Determine the current I in the given circuit, using the superposition theorem 3Ω Μ 10 V 1Ω 19 ΖΩ ww 1104 Μ 3Ω 10 Ω •5Ω 5V

Q: 2. If the voltage gain of an amplifier is 100, the voltage gain in dB is equal to a. 6 dB b. 40 dB…

A: Given data, Voltage gain of an amplifier, Av=100 V

Q: A resistance strain gauge with a gauge factor of 2 is fastened to a steel member which is subject to…

A:

Q: a) Let V = 100r²,r < 10m. Find w, and D. Derive the electric field intensity (E) for line charge.

A:

Q: What is the reserve capacity, if the maximum demand of generation of power is 50 MW, the load factor…

A: Given, Maximum demand is 50 MW. load factor is 60%. Plant capacity factor is 50%.

Q: For each design alternative, develop an equation for v2 as a function of R or R1 & R2. Special Case:…

A:

Q: A JFET is set up as a follower, with = 200, r = 100 kn and source load resistor R₂ = 1 k. The output…

A: Given: A JFET is set up as follower with, The amplification factor, μ=200Drain resisatnce, rd=100…

Q: Find the amplitude (peak), phase, period, and frequency in Hz of the sinusoid v(t) = 12 cos(50t +…

A: Given: Sinusoidal signal, vt=12cos50t+10°

Q: Vs -20V R1 100kΩ R2 325ΚΩ Rc 4.7ΚΩ Q1 Re 1.5kΩ

A: Given that β=160 VS=20 V, R1=100 k-hm, R2=25 Kohm, RC=4.7 kohm, and  Re=25 kohm. The given circuit…

Q: 4. A PV module I found to operate at a temperature of 60°C under conditions of TA=30°C and G=980…

A: Given a PV module having, Cell temperature, Tcell=60 °C Ambient air temperature, Tair=30 °C…

Q: 1.2 mA 177 3 ΚΩ AM Given the current to voltage converter, determine the load voltage.

A:

Q: Determine the output expression  2. Simplify the expression

A: The logic gate circuit diagram is shown below,

Q: QUESTION 2 Find Rth with respect to the terminals a,b for the circuit in Ohms. Figure P4.64 8 Ω 60 V…

A: Given circuit:

Q: With zero volts on both inputs, an OP-amp ideally should have an output ..... 1. equal to the…

A: Given when both the inputs of the op-amp are zero then we have to find the output of the IDEAL…

Q: A load impedance ZL = 200 + J160Ω must be married on a 100Ω line using an open parallel estub tuner.…

A: A load impedance ZL=200+j160 Ω must be matched on a 100 Ω line using an open parallel stub. We need…

Q: 7. The armature of a d.c. generator has a 2-layer lap-winding housed in 72 slots with six con-…

A: Given data, A DC generator has 2 layer lap winding. Number of slots is 72 Conductor per slots is 6.…

Q: 3. A transmission line has 2 m long conductor carrying 3 A is placed parallel to the z- axis at…

A: Given data: From z-axis to conductor  ρ0=10 cm=10×10-2 m Current through the conductor I=3 A The…

Q: A delta-connected unbalanced load is connected across a three-phase balanced source. The sequence…

A:

Q: Q3-A-Discuss the stability of a system given by its open-loop transfer function K(s+13) s(s+3)(s+7)…

A:

Q: Question 1 Find the value of current is passing through R3 (60 2) resistor. V₁ = 100 V + R₁ = 60 S2…

A: Given circuit,

Q: What Draw full characteristics graph of zener diode with reverse breakdown voltage of 12V.

A:

Q: The response of the system is given by Y(s) = = Find the final value of the system output. (5+3)(5 +…

A:

Q: Find the number of commutator segments required in a 6-pole dc machine having s simple wave-wound…

A:

Q: SV 15 ( 25 f wwwww 50 SV Determine the current 1 in this circuit

A: Given data, Circuit diagram is given as,

Q: (12) 3. Find i. 3 45 M (+15V ↓i 2.

