rad/sec
Please
An AC circuit is composed of a serial connection resistor with resistance 500a coil with inductance 0.3 H and a capacitor with capacitance 15 The circuit is connected to an AC voltage source with amplitude 25 V and frequency 50 Hz. Determine the amplitude of electric current in the and a phase difference between the voltage and the