8. A wind turbine receives air at 50kph and receives energy from it then the flowmeter behind it reads 10kph. Assuming no change in internal energy of the air, find the specific work in J/kg that the turbine will receive assuming no losses in friction.

8. A wind turbine receives air at 50kph and receives energy from it then the flowmeter behind it reads 10kph. Assuming no change in internal energy of the air, find the specific work in J/kg that the turbine will receive assuming no losses in friction.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: A centrifugal air compressor handles 200 cfm from 12 psia to 90 psia. The initial specific volume is…

A: a. Flow energy:

Q: Example: A 100MW hydro-electric station is supplying full load for 10 hours in a day. Calculate the…

A: Hydroelectric Power is given by, P=ηρQgh where, η=efficiency ρ=density of water Q=volume of water in…

Q: If number of vanes on turbine is more than required, it will the work produced by the turbine. O…

A: 1.If number of vanes on turbine is morethan required, it will ..................... the work…

Q: AT. 2] a water pump is to be used in a water supply system as shown in the figure. The pressure at…

A: Given:- Diameter of pipe=60mm=0.060m Velocity in the pipe, v=2 m/s Pressure in the pipe at 1, P1=70…

Q: An air compressor takes in 12m3 /min of air (measured at atmospheric conditions of 101.3 kPa, 15o c)…

A: Given data An air compressor takes in 12m3 /min of air (measured at atmospheric conditions of 101.3…

Q: Problem 2. A garden hose with an attached nozzle is used to fill a container with water. The nozzle…

Q: 1. A jet of water strikes on series of cup shaped vanes which deflects it through 165 degrees If the…

Q: The peripheral speed of the rotor of impulse turbine is (300m/S) and the absolute velocity of air at…

A: For solution refer below images.

Q: Find the flow rate of water through the system shown for the turbine to produce 20kW. Neglect…

A: the power rate of the turbine is P=ρQgHQ=PρgH=200001000×9.81×30=0.068 m3/sec

Q: 6. A pump is delivering water from the surface of a lake to a tank 20m above at a rate of 70L/s…

Q: A Wind turbine has a rotor diameter of 33m. At wind speed of a 13m/s what is the power [MW] in the…

A: Given, The diameter of the rotor, d = 33 m The radius of the rotor, r = 16.5 m Speed of wind, V =13…

Q: How much flow energy in kW required to move 3000liters/min. of water inside the pipe against a…

Q: ро 3. VB Pumpe -Vinn We have a boat wit a constant speed V_B and a constant volumetric flow rate Q…

A: Given: The flow rate, Q = 20 l/s The density of water, ρ = 1000 kg/m^3 The gravitational…

Q: An irrigation line carries water from a lake down into an arid valley 810 ft below the surface of…

Q: While the pressure remains constant and 85 psig, the volume of air changes from 20 t3. Find the…

Q: If a pump discharges 75 gallons per minute(gpm) of water whose specific weight is 61.5 lb/ft^3(g =…

A: Given data: The rate of discharge of the pump is V=75 gpm. The specific weight of the water is…

Q: H.W 1 body (mass 800 g) changes velocity from 25 m/scc to 40 m/sec, find the kinetic energy?

A: Vector is a physical quantity that has magnitude and direction both. Scalar is a physical quantity…

Q: A 4in3 hydraulic motor has a mechanical efficiency of .91 and a volumetric efficiency of .83. It…

A: Given: The volume of the hydraulic motor, V = 4 in^3 The mechanical efficiency of the motor, ηm =…

Q: the blades due to friction. Taking the blade angles at the inlet and outlet to be equal, find the…

Q: A tidal power plant of single basin type, has a basin area of 25 x 10 to power 6 m2. The tide has a…

A: Given dataBasin area = 25 x 106 m2Tide maximum height = 10 mTurbine stops operation below a head of…

Q: A 15hp motor is used to drive an air compressor. The mechanical and compressor efficiency are 65% &…

A: Power inputShaft power=15 hp=11.2 kW T1=30oC=303 K P2P1=6 ηm=65% ηC=70%

Q: Water flows through a 75 mm diameter pipe at a velocity of 3 m/s. Find the mass flow rate in kg/s

Q: 3. A work done on the steady flow system is 30 kJ/kgm. Calculate the heat in HP if the mass flow…

A: Given:W=-30 KJ/Kgm=10 Kg/minu1=10 KJ/Kgu2=20 KJ/Kg

Q: The turbine depends mainly on the fluid kinetic energy to produce power

A: This question is based on the concept of turbine .

Q: A fan delivers 8.2 m3/s of air at static pressure 250 kPa when the speed of fan is 256 rpm and…

A: Q1 = 8.2 m3/s P1 = 250 kpa N1 = 256 rpm H1 = 34 kW N2 300 rpm

Q: A hydroelectric plant has a reservoir of area 2 sq. kilometres and of capacity 5 million cubic…

A: Given:-Efficiency of turbine=85%Efficiecny of generator=95%Load=15000 kWTime=4 hoursHead=50…

Q: Centrifugal pump impeller runs at 950 rpm. Its external and internal diameters are 500 mm and 250…

A: Given: The speed of impeller, N = 950 rpm The external diameter of impeller, D = 500 mm The internal…

Q: Find the flow rate of water through the system shown for the turbine to produce 20 kW. Neglect…

Q: A horizontal axis wind turbine is installed at a location having free wind velocity of 15 m/s. the…

A: Given data wind velocity = 15m/s. Diameter = 80 m. radius =40 m To find the rotational…

