A 20 resistor, a 0.01 H inductor and a 100 µF capacitor are connected in series. A DC voltage of 100 V is suddenly applied to the circuit. Find the maximum current and the time at which it occurs.
Q: What is the resulting SQNR for a signal uniformly distributed on [−5, 5] when uniform?
A:
Q: Figure Q2(a) is an RLC circuit with R= 20 22, L=4 H, and C = 50 mF. Assume the circuit is in steady…
A:
Q: Q1) Fill in the following blanks: 1.lonization coefficients a. y are functions of ....... 2. Time…
A: As per Bartleby policy we can answer first three parts. Please repost the question for other parts.
Q: A silicon p-n junction (ε=11.9ɛ n; = 1.45 x 10¹⁰ cm³3³) at 300K has dopant concentrations N₁=2 x…
A:
Q: Determine the equivalent inductance of the figure.
A: Brief description: For the given circuit by the clear identification of the placing of the dots we…
Q: Question 2:- use Ronth Hurwitz criterion and determine i-Aumber of roots in left half of s-plane. -…
A: We need to find out the number of poles .
Q: The power input to a synchronous motor is measured by two wattmeters both of which √3 indicate 50…
A:
Q: • Find the state equations and output equation for the phase-variable representation of the transfer…
A:
Q: Basic Electrical Engineering Simulate the circuits shown using Multisim. Copy and paste the…
A: The required current value can be calculated by using the nodal analysis.
Q: HW/Consider the system whose closed-loop transfer function is G(s) = K(T₁s + 1) T₂s +1 Obtain the…
A:
Q: '8 Ω Το -j2n 4F m j4Ω 2/04 6Ω Μ 10230V
A: given here a electrical network and asked to determine the value of the current I0 in the network by…
Q: A 200 V d.c. shunt motor takes 4 A at no-load when running at 700 rpm. The field resistance is 100…
A: The voltage rating is 200 V The shunt motor current is 4 A The speed of the shaft is 700 rpm The…
Q: In a capacitively coupled amplifier, the input coupling capacitor and the output coupling capac-…
A: Capacitor:- Capacitor stores electrical charges in electric field. Capacitance is the effect of…
Q: Determine the z-transform of the sequence x[n] = (-)" cos(³7)u[n] a. 1+1/²/2-1 ,ROC: |z|> // 1+…
A: given here a anti causal discrete time system and asked to find the z transform for that system.
Q: Draw the negative- and zero-sequence impedance networks for the power system shown below. Mark the…
A: In this question we need to draw negative sequence and zero sequence per unit impedance diagram of…
Q: Electrical Engineering The square in the figure represents four electrodes at the indicated…
A: An electrical potential at a point is the charge accumulated at the point, an electric potential is…
Q: d) A radio antenna pointed in a direction of the sky has a noise temperature of Ts = 50 K. The…
A: Given Parameters of an amplifier and a pre amplifier. We need to determine the output noise power…
Q: Find the value of V0 using the source transformation method.
A:
Q: Please draw the block diagram of Standby UPS.
A: UPS stands for uninterruptible power supply. It is used as instant power backup if supply is…
Q: A-derive an equation for the copper saving in autotransformer. B- what are the disadvantages of the…
A: Given We need to derive the equation for saving of conductor in an autotransformer and we need to…
Q: 20.a. In a capacitor-start motor driving a high-inertia load, regeneration can occur during the time…
A: By reversing the current of motor, motor stored energy can be feed back to the supply and this is…
Q: A positive-sequence, balanced -connected source supplies a balanced Y-connected load. If the…
A:
Q: Design a D Flip-Flop using a JK Flip-Flop and basic gates. You have to show the following i. The…
A:
Q: 1.The voltage measured from the collector to the emitter is the sum of the voltage base-emitter plus…
A: We need to tell about whether the given statement are true or false
Q: In a balance three-phase system, the source has an abc-phase sequence and is connected in delta. The…
A:
Q: 12.a. Which one of the following statements is true about a two-winding distributed-field universal…
A: 12) a) It is a type of motor which can run on either a DC or a single-phase AC supply. Universal…
Q: 1. In the circuits of Fig. 3.2a and b, what aspects of Ohm's law were validated? 2. Describe any…
A: Since you have posted a question with multiple sub-parts, we will solve first three subparts for…
Q: b. two 1-phase furnaces I and II are supplied at 80V by means of a Scott-connected transfor…
A: Given Data, Secondary Voltage V2=80V Primary Voltage V1=6600V
Q: Fig. 4.a shows the phasor of current flowing through the three different circuits with same value of…
A: Given, The phasor of current flowing through the three different circuits with same value of voltage…
Q: A 5-µF capacitor is discharged suddenly through a coil having an inductance of 2H and a resistance…
A:
