a) An operational amplifier with non-inverting voltage feedback is given in Figure Q4.a. It has the following properties: Vin + 1 kQ Figure Q4.a Open loop gain: 100,000 Open loop output impedance: 400 Open loop bandwidth: 10 Hz Calculate: 1) The closed-loop voltage gain 2) The closed-loop output impedance 3) The closed-loop bandwidth Vout 99 ΚΩ R₁

a) An operational amplifier with non-inverting voltage feedback is given in Figure Q4.a. It has the following properties: Vin + 1 kQ Figure Q4.a Open loop gain: 100,000 Open loop output impedance: 400 Open loop bandwidth: 10 Hz Calculate: 1) The closed-loop voltage gain 2) The closed-loop output impedance 3) The closed-loop bandwidth Vout 99 ΚΩ R₁

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q. One advantage of having feedback in op amp circuit is A. low gain B. low bandwidth C. can control gain D. high output voltage E. less input signal F. less complicated
a) An operational amplifier with non-inverting voltage feedback is given in Figure Q4.a. It has the following properties: Vin + 1 kQ Figure Q4.a Open loop gain: 100,000 Open loop output impedance: 400 Open loop bandwidth: 10 Hz Calculate: 1) The closed-loop voltage gain 2) The closed-loop output impedance 3) The closed-loop bandwidth Vout 99 ΚΩ R₁
1- Mention any two non linear applications of op- amp. 2- For the circuit given below : Vin is a sine wave Vinpp=9 V and Vref=2.4 V , Assume Vsat=±12V Name the circuit and draw the input and output waveforms . Vo Vin Vref 3- Explain why open-loop op-amp configurations are not used in linear applications? Draw the block diagram of opamp and define the function of each block
Steady state errors are only for . .... the open loop systems O none of the mentioned the non-unity feedback systems O the unity feedback systems O O
Problem C It is desired to have a gain of 20 for frequencies up to 180 kHz. Determine the minimum unity gain frequency specification for the op amp. The gain should be within at least 98% Vsig Rin + Rf Vcc/-Vcc +12v/ -12V Vout
these Questions from ELECTRONICS LAB ,The name of Experement is Op-Amp Comparators.
1- Mention any two advantages of Integrated Circuit . 2- For the circuit given below : Vin is a sine wave Vinpp=6 V and Vref=-2.4 V , Assume Vsat=±12V Name the circuit and draw the input and output waveforms . Vin Vref 3- Explain why open-loop op-amp configurations are not used in linear applications? Draw the block diagram of opamp and define the function of each block
Ques 2: What is the Voltage series feedback? Explain the effect of feedback on gain and input, outputimpedance
1- Mention any bwc advantages of integrated Circut. 2- For the circuit given below Vnis a sine wave Vinpp 11 Vand Vref-12V, Assume Vsat 1zv Name the circuit and drew the input and output waveforms. Vo Vin Vref 3- Explain why open-oop op-amp configurztions are not ues in linear applications Draw the biock diagram of opemp and define the funcion of each biock
What is an A/D converter with Voltage-to-Frequency Conversion (VFC)? What is the working principle?
1) Op-amp limiting factors - Current Saturation U2 Vin R1 OUT OPAMP R2 RLoad The saturation output current for the above op-amp is +/- 15mA. For the following input signals, determine if the output appears as would be expected in an ideal circuit. Include sketches of the output voltage. a) R1 = 100, R2 = 900, an open circuit load, and Vin is 2Vpp triangle wave with zero offset voltage (Vmax 1V, Vmin = -1V) and a period of 2ms. b) R1 = 100, R2 = 900, a 1k load, and Vin is 2Vpp triangle wave with a 1V offset voltage (Vmax=2V, Vmin = 0V) and a period of 2ms. c) R1 = 100, R2 = 900, an open circuit load, and Vin is 4Vpp triangle wave with zero offset voltage (Vmax=2V, Vmin = -2V) and a period of 2ms.
An op-amp with open-loop parameters OFAOL = 2 x 105 and fPD = 5 Hz is connected in a noninverting amplifier configuration with a low- frequency closed-loop gain of ACLO = 30. An input voltage signal of v = 100sin(27ft) P V is applied. (a) What is the closed-loop bandwidth?