a) Calculate the energy stored in a capacitor at time t = 1 s if C = 23.5 pF and Vc = 0.8 V.b) A 137 pF capacitor is connected to a voltage source such that Vc(t) = 12e-²t V, t≥ 0.Calculate the energy stored in the capacitor at t equal to 200 ms.

Answered: Image /qna-images/answer/76a4e4d6-02c3-43e1-9fe2-36022c57f893.jpg

Answered: a) Calculate the energy stored in a…

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 5PP: Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 -...

See similar textbooks

Similar questions

A 0.8-F capacitor is connected in series with a 7-ohm resistor. If the connection is energized from a 10-V DC source, determine the voltage (in volts) across the capacitor at t = 2.5 ms. The initial charge is 150 mC. Express your answers accurate to four decimal places. No need to put the units. Do not put spaces.
A parallel-plate capacitor is connected to a battery. Without disconnecting the capacitor, a student pulls the capacitor's plates apart so that the plate separation doubles. As a result of this action, what happens to the voltage across the capacitor and the energy stored by the capacitor?
A10,000μF capacitor has an asymmetric tolerance speciﬁcation of+20%/−50%.What is the possible range of values for this capacitor?F capacitor has an asymmetric tolerance speciﬁcationof+20%/−50%.Whatisthepossible range of values for this capacitor?
An initially charged capacitor has an initial voltage of Vo=53 Vand a capacitance ofC=175μFand it is connected to a resistor of resistance R=4.85kΩas shown in the figure below. The switch is closed at t=0. Determine the current running in the circuit one time constant after the switch is closed. Express your answer in units of mA using one decimal place.
A paralel-plate capacitor is constructed using a dielectric material whose dielectric constant is 2.40 and whose dielectric strength is 3.00 x 10" wm. The desired capacitance is 0.100 g, and the capacitor must withstand a maximum potential difference of 4.00 kv. Find the minimum area of the capacitor plates. Jm²
Problem 2 The voltage across a 2-F capacitor is shown in the given figure. Sketch versus time the capacitor a) current b) power c) stored energy v(t) 3 t (s) 0.1 0.2 0.3 0.4
A 10¯7-F capacitor (100 nanofarads) is charged to 100 V and then disconnected. One can model the charge leakage of the capacitor with a RC circuit with no voltage source and the resistance of the air between the capacitor plates. On a cold dry day, the resistance of the air gap is 3× 103 Q; on a humid day, the resistance is 8 x 10° Q. How long will it take the capacitor voltage to dissipate to half its original value on each day?
Consider the circuit in figure given below: A B The capacitor C is initially charged. At time 0, the switch is connected from A to B and the voltage across the capacitor is measured. The following data are recorded by a data acquisition system: t(s) 0.0 0.1 0.2 0.3 0.4 0.5 V(V) 4.98 1.84 0.68 0.25 0.09 0.03 (a) Determine the linear correlation coefficient betweent and V. (b) Determine the linear correlation coefficient between t and In(V).
Please help will upvote for sureFor the circuit below:a) What is the maximum current at any time in the circuit?b) Write Equation of capacitor voltage in any time and find the capacitor voltage at t=1msec, t=10msec, t=1sec and t=10sec?d) Draw the capacitor voltage and current signal versus time axis and sign four different time values in (c) on it?
A capacitor 0.038 µF capacitor has a negative temperature coefficient α of - 177 ppm / deg C. The nominal temperature for the capacitor is 25 degrees C. If the capacitor has to operate at 30 degrees C, what would the decrease in capacitance be? Enter your answer in pF
Switch KC xC The circuit above has a switch that connects one capacitor and a resistor to a battery when in position A, and connects that capacitor and resistor to a second capacitor and resistor when in position B. Both capacitors have capacitance C when they are filled with nothing. We begin this problem with both capacitors uncharged, but filled with a solid with dielectric constant x. (a) The switch is set to position A at a time t = 0. After waiting a long time, what is the charge on the capacitor? What is the energy stored in the capacitor. (b) The switch is moved from position A to position B, connecting the charged capacitor to the uncharged one. After a long time, what is the charge on each of the two capacitors? Remember that charge is conserved. (c) How much energy was lost to heat in this transfer of charge? Hint: You will not need to compute an integral, nor do you need to know the amount of resistance in the circuit. (d) The dielectric material is slowly pulled out of the…
The initial capacitor voltage is 4 V. Switch S1 is closed at t = 0. The charge (in micro C) lost by the capacitor form t = 25 microS to t = 100 microS is:1) 6.992) 8.713) 5.554) 10Please show detailed steps and work

SEE MORE QUESTIONS

Recommended textbooks for you

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

SEE MORE TEXTBOOKS

a) Calculate the energy stored in a capacitor at time t = 1 s if C= 23.5 pF and Vc = 0.8 V. 12e-2¹ V, t≥ 0. = b) A 137 pF capacitor is connected to a voltage source such that Vc(t) Calculate the energy stored in the capacitor at t equal to 200 ms.