5002 FIELD 11₂ 0,0352) ARMATURE 230V The armature current is Blank 1 A The armature voltage drop is Blank 2 V Round off using 2 decimal places.

Q: IA + 82 I3 아아가 12V find I, Iz, Is using Super positii Theorem on

A:

Q: In the normal operation of an induction motor, the rotor turns at less than synchronous speed in…

A: Induction Motor:- An induction motor, also known as an asynchronous motor, is an AC electric motor…

Q: Question- A series RLC circuit has a bandwidth of 300 rad/sec at a resonant frequency of 3000…

A: Given- Series RLC circuit- Bandwidth=300 rad/sec, Resonant frequency=3000 rad/sec, Voltage…

Q: A pn junction has a built-in potential of 0.8V. The depletion layer width at a reverse bias of 1.2V…

A: A p+n junction has  A built-in potential (VB) = 0.8 V Case (i):-  The depletion layer width (d1) = 2…

Q: The preferred method for applying the field excitation voltage uses a field relay which operates on…

A: Field Excitation Voltage:- The quantity of electric energy (D.C.) fed into the field winding of an…

Q: SINGLE-LOOP CIRCUIT Exercise 1: In the circuit of Figure 3, find the power absorbed by each of the…

A:

Q: 4. Find the phasors corresponding to the following v(t) a. b. 24 cos (4t -15%) i (t) = 8 cos (st+85°…

A:

Q: Plot the input/output characteristics of the circuits shown below using both ideal diode mode and…

A: Given For ideal diode , VD,on=0 V For constant voltage model ,VD,on=0.8 V R1=2 kΩ R2=5 kΩ VB= 1.8 V

Q: Example 37.6. A 3-phase, 16-pole alternator has a star-connected winding with 144 slots and 10…

A: As per the question, the given alternator is a three-phase with 16 poles.  The winding is conned in…

Q: 4. Find the phasors corresponding to the following v(t) = 24 cos (4t-15⁰) V a. b. i (t) = 8 cos (5t…

A: We need to find out phasor of given signal

Q: Draw circuits to calculate Vth and Rth for each problem shown below. You do not need to calculate…

A:

Q: 2. What are the similarities and differences between UJT and BJT?

A: The objective is to determine the similar and different characteristics of BJT.

Q: What is the efficiency of the boost converter shown below if R₂ = 6₂R = 100, and D = 0.65? Show the…

A: Given RL = 6 ohm R = 100 ohm D = 0.65 We need to find the efficiency of boost converter given.

Q: Question In a series RC circuit, the voltage across the capacitor and the resistor are 60 V and 80 V…

A:

Q: 4) What is the inverse Fourier transform of X(jw)depicted below? -12-10 -8 0 (a) X (jw) 10 12 (b)…

A: As per Bartleby guideline we need to answer the first question only. Kindly repost the rest…

Q: Find Vo a)-5 V b) 4 V c)-3 V d) 2 V e) none of these 6 V Vo 8 Ω • 10 Ω 3v V

A: Given, The circuit is,

Q: 1 1- Given T(s) = 1+ 10€ 5+16²2 5² Sketch the Bode Plot, both magnitude My endphase &

A:

Q: In the following circuit, R = 42, L = 10 mH, Vdc = 12 V, and Calculate the average power for each…

A: It is given that: R=4 ΩL=10 mHVdc=12 VVst=36+30cos4π60t+10cos8π60t

Q: source is (V-240v) calculate at a = = ² 6 a) V dc b) Vorms c) Pout

A: Given data The given question is an example of half wave-controlled rectifier with a Resistive load.…

Q: Three identical capacitors are connected in delta to a 415V, 50 Hz, 3-phase supply. If the line…

A: Voltage VL = 415V Frequency f = 50 Hz Line current IL = 15 A

Q: 13. Find circuit current in this schematic. R-30 kn E₁-10 V w XL-40 kn

A: The given circuit diagram is shown below,

Q: In the circuit shown, the three voltmeter readings are V₁ = 220V, V2 = 122V, V3 = 136V. Vi V₂ R₁ V3…

A: Given- Readings of the voltmeters- V1=220 V,V2=122 V,V3=136 V, To Find- The power factor value of…

Q: A 5 PC charge is uniformly distributed over conductive sphere of radius 13cm, the elf Time component…

A: Given data: Q=5 pCRadius, R=13 cm

Q: The dielectric strength of rubber is 40000 V/mm at frequency of 50 Hz. What is the thickness of…

A: Given, Dielectric strength of rubber = 40000 V/mm. Frequency = 50 Hz. Applied voltage = 33 kV.…

