A 20 m chain was found to be 10 cm too long after chaining a distance of 2000 m. It was found to be 18 cm too long at the end of the day's work after chaining a total distance of 4000 m. What is the true distance if the chain was correct before the commencement of the day's work? (a) 3962 m (b) 4019 m (c) 3981 m (d) 4038 m

A 20 m chain was found to be 10 cm too long after chaining a distance of 2000 m. It was found to be 18 cm too long at the end of the day's work after chaining a total distance of 4000 m. What is the true distance if the chain was correct before the commencement of the day's work? (a) 3962 m (b) 4019 m (c) 3981 m (d) 4038 m

Engineering Fundamentals: An Introduction to Engineering (MindTap Course List)

5th Edition

ISBN:9781305084766

Author:Saeed Moaveni

Publisher:Saeed Moaveni

Chapter7: Length And Length-related Variables In Engineering

Section: Chapter Questions

Problem 42P

See similar textbooks

Similar questions

The length of a line measured on a slope of 15° was recorded as 550 m. But it was found that the 20 m chain was 0.05 m too long. Calculate the true horizontal distance of the line.
A 100 m tape weighing 3 kg was standardized and found to be 0.02 m short at temperature of 10degC and a 30 N pull when supported throughout. The 1324.55 – meter distance measured is an inclined distance whose difference in elevation between the points is 2 m. What is the correct distance? a. 1 324.28 m b. 1 234.18m c. 1 345.83 m d. 1 432.11 m
A built-up beam made from fastening two channels to a wide flange section carries loads as shown. The fasteners are 12mmØ bolts with allowable shear stresst = 110 MPa. For bearing 0h= 220 MPa for single shear, and op= 275 MPa for double shear. E= 200 GPa. F= 420 MPa a. Determine the maximum bending stress on the section b. Determine the maximum shearing stress at Neutral Axis.
solve very fast in 15 min and I need a clear answer | dybala
3.2. The length of a survey line was measured with a 20 m chain and was found to be equal to 1200 metres. As a check, the length was again measured with a 25 m chain and was found to be 1212 m. On comparing the 20 m chain with the test gauge, it was found to be 1 decimetre too long. Find the actual length of the 25 Im chain used.
Please help me ASAP. Please put the answer on the paper. Complete solution. I need the answer after 40 minutes. Rate will be given accordingly. Thank you in advance. In 1984, the compass reading of the azimuth of a line from north was 141°33’40’’. The magneticdeclination at that time is 2°21’ E. It was found out that the secular variation per year is 5’ E. Determinethe magnetic bearing in 1995.
18. The length of a survey line was measured with a 20 m chain and was found to be equal to 1200 m. If the length again measured with 25 m chain it is 1212 m. On comparing the 20 m chain with the test gauge, it was found to be 1 decimeter too long. Find the actual length of 25 m chain used.
[Exercise 1] Measure the height difference between points A and B with a level instrument. It is known that the elevation of point A H, is 12.658m, the center cross reading of A ruler is 1526mm (a= 1526mm), and the center cross reading of B ruler is 1182mm (b). What is the height difference hAB between the A and B points? What is the elevation of point B H₂?
100 and C = 2) A transit with a stadia interval factor of K = at point C on the line between points A and B,and the following stadia readings were observed: 0.381 was set Vertical Hair Readings(m) Position of Rod angle() -7.14 Middle Upper 1.540 1.960 Lower Rod held at A Rod held at B 1.395 1.250 12.28 1.800 1.640 Determine the following: a) length of line AB b)difference in elevation between points A and B
Structure 2: 300 N 4 m 4 m C 45° 45° Structure 3: TION
11. A 30 m metric chain is found to be 10 cm too short throughout a measurement. If the distance measured is recorded as 300 m, what is the actual distance? (a) 300.1 m (c) 299.0 m (b) 301.0 m (d) 310.0 m
Compute levels of the points below. f:=± 40mm STADIA READINGS POINT DISTANCE ΔΗ H b f A 3,706 122,000 m 18,22 m 11 3,243 15,77 12 2,560 15,19 TP1 0,555 0,299 19,23 21 1,274 13,38 22 1,958 14,27 23 2,878 12,93 24 3,089 10,88 B 3,604 122,325 m