A: Given circuit:

Q: Referring to Figure 2, a. Explain how to evaluate the correct combination of X and Y for…

A:

Q: Three identical loads having an impedance of (8.66 + j5) are connected in wye across a balanced…

A: Given: Impedance, Z=(8.66 + j5)Ω Line voltage, VL=330V

Q: A certain electronic power supply requires 25 W of input power. It can produce an output power of 20…

A:

Q: An electron having velocity v=-1.2×10° j m/s enters a unifom magnetic field of 2 T as shown in…

A: (i) The necessary centripetal force will be provided by the magnetic force,  Fm=Fcqv×B=mv2rr=mvqB…

Q: Please answer it with further explanation. badly need it What are your observations in this table…

A: We know that in a Reverse biased condition diode acts as an open switch(ideally speaking of infinite…

Q: A communications channel with a bandwidth of 4 kHz has a signal power to noise ratio of 7. The…

A:

Q: 4. The switch has been open for a long time and is closed at t = 0. The circuit parameters are…

A:

Q: Two alternators A and B delivers 100 and 150 A, respectively to a load. If these currents are out of…

A:

Q: A DC motor takes an armature current of 130 A at 460 V. The armature circuit resistance is 0.4 Q.…

A: Given that: Armature current, Ia=130 A Voltage, V= 460 volt Armature resistance, Ra=0.4 ohm Pole,…

Q: A coil of resistance 20 Ω and inductance 300 mH is connected in parallel with a capacitor of 200μF.…

A:

Q: What are the advantages of digital control system?

A: Digital control system have various advantages over analog control system.   1. Binary or discrete…

Q: A 100 Q resistor is connected across the terminals of a 2.5V battery. What is the power dissipation…

A:

Q: 2. Given: A certain liquid weighs 7.95 kN/m³ Required: a) Specific volume (m³/kg) b) Specific…

A: 2) It is given that: m=7.95 kNm3=7950 Nm3

Q: In digital transmission, the modulation technique that requires minimum bandwidth is a. Delta…

A: Answer: Delta Modulation   Explanation: a. It is a valid option. It requires a minimum bandwidth and…

Q: b. The output from the quantization process will be coded to generate bit stream to be encoded…

A: The digital data encoding schemes are categorized into five types based on their synchronization…

Q: Find the individual current and voltage drop across each resistors if C₁ = 4892, C₂ = 25, and…

A: The required parameters can be calculated by using the resistance reduction and by using the voltage…

Q: Given points M(-1, 2, 1), N(3,-3, 0), and P(-2,-3,-4), find: a) RMN b) RMN + RMP c) Ml d) aMP e)…

A:

Q: Obtain Zin for the circuit in Le Fig. 9.67. Zin j15 Ω 25 Ω wwwm -j50 Ω 20 Ω 30 Ω 110 Ω

A: Given, The circuit is,

Q: In the circuit shown, assume R₁ =1002, design the value for R₂ in (12) so that the power supplied by…

A: The required parameters can be calculated by using the ohms law and kirchhoff's voltage law.

Q: What will be the meters reading? Voltmeter V, 24 V XMM1 Xid www R₁ = 1.5k2 R₂ = 2.5k2 XMM2 Ammeter

A: Given circuit,

Q: Show complete solution. Solve I1, I2, I3 and 14 of the given circuit. Solve for 1₁ to 14 of the…

A:

Q: Find the Thevenin equivalent with respect to the terminals a, b and determine the current across 1.5…

A:

Q: The expression for bandwidth BW of a PCM system, where v is the number of bits per sample and fm is…

A: The correct option along with the explanation is provided in the following section.

Q: If the apparent power of an ac circuit is 111.84 kVA, Find the magnitude of the active power if the…

A:

Q: In a BJT, Ico= ICBO =2 μA. Given a = 0.99, the value of ICEO is?

A: Given: In a BJT the parameters are, Common base current, ICO=ICBO=2 μA The current gain, α=0.99

Q: What is the Beamwidth parameter? (a) 00 = 0°, N = 8, d = x/2 (b) 00= 45°, N = 8, d = λ/2 for the…

A: Given, θ0=Angle of lobe β=Beamwidth, λ=Wavelength N=Number of arrays, d=Distance  Here, we have to…