A resistance of 2/(t + 20) Q and inductance of 4 H are connected in series to a battery of unknown emf V. If the current is initially zero and is 50 A at the end of 2 seconds, find the unknown emf of the battery.
Q: A 350 in. length of conductor is connected to a source of emf and carries a steady current of 25…
A: It is given that: Length=L=350Current=I= 25 AArea of cross-section=A=0.0063 sq.in.Time period=T=1…
Q: a. Find the power delivered to an element at t = 30s if the current entering its positive terminals…
A: As per our guidelines we are supposed to answer only one question. Kindly repost other questions as…
Q: By means of a battery, a capacitor C1 of 3.55 μf is charged until it reaches a potential difference…
A: From the charge Conservation
Q: 21 A real silicon photocell measuring 10 by 10 cm is exposed to 6000-K black-body radiation with a…
A: The flux of photons is determined as shown below
Q: A 120 V potential difference is applied to a space heater whose resistance is 13Q when hot. (a) At…
A: Given: Potential difference V=120 V Resistance R=13 Ω
Q: A 22kV, 50 Hz overhead transmission line connects Ibra and Muscat. There are three units in a string…
A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…
Q: A battery of silicon photocells mounted on a plane surface operates with an efficiency of 16.7%. It…
A: The data is provided as:
Q: I believe the answer for part one of the question is 5 seconds. Need some help solving the other two…
A:
Q: Q1) For the network in a. Find the mathematical expression for the voltage across the capacitor…
A:
Q: The charge entering a certain element is shown in the given figure, where A = 20. Find the current…
A: In this question we need to find a current from the given charge vs time waveform.
Q: The open circuit voltage of a solar cell is given by the following expression Voc = (kT)/q * ln *…
A: Solution- From the above equation that is clear that open circuit voltage can be improved by…
Q: The surface area of a region is 150 cm², d = 5 mm, and & = 10 for a parallel-plate capacitor.…
A: The solution is given below
Q: 6. A fan that consumes 20 W of electric power when operating is claimed to discharge air from a…
A: Claim Is not reasonable. Explanation is given in step-2
Q: A battery pack of 30 nickel metal hydride battery modules powers a high performance electric…
A:
Q: Problem 3: At t=0, a charged 10-uF capacitance is connected to a voltmeter, as shown. The meter acts…
A: Given circuit is = Meter is replaced by a resistor (R). Given values are =
Q: 1. What are the electric potential values, emf and IR, in the circuit? 2. What happens to the…
A: The circuit can be made as: The circuit KVL equation can be written as: And the potential…
Q: Determine the capacitor voltage in Volts (V), power in milliwatts (mW), and stored energy in…
A: In this question, At time t= 0 switch is open. Find the voltage across the capacitor and power and…
Q: In the figure below given that Q =30 nC, find the electric potential in units of V at the point p.…
A:
Q: 3- The charge on the capacitor in the network of Fig. is 2 coulombs. If the switch K is closed at…
A: (a) E = 100 V The initial charge is q(0) = 2 C The initial voltage across the capacitor, VC(0) =…
Q: Find the charge on the capacitor in the circuit shown in the figure. The capacitance of the…
A:
Q: A conducting coil, with current i(t) = 4.40e−0.0250t sin(120πt), with i in amperes and t in seconds,…
A: The current flowing through the coil is given as Differentiating the current i(t) with respect to…
Q: The energy dissipated in a circuit is rated at 240 microJoules. If the supply voltage is given to be…
A:
Q: A 44KV, 50 Hz overhead transmission line connects Ibra and Muscat. There are three units in a string…
A: Given, Csh=0.2Cs where, Csh is the shunt capacitance and Cs is the series capacitance.
