A DC voltmeter has a sensitivity of 1000 ohm/volt. When it measures half of full scale what is the current through voltmeter? A.100 mA B.1 mA C.0.5 mA D. 50 mA

Q: 2)With neat diagram explain the construction and working principle of strain gauge

A:

Q: A PMMC instrument gives 27 mA at full scale reading when a potential difference across its terminals…

A: I HAVE EXPLAINED IN DETAIL IN BELOW STEPS

Q: 12 V R1 12 mA R2

A: Note: Since you have posted a question with multiple subparts, we will solve the first three…

Q: ) With neat sketch explain the cross sectional view and I-V characteristics of the device which is…

A:

Q: RI = 80KN ww VT = 100V R2 = 80KN V )0-100V Range %3D What does the voltmeter read when it has a: A.…

A:

Q: A galvanometer has a current sensitivity of 1 (micro A/ mm) and critical damping resistance of 2…

A: Given values are - Current sensitivity=1μAmmCritical damping resistanceR=2kilo ohm

Q: What is GENERATION AND MEASUREMENT OF DC VOLTAGE? Give some introduction about it in 2 page if…

A: According to the question, we have to find the value of  Generation and measurement and generation…

Q: A PMMC instrument has internal resistance of 0.51 kN and gives full scale deflection for 41 mA. The…

A: The solution can be achieved as follows.

Q: A PMMC instrument gives 27 mA at full scale reading when a potential difference across its terminals…

A: Dear student as per our guidelines we are supposed to solve only one question in which it should…

Q: in one paragraph explain in your words what doping process is.

A: here we have to write what is doping process.

Q: The temperature coefficient of resistivity of carbon is -0.0005/C°. If the resistor is made of…

A:

Q: A STRAIN GAUGE IS HAVING ORIGINAL RESISTANCE OF 300 OHMS AND GAUGE FACTOR TO BE IF THE VARIATION OF…

A:

Q: (1) A moving coil nstrument whose resistance is 10 2 and has a full-scale deflection when the…

A:

Q: At 298 K, the nominal Zener voltage is found to be equal to 10 V. Given that the value of the…

A:

Q: R3 = 10KN R4 = 15KN What does the voltmeter read when it has a: A. SKN/V sensitivity? B. 20KN/V…

A: The solution can be achieved as follows.

Q: Sketch the following particulars for the device which is used in high voltage and high current…

A:

Q: What is the expression of thermal voltage? Find out the value of the thermal voltage at 300 K.

A:

Q: A PMMC type meter has a full scale deflection of 20 mA. The resistance of the coil is 400. So (1)…

A: Solution: PMMC type meter: full scale deflection i=20 mA                                  =20 ×10-3…

Q: What is the Vref for Iref = 250 microamps in the circuit in the figure? What is R1?

A:

Q: What is the relationship between the voltage across the power and the current? (P = I V )

A: Voltage :- voltage is potential difference between two point in circuit. It is denoted  by V.…

Q: Calculate the value of the multiplier resistance on the 50 V range of a de voltmeter, that uses a…

A:

Q: Calculate the sensitivity of a 200 micro Ampere meter movement which is to be used as a dc voltmeter

A: In the question,  Calculate the sensitivity of the meter If 200 micro Amperem Meter movement which…

Q: Bridge Rectifier 220:7.3 R 220V RMS + V - 220Ω 1 1000µF 本4.7V R 1kQ 4. Assuming the Zener diode is…

A: Izmin = 0 m A. Ideal zener diode. By the help of transformation ratio of the transformer be…

Q: A PMMC instrument gives 29 mA at full scale reading when a potential difference across its terminals…

A: Given: For PMMC Im=29 mAVm=41 mV So, meter resistance Rm=VmIm=4129=1.414 Ω

Q: The resistance of a thermistor is 800 2 at 50 °C.and 4 kQ at the ice-point. Calculate the…

A: At, T1=273 K, R1=4 kΩT2=323 K, R2=800 ΩBy Thermistor equation,B=T2 T1T2-T1 ln R1R2B=323273323-273 ln…

Q: Answer the following questions: A 0 -150 volt DC voltmeter has a resistance of 100 ohms per volt.…

A: As per our policy we can provide solution of first three questions only. V=150 VR=100 Ω/V

Q: A voltmeter has a resistance of 30 Q. What will be its reading, when it is connected across a cell…

A: Given, Voltmeter has resistance, R=30 Ω Cell emf, ε=2 V Internal resistance, r=10 Ω

Q: 22) What type of conversion is happening in a DC Motor.   a. DC electrical energy to mechanical…

A: A (DC) motor is a type of electric machine. It converts dc electrical energy into mechanical energy.…

Q: 3. The resistance of the copper field winding of a DC machine at 40 deg. C is 0.40 ohms. After…

A: As per company guidelines we supposed to answer 1st question only.Kindly upload other question…

Q: Design a dc voltmeter by using direct method with d'Arsonval meter of 70 Q and full scale deflection…

A:

Q: A PMMC instrument gives 19 mA at full scale reading when a potential difference across its terminals…

A: a PMMC instrument gives 19mA at full scale reading when a potential difference across its terminal…

Q: With neat diagram, State the principle of RTD sensor…

A: We need to find out resistance at given temperature and we need to find out the tempreture for given…

Q: A PMMC instrument has internal resistance of 0.66 kn and gives full scale deflection for 30 mA. The…

A: To use voltmeter as a multi range voltmeter we have to add series resistor.

Q: BASIC ELECTRICAL ENGINEERING - ELECTRIC CIRCUIT Draw a simple circuit diagram of circuit consisting…

A:

Q: Q1) Define the following D'arsonval movement, Galvanometer sensitivity, Voltmeter sensitivity,…

A: As per Bartleby guidelines we are allowed to solve only three subparts,please ask the rest again.

Q: The resistance of the copper field winding of a DC machine at 40 deg. C is 0.40 ohms. After…

A: The solution can be achieved as follows.

Q: What is the ideal resistance of a voltmeter? What is the ideal resistance of an ammeter? How do you…

A: In this question , we will find ideal resistance of voltmeter and ammeter ....

Q: A PMMC instrument gives full scale reading of 25 mA when a potential difference across its terminals…

A: PMMC: It stands for permanent magnet moving coil and is used to measure the DC value.

Q: QI. Describe A- Dual-slope digital voltmeter. B- Electrical Standards.

A: A.  DUAL SLOPE DIGITAL VOLTMETER The double incline incorporating type DVM coordinates the…

Q: A PMMC instrument has internal resistance of 0.63 k and gives full scale deflection for 31 mA. The…

A:

Q: Q3) What are the important characteristics of the voltage

A:

Q: Q21  A PMMC instrument gives 25 mA at full scale reading when a potential difference across its…

A: Given : Full scale deflection current, Ifd=25 mA Potential difference applied, Vm=32 mV

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.