Answered: A capacitor having a Q-factor of 400 is…

A capacitor having a Q-factor of 400 is connected in parallel with a coil having a Q- factor of 50. Determine the overall Q factor of the parallel combination.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 6RQ: A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating...

See similar textbooks

Related questions

Q: 2. Determine Ix using superposition theorem.

A: The superposition theorem state that the sum of response of individual sources acting alone is equal…

Q: _etwork in Figure. ww 6 ΚΩ 12V Use the differential equation approach to determine io(t) for t> 0 in…

Q: At what time is necessary for a current on a series RL dc circuit to reach 83.5 % of the final…

A: In this question, We need to determine the value of time necessary for a current on a series RL dc…

Q: Compute for Vo. Vcc R3 100kΩ R4 100kΩ Hii R₂ 1kΩ R₁ Μ 10kΩ Vo

Q: 1. The following sinusoidal waveform, v(t), is applied to a load. The load draws a current, i(t):…

Q: What is the Norton's resistance

Q: 3. If V(0) = 10V, find v(t) for t>0. 10 Ω 5Ω 10Ω -20 Ω + 10 mF

Q: 5) Determine the value of Vo and sketch Vo for the given circuit below. +8 V -8 V +o 1 ΚΩ +||+ Si 4…

A: Given, The circuit

Q: Determine the simplified Sum of Product expression of Q1 and Q2 from the table using a K-Map, then…

A: In this question, We need to determine the expression of the Q1 and Q2 in form of Sum of Product.…

Q: 700 Mbyte CD is used to store PCM voice data. Suppose that a CT voice signal is sampled at 8…

A: We need to find out the time for given data size and sampling rate .

Q: Find the Vin All R is equall Vin Br 5 + R R -M =R Vo

Q: [0.5(e-2t +e-4t) lo.5(e-2t-e-4t) 0.5(e-t-e-4t)1 0.5(e-2t + e-4t) Find x₂(t), t≥ 0, when x₁ (0) = 2…

Q: (a) (b) (c) -(2+a)s D[s] D[s] <<-as D[s] Find the sensitivity of T[s] with respect to a, when N[s]…

Q: Provide 3 sample calculations involving DC circuit under transient current condition on series R-L…

Q: 2. Determine the impedance of the following circuits if w=50rad/sec a. Zin 35 10 mF b. Zin ееее 0.2…

Q: Law proves that in a given circuit, the higher the impedance, the lower the current flow. a. Ohm's…

A: In general the impedance and the current are inversely proportional to each other.

Q: A buck converter has a duty cycle of 0.8. It has and inductor resistance of 20 and a resistance load…

Q: 3. Find v(t) for t>0.

A: The required parameters can be calculated by analysing the circuit before and after t=0.

Q: P3. A 4 pole, 50 Hz three-phase induction motor has a slip of 1% at no load. When operated at…

Q: Question 14 For an NMOS FET to be operating in the linear region of the ID-VDS characteristic: Gate…

A: Metal-oxide-semiconductor field-effect transistor is referred to as MOSFET. It has a MOS…

Q: a) If a load rated at 120Vdc and 300W is to be supplied for five hours followed by 1kW to be…

A: As per BARTLEBY GUIDELINES, For Multiple Questions, we have to answer only first question. So I…

Q: In a three-phase inductive motor circuit, I want the name of each element and the symbol in this…

Q: Two continuous-time WSS zero mean random processes X(t) and Y(t) are uncorrelated, which means that…

A: Given: Two continuous time WSS zero mean random processes X(t) and Y(t) are uncorrelated. i.e.…

Q: why the formation of stars and the emergence of elements are so important in our world. Give some…

A: As per the concept of formation of stars and suns in universe, these are formed by the explosion of…

Q: Identify the 3rd order transfer function ?(?) of the op amp from the Bode plot of the open-loop…

Q: 1) Demonstrate the validity of the following identities by means of truth tables: a. ((x+y+z) xy)' =…

Q: Question 11 Determine the first partial fraction convolution output y(w) signal using fourier…

A: As per the Bartleby guidelines, i can solve only one question. So I request you to submit the rest…

Q: What is the Norton equivalent resistance RN across a and b for the circuit shown in this figure: RA…

Q: a) s4 +25s³ + 15s² + 20s + k = 0

Q: USING D1 1N4001G or SILICON DIODE. To sketch the characteristic curve of the diode you need to vary…

A: In electronics, "biasing" often refers to the application of a constant DC voltage or current to a…

Q: . Compute the inverse z-Transform of the transform X(z) = 4z +1 z-z+.5

Q: What is the time constant for the circuit shown below, in ms (mili-seconds)? Your answer needs to…

A: Given,

Q: -) st+ ks³+2s² + (k+ 1)s + 10 = 0

A: Given that: The characteristic equation of a feedback control system is s4+ks3+2s2+k+1s+10=0. Find…

Q: [u]h Z 0.85

A: We need to find out the transfer function for given block diagram .