Q: Aline of lengthi camying acharge Q produces the following electric potential at a perpendicular…
A: According to the question we have to find, What is the approximate electric potential at…
Q: Suppose we have a washer-shaped object with conductivity 50 S/m. The inner radius is a = 3 mm, the…
A: The solution is given below
Q: Q2:A)Show that no work is done in moving a 1 µc charge form the origin to point (3,1,4)in an…
A: To calculate the work done in moving a 1µC charge from origin to point (3, 1, 4) use the relation,…
Q: A typical AA battery has a potential difference of 1.5 V and stores 10,000 J of chemical energy. An…
A: Following circuit, diagrams are drawn as shown below
Q: a. Find the amount of charge stored on either plate of 4.4 mF capacitor connected to a 12-volt…
A: The capacitor is an energy-storing device that stores energy in its electric field. The amount of…
Q: The dark saturation current of a solar cell is 1.7E-8 A/m?, the cell temperature is 302 K, the…
A:
Q: 20 mm thicknesses and 1500 mm^2 The 200 WATT power of 3 MHz is used to warm up the fragment of the…
A:
Q: In the figure shown the total resistance is 30 kN, and battery's emf is 18 V. If the time constant…
A: Time constant of RC is given by R*C. And time constant of circuit is 12 μs. Equating the two we get…
Q: Use the following circuit to complete the accompanying table of Charges, Capacitances, and Voltages.…
A: It is known that the equivalent capacitance of two parallel-connected capacitors is the summation of…
Q: Answer "one" of the following: A. A capacitor C = 100 µF, is charged through a resistor of 1 k ohm…
A: B) compressed air could be stored in steel containers at 3000 lbs/in2 what the energy density is…
Q: In the figure the ideal battery has emf 8 = 43 V, the resistances are R1 = 51 kQ and R2 = 44 kN, and…
A: (a) At time t=0 the capacitor is shorted as initially capacitor is uncharged. Thus the current…
Q: 3. Consider the circuit in the diagram. The two capacitors are identical parallel plate capacitors…
A: Given when switch is at 'a' When switch is at 'b'
Q: The emf source, E, of the circuit shown in the figure has negligible internal resistance. The…
A: Given circuit: Source emf has negligible internal resistance. Resistors R1=7.1 ΩR2=2.8 Ω…
Q: 1.) The terminal voltage of a voltage source is v = 6 sin 2t V. If the charge leaving the positive…
A:
Q: a. In an electric circuit, total energy (in Joules) dissipated by elements between t, = 0 and tą =…
A:
Q: 43. A wire of one kilometer length has a resistance of 20 Q. If the length is halved, then the new…
A:
Q: 4) The electric field in a thunderstorm is approximately 10* V/m and the potential difference…
A: Given information: The volume of the cylinder is:
Q: What is the voltage drop uL(t) across an ideal inductor with inductance L, if the current flowing…
A:
Q: The dark saturation current of a solar cell is 1.6E-8 A/m?, the cell temperature is 332 K, the…
A:
Q: - and Er2 to the plates. (15 (in pF) of parallel-plate capacitor containing two dielectrics a) Find…
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: (e) In electrical circuits, Ohm's law can be mathematically modeled as /=V/R, whereas / is the…
A:
Q: Two coils A and B have, initially, a mutual inductance of 250 mH, and the current in coil A is 2 A.…
A: Given data, The value of current (i) = 2 A The value of time(T) = 0.2 sec
Q: A resistor (of unknown constant resistance) and a 0.02 farad capacitor are connected in series with…
A:
Q: An inductance of 1 henry, a resistance of 1600 ohms, and a capacitance of 10-6 farad are connected…
A: Given, R = 1600 ohm L = 1 H C = 10^(-6) F emf, e(t) = 100 sin(600t) volts Initially…
Step by step
Solved in 2 steps
- You are a journeyman electrician working in an industrial plant. Your task is to connect an inductor to a 480-V, 60-Hz line. To determine the proper conductor and fuse size for this installation, you need to know the amount of current the inductor will draw from the line. The nameplate on the inductor indicates that it has an inductance of 0.1 H. An ohmmeter reveals that it has a wire resistance of 10 . How much current should this inductor draw when connected to the line?A coil of inductance 50 mH and resistance 5 ohm is connected to a 110V, d.c. supply. Determine the final value of current, the value of current after 4 ms, the value of the voltage across the resistor after 6 ms, the value of the voltage across the inductance after 6 ms, and the time when the current reaches 15A.An inductance of 2 henries and a resistancc of 20 ohms areconnected in series with an emfE volts. If the current is zerowhen t 0, find the current at the end of 0.01 sec if E = 100 volts.
- What is the value of the induced voltage of the self-inductance when the rate of current is from 200 uA to 20 uA and the total time interval is 5 uS?A resistance of 10 Q and an unknown inductance are connected in parallel to a 110- Vac, variable frequency source. When the frequency is 50 Hz, the current drawn by the circuit is 6 A. At what frequency will the current drawn falls to 5.8 A.A resistance of 20 ohms and an unknown capacitance are connected in parallel to a 110-Vac, variable frequency source. When the frequency is 60 Hz, the current drawn by the circuit is 6 A. At what frequency will the current drawn falls to 5.8 A.
- An inductance of L henrys and a resistance of 10 ohms are connected in series withvoltage of 100 Volts. If the current is initially zero, and is equal to 9 Amperes after 1second.a) Find L? and b) Find the current after 0.5 s.Identify the statement from the following when the inductance can have high value. a. All the given options O b. If the number of turns of the wire is more O c. If the length of the wire is longer O d. If the cross-sectional area is lessAn inductance of 2 henries and a resistance of20 ohms are connected in series with an emfof E volts. If the current is zero at time, t = 0,find the current at the end of 0.01 sec if E =100sin150t volts.
- Using superstition, find the value of i0 if voltage source at the left is 10, angle - 30 degrees V, and current source is 2, angle zero degrees. A total of three sources will be considered, separately. The 24 volt source is DC. When this source is acting alone, the capacitor will be open-circuited.A coil has a resistance of 18 when it mean temp is from 20o C to 50o C. Find its mean temp rise when its resistance is 21 and the surrounding temp is 15o C. A potential difference of 250 V is applied to a copper field coil at a temp of 15o C and the current is 5A. What will be the mean temp of the coil when the current has fallen to 3.91 A, the applied voltage being the same as before.25/ Identify the statement from the following when the inductance can have low value. a. If the number of turns of the wire is less b. If the cross-sectional area is lesser c. If the length of the wire is longer d. All the given options