Q: What is the turbine output of 100m head and delivering 1 cu. m/ sec in a hydro electric power plant…

A: Given data:

Q: A wind turbine receives air at 50kph and receives energy from it then the flowmeter behind it reads…

A: Given Entry velocity, V1 = 50 kph = 13.9 m/s Exit velocity, V2 = 10 kph = 2.8 m/s Find…

Q: 1. A fluid is flowing in a 6in diameter pipe at a pressure of 4PSI with a velocity of 8ft/s. The…

Q: The discharge pressure of an air compressor is 5 times the suction pressure. If the volume flow at…

Q: A 15 HP motor is used to drive an air compressor. The compressor efficiency is 75% and the air is…

Q: Find the flow rate of water through the system shown for the turbine to produce 20 kW. Neglect…

Q: A wind turbine, of radius 1.5 m, on a wind farm. If the wind speed is 8.0 m/s find the input and…

A: Write the expression of the area of the turbine.

Q: on a smooth surfac kg and then they - The energy loss č

Q: QUESTION 7 A pump discharges water at 4 m³/s through a pipe. If the pressure difference between the…

Q: A Pelton wheel has diameter of 3m and develops 800KW when rotating at 200rpm. What is the average…

Q: A 150mm diameter jet of water is discharging from a nozzle into the air at velocity of 45m/s. Find…

Q: 3.4 Find the flow rate of water through the system shown for the turbine to produce 20 kW. Neglect…

Q: 4.7 Find the power required to pump water from one tank to another, as shown in Fig. 4.31. The…

Q: nozzle efficiency of a Pelton turbine is 90%. Find the velocity of water at the zle exit if the head…

Q: A pump lifts water at the rate of 6 m^3/s to a height of 120 m and the friction loss in the pipe is…

Q: 2. A hydroelectric plant has 20 MW generator with an efficiency of 96%. The generator is coupled to…

Q: 1. A centrifugal pump has external and internal diameters of 300 mm and 150 mm respectively. The…

Q: Q3: The Petroco Service Station has one pump for regular unleaded gas, which (with an attendant) can…

A: Given data as per question average arrival time=6hourλ=6Average service time…

Q: A hydraulic pump, the speed is 950r/min, the displacement V, = 168ML/r, the working pressure is…

Q: In a hydraulic pump, the theoretical flow rate delivered is 203 liters/min with its volumetric…

A: Pump: The mechanical device that moves the fluid from one place to another place by some mechanical…

Q: A pump has a displacement volume of 6in³ and delivers 29gpm at 1200rpm and 500psi. If the overall…

Concept explainers

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.

Question

8. A wind turbine receives air at 50kph and receives energy from it then the
flowmeter behind it reads 10kph. Assuming no change in internal energy of
the air, find the specific work in J/kg that the turbine will receive assuming
no losses in friction.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Find the flow rate of water through the system shown for the turbine to produce 20kW. Neglect friction in your calculations
Obtain the heat transfer to the engine Qh, the work done by the engine W, and the efficiency e.
6. A pump is delivering water from the surface of a lake to a tank 20m above at a rate of 70L/s while the pump label suggests it consumes 18kW of electric power. If all the loses and any changes of kinetic energy are negligible, a. What is the pump efficiency? b. What is the pressure rise of water in the pump?
Q4: Find the force when 60 kg of blood is given upward of about 0.1s, in a velocity nearly 1 m/s.
A petrol engine has mechanical efficiency 0.8 and lower calorific value of 44.2 MJ / kg. The engine bore 0.06 m and stroke of 0.08 m. The engine speed of 2000 rpm. The consumption of fuel about 8 liter / h and the brake weight is 200 N. Take the density of fuel as 750 kg / m3 and torque arm of 400 mm.Find the specific fuel consumption. *
1. A fuel pump is delivering 10 gallons per minute of oil with a specific gravity of 0.83. the total head is 9.15m. Find how much energy/power does the pump consumes in kJ per hour. 2. A pump driven by an electrical motor moves 25 gallons per minute of water from a reservoir A to B, lifting the water to a head of 245 ft. The efficiency of the pump is 65%. Neglecting velocity head, friction head and minor losses; What power input in horse power is required?
Problem 2. A garden hose with an attached nozzle is used to fill a container with water. The nozzle starts at a diameter of 2 cm and is then reduced to 0.8 cm at the exit. In 50 seconds, the nozzle and hose are able to fill the container with 10 gallons of water. Find the volumetric flow rate (m³/s), the mass flow rate (kg/s), and the average velocity (m/s) at the at the nozzle exit. Assume the density p of water is 1000 kg/m³.
help me pls
A fluid undergoes a non-flow frictionless process. Work is -156.2kJ. if V1=0.845m3 and the pressure varies as -730V + 700 kPa where volume is in m3. Find the final volume
A hydraulic pump delivers 12 litres per minute towards pressure of 270 bar.Find the following (a) Calculate the hydraulic power in kW (b) If the overall efficiency of the pump is given as 69% .Find the input of electric power needed to drive the pump in watts .
A fan delivers 8.2 m³ /s of air at static pressure 250 kPa when the speed of fan is 256 rpm and requires a power of 34 kW. If the fan speed is changed to 300 rpm, find the new air flow rate, static pressure and the power required.
Centrifugal pump impeller runs at 950 rpm. Its external and internal diameters are 500 mm and 250 mm. The vanes are set back at an angle of 35° to the outer rim. If the radial velocity of water through the impeller be maintained constant as 2 m/sec, find the angle of the vanes at inlet, the velocity and direction of water at outlet and the work done by the impeller per kg of water