3- The student pushes horizontally on a 37 kg box with a force of 115 N. The coefficient friction between the box and the floor is 0.37. What is the frictional force on the crate from the floor? a- 115 b- 230 c- 110 d-121

3- The student pushes horizontally on a 37 kg box with a force of 115 N. The coefficient friction between the box and the floor is 0.37. What is the frictional force on the crate from the floor? a- 115 b- 230 c- 110 d-121

Name: 3- The student pushes horizontally on a 37 kg box with a force of 115
Uploaded: 2024-03-20T06:56:46.000Z
Channel: Bartleby
Description: 3- The student pushes horizontally on a 37 kg box with a force of 115 N.The coefficient friction between the box and the floor is 0.37. What is thefrictional force on the crate from the floor?a- 115 b- 230 c-110d-121

Physics for Scientists and Engineers, Technology Update (No access codes included)

9th Edition

ISBN:9781305116399

Author:Raymond A. Serway, John W. Jewett

Publisher:Raymond A. Serway, John W. Jewett

Chapter12: Static Equilibrium And Elasticity

Section: Chapter Questions

Problem 12.65CP: A uniform pole is propped between the floor and the ceiling of a room. The height of the room is...

See similar textbooks

Similar questions

A uniform pole is propped between the floor and the ceiling of a room. The height of the room is 7.80 ft, and the coefficient of static friction between the pole and the ceiling is 0.576. The coefficient of static friction between the pole and the floor is greater than that between the pole and the ceiling. What is the length of the longest pole that can be propped between the floor and the ceiling?
Consider a large truck carrying a heavy load, such as steel beams. A significant hazard for the driver is that the load may slide forward, crushing the cab, if the truck stops suddenly in an accident or even in braking. Assume, for example, a 10 000-kg load sits on the flatbed of a 20 000-kg truck moving at 12.0 m/s. Assume the load is not tied down to the truck and has a coefficient of static friction of 0.500 with the truck bed. (a) Calculate the minimum stopping distance for which the load will not slide forward relative to the truck. (b) Is any piece of data unnecessary for the solution?
If you press a book flat against a vertical wall with your hand, in what direction is the friction force exerted by the wall on the book? (a) downward (b) upward (c) out from the wall (d) into the wall.
Review. A rifle bullet with a mass of 12.0 g traveling toward the right at 260 m/s strikes a large hag of sand and penetrates it to a depth of 23.0 cm. Determine the magnitude and direction of the friction force (assumed constant) that acts on the bullet.
(a) What is the maximum frictional force in the knee joint of a person who supports 66.0 kg of her mass on that knee? (b) During strenuous exercise it is possible to exert forces to the joints that are easily ten times greater than the weight being supported. What is the maximum force of friction under such conditions? The frictional forces in joints are relatively small in all circumstances except when the joints deteriorate, such as from injury or arthritis. Increased frictional forces can cause further damage and pain.
(a) Calculate the tension in a vertical strand of spider web if a spider of mass 8.00105 kg hangs motionless on it. (b) Calculate the tension in a horizontal strand of spider web if the same spider sits motionless in the middle of it much like the tightrope walker in Figure 4.17. The strand sags at an angle of 12° below the horizontal. Compare this with the tension in the vertical strand (find their ratio).
To determine the coefficients of friction between rubber and various surfaces, a student uses a rubber eraser and an incline. In one experiment, the eraser begins to slip down the incline when the angle of inclination is 36.0 and then moves down the incline with constant speed when the angle is reduced to 30.0. From these data, determine the coefficients of static and kinetic friction for this experiment.
Consider a large truck carrying a heavy load, such as steel beams. A significant hazard for the driver is that the load may slide forward, crushing the cab, if the truck stops suddenly in an accident or even in braking. Assume, for example, that a 10 000-kg load sits on the flatbed of a 20 000-kg truck moving at 12.0 m/s. Assume that the load is not tied down to the truck, but has a coefficient of friction of 0.500 with the flatbed of the truck. (a) Calculate the minimum stopping distance for which the load will not slide forward relative to the truck. (b) Is any piece of data unnecessary for the solution?
This problem returns to the tightrope walker studied in Example 4.6, who created a tension of 3.94103 N in a wire making an angle 5.0° below the horizontal with each supporting pole. Calculate how much this tension stretches the steel wire if it was originally 15 m long and 0.50 cm in diameter.
A block of ice (m = 15.0 kg) with an attached rope is at rest on a frictionless surface. You pull the block with a horizontal force of 95.0 N for 1.54 s. a. Determine the magnitude of each force acting on the block of ice while you are pulling. b. With what speed is the ice moving after you are finished pulling? Repeat Problem 71, but this time you pull on the block at an angle of 20.0.
An automobile driver traveling down an 8% grade slams on his brakes and skids 30 m before hitting a parked car. A lawyer hires an expert who measures the coefficient of kinetic friction between the tires and road to be k = 0.45. Is the lawyer correct to accuse the driver of exceeding the 25-MPH speed limit? Explain.
A horizontal force of 95.0 N is applied to a 60.0.kg crate on a rough, level surface. If the crate accelerates at 1.20 m/s2, what is the magnitude of the force of kinetic friction acting on the crate? (See Section 4.5.)