Q: Exercise 4. Find the Req for the circuit shown below. Reg a. b. 30 Ω Μ 10 Ω, 40 Ω Figure 19. 30 Ω Z…

A: Given:

Q: Q-A 220 V, 15 kW. 1000 rpm DC shunt motor with armature resistance of 0.250, has a rated line…

A: Given- A 220 V, 15 kW. 1000 rpm DC shunt motor- So, V=220 V, Po=15 kW, Speed N1=1000 rpm, Armature…

Q: Three resistors in parallel: RTotal 1 1 1 1 + + R₁ R2 R3 1) The circuit in figure (1) has, Vsupply…

A:

Q: A three-phase, 318.75 kVA, 2300 V alternator has an armature resistance of 0.35 ohms/phase and a…

A:

Q: 900-0 SI |1=2=h=х по лола ольпогое хош ауд почер таул 100-0 = z" h'x uї дела dul E-X₂hX+₁ = y shin

A: Given: R = 4xy3z-3R = 4xy3z3Error in x, y, z = 0.001x=y=z = 1 Prove: Show that Max. Relative error =…

Q: 3. Convert the following WYE-connected resistors, inductors, and capacitors to their equivalent…

A:

Q: A 50 kVA transformer has an efficiency of 98% at full load,0.8 p.f. and 97% at half full-load, 0.8…

A:

Q: constant-voltage model (VD,on= 0.8 V) to determine the current ID flowing through the

A: Given data, VG=5 VR1=1 kΩR2=2 kΩVD,on=0.8 V By using the constant voltage model, a diode circuit is…

Q: A 20 kVA, 220 V, wye-connected, 3-phase salient-pole generator supplied load at 0.707 pf lagging.…

A: Given here a 20 KVA , 220 V , Y-connected ,3-phase sailent-pole supplied load at 0.707 lagginf power…

Q: 1. Find the equivalent inductance. Leq 50m H ботн try A to ich@m- 10 MH 20mH 25mH 25mH

A: Given: A network with various inductance in series and parallel combinations. To find: Equivalent…

Q: Two resistors in parallel: RTotal: = Three resistors in parallel: RTotal RTotal 1 1 1 + R1 R2 = || 1…

A: Since you have posted the questions with multiple subpart so we are supposed to answer the 3…

Q: A piece of wire has a resistance of 100 ohms. It is cut into 10 equal pieces. These shorter pieces…

A: The amount of current flowing through each component in a series circuit is the same. Of contrast,…

Q: handwritten needed. A 25 kW, 240 V self excited dc shunt generator has a field circuit resistance…

A: The electromagnetic induction rules of Faraday provide the basis for how a DC generator functions.…

Q: ACTIVITY NUMBER 1-FINAL NUMBER2 Find the current in the 8 Ohms resistor using superposition theorem.…

A:

Q: 0,1.Vx -j3 12 j20 + Vx X y

A:

Q: . Find the equivalent capacitance. Ceq TOF tt LE to jefausto@ 15 F 12F1 25 F 18F 30F ان ہے

A:

Q: 6.8 The volume charge density in nC/m³ in all space is given by P(x, y, z) = sin 5x sin 8y sin 2z…

A: The charge density is the quantity of charges present at a specific place. Linear charge density is…

Q: A.1) Investigate the purpose of the oscilloscope trigger.  A.2) Investigate the characteristic of…

A: According to the question, we need to discuss (1) The purpose of the oscilloscope trigger. (2)…

Q: For the parallel circuit shown below, using KCL determine the source current Is E R₁ 8 mA 2 ΚΩ R₂ a…

A: Given circuit:

Q: Calculate the electric resistance in ohms for a copper wire has a length of (8 m) and a radius of…

A: Given data, Length of copper wire l=8 m. Radius r=2 mm = 2×10-3 m. Resistivity ρ=1.6×10-8 Ω-m.

Q: 4) What is the inverse Fourier transform of X(jw)depicted below? -12-10-8 0 X (jw) 10 12 W (b) X(jw)…

A:

Q: number 2 also please

A:

Q: . Find the equivalent inductance. 50m H m PAPUA my S 60mH Leq RSITY 10 MH horized tribution to jo…

A: We need to find equivalent inductance for given circuit

Q: (c) What is the period of the signal f(t) = cos (2 77 t - 7/8) - 7 3 -7 sin (t + π/6)? Hint: take…

A:

Q: 2) Determine if y(t) = cos(x(t)) is linear, time-invariant, and/or causal?

A: Given data: Yt=cos xt

Q: Given the potential function V= 6x - 5y. Find the E field

A: Given, V=6x-5y

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.