Q: In the circuit shown, the source current has a value of Is = 57mA. Determine the amount of power…
A:
Q: 1) The magnetic field of 2 x 10-2 T acts at right angles to a coil of area 100cm² with 50 turns. The…
A: Given data, B=2×10-2 TA=100 cm2N=50 turnsEavg=0.1 V Angle between coil and magnetic field is 90…
Q: Q3: The Excess electron concentrations is a function decay of time as; Sn(t) = {3.6² (3.68 x 1013…
A:
Q: A Req ? 2 Ω 2 Ω M 4 Ω Μ 2 Ω 4 Ω Μ 1Ω M B 1.6 Ω ΣΩ 3 Ω
A:
Q: 1. For the Diode Circuits shown below, Vd=0.7v a. Draw the small signal eq. circuit find Vo (AC+DC)…
A: Diode: A diode is a two-terminal semiconductor device created by a p-n junction separating two doped…
Q: 3.35 Find V, in the circuit in Fig. P3.35 using nodal analysis. 12 ΚΩ σν 6ΚΩ www 12v (+ 6ΚΩ V Figure…
A:
Q: Sketch the signal x(n) shown below as: 1. xn) u(l-n) ال 4 3 2 1 0 1 2 3 4 5
A:
Q: A 380 volts, 3 phases, 50 Hz, 10 pole motor is driving a water pump (Torque is proportional to…
A: In this handwritten solution, the concept related to the important motor related parameters &…
Q: A single stage amplifier has a voltage gain of 60. The collector load RC = 50092 and the input…
A: Loading effect Two amplifiers are cascaded the total gain for A1 can be calculated by including the…
Q: 20kΩ 8.2ΚΩ ΖΩ 1.0ΜΩ + Vo
A:
Q: The diagram below shows a mid-point reactor tap-changer in one phase of transformer winding. What is…
A: Given A circuit diagram of mid-point reactor tap changer. We need to determine the purpose of…
Q: The signal ä(t) is now sampled at a rate of w§. (i) (ii) If ws > Wn, plot the resulting spectrum of…
A:
Q: does arduino sensors have 100 accuracy in sensing a condition? for example dht11 for tem,…
A: The sensor which uses Arduino are very accurate in sensing either temperature if it is a temperature…
Q: 1- What will happen if the primary of a transformer is connected to d.c. supply? 3 Lin
A: We are authorized to answer only 1 question at a time since you have not mentioned which question…
Q: For the given system,
A:
Q: Which of the following is a DMA controller? Select the correct response: O82C59A O82C55A O82C37A…
A: In this question, We need to choose the correct options Which is following is a DMA controller?
Q: Q1/ In the circuit shown below, the zener diode used has the following specifications : Vz= 12 volt,…
A: power P = voltage V * currrent I . at maximum value of current , power will be maximum . generally…
Q: Calculate the inductive reactance of a 0.9-μH coil at 800 MHz.
A: In this question we need to find a inductive reactance of a 0.9-μH coil
Q: (a) Derive an expression for vout(t) in terms of vin(t). R2 www 60kQ R1 40kQ R3 vout 40ΚΩ Vin C1…
A:
Q: H.W.(11): Design a low-pass filter using one resistor and one capacitor that will produce a…
A: As per bartleby guideline for more than one question only first is to be answered please upload the…
Step by step
Solved in 5 steps with 5 images
- You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
- A 15-F AC capacitor is connected in series with a 50 resistor. The capacitor has a voltage rating of 600 WVDC. The capacitor and resistor are connected to a 480-V, 60-Hz circuit. Is the voltage rating of the capacitor sufficient for this connection?An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?You are working in an industrial plant. You have been instructed to double the capacitance connected to a machine. The markings on the capacitor, however, are not visible. The capacitor is connected to 560 volts and an ammeter indicates a current of 6 amperes flowing to the capacitor. What size capacitor should be connected in parallel with the existing capacitor? What is the minimum AC voltage rating of the new capacitor? What is the minimum DC voltage rating of the new capacitor? What is the minimum KVAR size that can be used in this installation?
- An inductance coil consumes 500W of power at 10A and 110V and 60HZ. Determine the resistance and the inductance of the coilA capacitor in series with a 20-KO resistance across a 10 V ac source. What size C is needed for equal voltage across R and Xc at frequency of 100 Hz and 100 KHz.Using the series circuit in Figure 3 consisting of a voltage source V, the resistor R and the fully uncharged capacitor C, how to find the value of the capacitance C considering as known data the time constant of the circuit T and the value of the resistor R? V ww R
- What is the equivalent resistance ?? and what is the total inductance ??An alternating voltage is applied to a series circuit consisting of a resistor and iron-cored inductor and a capacitor. The current in the circuit is 0.5 A and the voltages measured are 30 V across the resistor, 48 V across the inductor, 60 V across the resistor and inductor and 90 V across the capacitor. Find (a) the combined copper and iron losses in the inductor (b) the applied voltage.Show that the voltage division rule for two capacitors in series as in the figure