Q: Determine the Discrete-time Fourier series representation for the sequence below. Show the details…

Q: mn VI تے ww R₂ V₂ RE Vo Giveni fi 20kn R₂= 30KR в3= 50 кл Rp = 1MS V₁=2v V₂ = 4v 2 V₂ = 6v. 3 Solve…

Q: s6 +255 +8s4 + 15s³ + 20s² + 16s + 16 = 0

Q: 2. Find i(t) for t>0 1+ 400 80V t=0 3F 3002 ·o.si Li 5002

A: We need to find out current for given circuit, first we will find out the voltage across capacitor…

Q: You are given an AC signal having a peak voltage of 55 Volts; determine the average value of the…

A: Given Peak value of the AC signal =Vp= 55V To find the average value of the voltage..

Q: The speed of a shunt-wound d-c motor may be efficiently regulated by an external field rheostat…

Q: Question 25 Determine the denominator part of the Fourier transform of the response h(n) = (0.5)*2…

A: In this question, we need to choose the correct options We need to determine the Fourier transform…

Q: Vs 2 mV In the following circuit find V₁, V2, and the power dissipated by Rs 2kQ2 R1 10 KQ R2 R4 V₁…

A: Apply KCL at inverting terminal and using ohms law write the equations in terms of V1 and input…

Q: 2. In the circuit shown, determine the load currents I, and In 16 V ΖΩ www 5Ω R₁ ΠΟΩ R₂ 15Ω 36 V

Q: Use superposition theorem to solve for Vx when all sources are active. 4V 3 Ω ΤΩ + Ox 2 Α 2A 2 Ω w •…

A: In this question We need to determine the voltage Vx using the super position theorem. Here 3…

Q: Given: 10 = 6 amperes, V1 - 7 volts, and V2 = 93 volts. Find the value of Vy (in volts). 5V, 1Ω Ig…

A: Given, The circuit diagram will be,

Q: Use superposition Theorem to find Vo. Do not include unit in the final answer. 6V 2 mA 1+ 2 ΚΩ ww 34…

Q: Several factors or conditions can cause conductors to overheat, but often overlooked is the…

A: The heating is the major concern in the conduction as the temperature increases then the resistance…

Q: 2. In Figure 2, calculate the (a) output voltage, (b) the voltage across the current source, and (c)…

Q: 81 50Ω· 2552 RL ww -+ 6V 251x 3. In the above diagram, R₁ represents the load in the circuit. A.…

Q: For the circuit shown below consider is =5 cos(1000t + 10°) A: a) Find the phasors VS, IR, IC and…

Concept explainers

Capacitor

The capacitor is an element used to store electrical energy in the electrical field. A capacitor is a form of passive energy.

Question

circuits

A capacitor having a Q-factor of 400 is
connected in parallel with a coil having a Q-
factor of 50. Determine the overall Q
factor of the parallel combination.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
List the five capacitor replacement rules.
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
A series R–L–C circuit comprises a 5µF capacitor, a 4ohm resistor and a variable inductance L. The supply voltage is 10∠0◦ V at a frequency of 159.1 Hz. The inductance is adjusted until the p.d. across the 4 ohm resistanceis a maximum. Determine for this condition (a) the value of inductance, (b) the p.d. across each component and (c) the Q-factor of the circuit.
A capacitor is placed in parallel with two inductive loads one of 20 amp at 30degree lag and one of 40 amp at 60 degree lag. What must be the current in the capacitor so that the current from the external circuit shall be at unity power factor?
Question 4 A boost converter has an input of 5V and an output of 20W at 15V. The minimum inductor current must be no less than 50% of the average. The output voltage ripple must be less than 1%. The switching frequency is 30kHz. Determine the duty ratio, minimum inductor value, and minimum capacitor value. Verify your answers using Matlab, show the inductor current is continues and its minimum is no less than 50% of its average. Furthermore, the output voltage ripple is less than 1%.
A resistor with a resistance of 50 2 is connected in parallel with an inductor with an inductance of 0.175 henry. The power source is 60 Hz. What is the impedance of the cir- cuit? Letod ed
A capacitor in series with a 20-KO resistance across a 10 V ac source. What size C is needed for equal voltage across R and Xc at frequency of 100 Hz and 100 KHz.
The total inductances of two coils, A & B when connected in series aiding is 0.5H and O.2 H when connected in series opposing. Coil A when isolated from coil B has a self-inductance of 0.2 H. Calculate the self- inductance of coil B. O 0.20H O 0.15H O 0.16H 0.12H
A capacitor that is connected parallel to the inductor is added to the circuit image below to correct the power factor to unity. What would be the capacitive reactance of the capacitor assuming the resistance is irrelevant.
Q/ Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V dc voltage sour.