A module consisting of 2 parallel strings of 20 series-connected squared solar cells (cell length 12 [cm]), is measured under standard test conditions (1000 [W · m-²]). Each cell has the following external parameters: Voc = 0.8 [V], Isc = 3 [A], FF = 0.8. A) What is the open circuit voltage Voc of the module? Give the answer in [V] with one decimal place: B) What is the short-circuit current Isc of the module? Give the answer in [A] with one decimal place: C) What is the maximum power output of the module? Give the answer in [W] with one decimal place:

A module consisting of 2 parallel strings of 20 series-connected squared solar cells (cell length 12 [cm]), is measured under standard test conditions (1000 [W · m-²]). Each cell has the following external parameters: Voc = 0.8 [V], Isc = 3 [A], FF = 0.8. A) What is the open circuit voltage Voc of the module? Give the answer in [V] with one decimal place: B) What is the short-circuit current Isc of the module? Give the answer in [A] with one decimal place: C) What is the maximum power output of the module? Give the answer in [W] with one decimal place:

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter19: Capacitors

Section: Chapter Questions

Problem 3PA: You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors...

See similar textbooks

Similar questions

An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
Incandescent lighting of 500 W is connected in parallel with an inductive load. A clamp-on ammeter reveals a total circuit current of 7 A. What is the inductance of the load connected in parallel with the incandescent lights? Assume a voltage of 120 V and a frequency of 60 Hz.
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Convert the circuit from a T to a pi configuration
Q/ solue the equation [500] = [DI]*+BL +BH ÷ CX %3D DI = 2000 H [DI] = 130 Bx = 198AH CX = 22 H
draw "Vo" for the network in the figure and determine the available "DC" voltage SENOID INPUTS - HALF WAVE RECTIFICATION
What is the total current for the circuit in the figure below? Given: R = 3000 Xc= 150 120 v 60 Hz Select one: O a. 266.7 mA O b. 894 mA O c. 989 MA O d. 1.2 A R Xc
Vcc = +12 V %3D a. Determine the following values for the fixed-bias configuration in the figure to the right. Rc IBo and ICO 2.2 k2 C2 RB 240 k2 ac output VCEQ, VB, and Vc 10 uF C ac input VCE B = 50 VBC 10 µF
Refer to the given circuit. C1 = 5 µF C3 = 8 µF C2 = 4 µF C4 = 6 µF C5 = 4 µF DURACELL VT = 12 V What is the voltage across the plates of capacitor #1 (C1)? Select one: a. 6.36 volts O b. 2.71 volts O C. 5.65 volts O d. 7.32 volts
Q#3 Find the value of Rab in the figure-(c) and figure-(d).
With V1, voltage peak to peak is 10 volts, R1=200 Ohm, R2=1000 Ohm and C1= 300 nF. Find Vx, voltage across the the capacitor, C1 and R2 when the frequency is 1000 Hz and 10000 Hz